Introduction: Measurements of polonium content in solids are usually performed by dissolving the material and preparing a thin sample which can be measured with one of the available instruments. A measurement of the radiation emerging from the thick sample should be sufficient to evaluate the polonium content. For this reason a calculation has been performed and the results have been compared with those obtained by the thin sample method. Obviously this proposed method using thick samples would be faster.

From introduction: "You will find enclosed the specifications for the freezing point method for determination of the amount of HF in UF₆. The specification for cleaning new shipping containers is also included."

The following report describes and foretells the situation in medium in which neutrons are being (a)produced as fast neutrons, (b) slowed down to thermal speeds by impacts with nuclei, and (c) absorbed by nuclei in such a manner that sometimes fresh fast neutrons appear at the place where a thermal neutron has just appeared.

A report which investigated vacuum distilation, entrainer gas distillation, and entrainer gas plus bromine vapor distillation.

Report discussing an experiment in which films of boron were deposited on glass and on metals by the thermal deposition of diborane at tempertatures between 500 and 600°C.

Abstract: "For defects between interior and coating, or between successive layers of coating, a simple, fairly accurate formula is established. The temperature rise at the edge of the defect is briefly discussed."

Abstract: "The behavior of radially split hollow cylinders upon heating is discussed."

The following report describes tests made for the purpose of determining the accuracy and permanency of various types of high resistance bleeders, and their resistance variation during use over a period of approximately six months.

Abstract: "Photographic plates have been used to measure the energy of neutrons from the fission of 25. The spectrum as inferred from the ranges of 850 protons recoiling in the forward direction shows a very wide maximum at ~1.5 Mev with an exponentially decreasing high energy tail which extends beyond 7 Mev. The minimum energy neutrons recorded were ~700 kv. If the spectrum is extrapolated to zero, one finds that this average neutron energy is about 1.85 Mev. The stopping power of the plates was calibrated by the use of monochromatic neutrons from the Li-7(pn) Be-7 reaction and the d-d reaction."

Report discussing a method of removing tuballoy (uranium) from metallic tantalum, which involves a double precipitation of tuballoy tetrafluoride obtained by reduction with stannous chloride.

The following report describes a modified Kraus type reactor that had been constructed for use in bets chemical conversion operations.

Technical report covering (1) analysis of uranium bromide and chloride samples, (2) the ferric-nitrate method of analyzing uranium fluorides for fluorine, (3) spectrographic determination of boron, cadmium and manganese in magnesium metal, (4) service analyses. contributions to other problems, (5) attempted preparation of uranous oxyfluoride, and (6) corrections in previous reports.

Technical report. Quite pure anhydrous ThCl4 in small quantity (8-10 g charge) has been prepared by the action of a mixture of Cl2 and CCl4 vapor on ThO2 at 675 degrees to 725 degrees C.

This technical report contains day by day experimental data reported in Engineer's Log Book, Electro-Chemistry Department, supporting Report No. EC-11 dated November 15, 1944, by W. L. Grube, Research Laboratories Division, General Motors Corporation.

From introductory paragraph: "In a slightly hypocritical water boiler the introduction of a single neutron may give rise to a fairly large burst of neutrons which dies out slowly. As was shown some time ago by Frankel and Nelson with the help of A. Horn the statistics of this multiplication process can be treated in a simple way for the hypothetical case that the number of neutrons produced per fission is two."

From abstract: "The report describes the complete structure of barium hydrogen phosphate, Ba HPO4, as determined by means of x-ray diffraction. The crystal is orthorhombic, with cell dimensions given by a=5.71 A b=7.05 A c=4.61 A. The calculated density is 4.15gm/cm[^]3 for two molecules in the unit cell. The space group is C[subscript]2v[superscript]7-pmn. The barium, phosphorus, and two sets of oxygen lie in the plane of symmetry. The third set of oxygens are in general positions. Parameters for these atoms have been found, and interatomic distances calculated. The positions of the hydrogens are indicated by the characteristics O-H-O distance (2.58A) between two oxygens."

From abstract: "Comparison of the activity produced by fast neutrons on lead with other activations corroborates the assignment of the 3.2 hr. activity as Pb209, and the assignment of the reaction as capture of fast neutrons. Two different measurements show that the neutrons captured have energies greater than 100 KEV. This average capture cross section for primary neutrons from 7.5 MEV deuterons on a thick target of beryllium is measured as 10[^]-27 ca[^]2."

Abstract: The counting accuracy of the Chicago Scalers, Models 961A and 961B, is a function of the bias setting of the limiter (V2). this report gives quantitative data supporting this thesis. A method of making bias settings is suggested. These tests were run at the suggestion of Mr. V. C. Hanson.

Technical report describing development of the Clinton alpha amplifier. The circuit for the Clinton alpha amplifier which is used with an Offner scaler is shown attached to the report. It consists of a pre-amplifier mounted in a cylindrical alpha chamber, followed by a three state amplifier and a pulse height selector in a separate cabinet. Pulses are fed from the pulse height selector in the amplifier to the input tube of the Offner scaler. Through the third stage of the amplifier, this circuit is exactly the same as the California circuit now used by the chemical section for alpha counting. A type 961 Offner scaler was used for these tests. None of the latest Offner scalers type961A, were available to us when the tests were made. Method of testing is given, results are tabulated, computations are made, and eight graphs are given. it appears that the Clinton amplifiers used with a Offner scaler will give substantially the same performance as that given by the California circuit.

Technical report which includes a description of scaling action in a Higinbotham circuit, of operation of the output circuit, of operation of the regulated high voltage supply. Acceptance and performance specifications are given. also included are cuts showing the bottom and top view of a scaler of this type. The scaling circuit diagram and major parts list is attached. To facilitate testing, the circuit of a satisfactory pulse generator is included together with a cathode - follower.

From introduction: "The measurement of the thermal conductivity of liquid TF6 presented unusual difficulties because of two of its properties which necessitated working with a closed system. The properties were (1) the liquid can exist as such only above 64.05°C. at which temperature its saturated vapor pressure is 1140 mm. of mercury, and (2) the compound reacts rapidly with moist air. Also because of the liquid's extremely corrosive nature, it was necessary to design a cell of special corrosion resistant materials."

Technical report with short reports on (1) Effect of radiation on organic compounds; (2) Effect of radiation on separation processes; (3) Effect of radiation on water and aqueous systems; and (4) Effect of neutrons on graphite.

Report concerning the behavior of atoms dislodged from their positions in solid constituents by neutrons during the transition from high energy to thermal energy.

Technical report summarizing our knowledge of the chemical effects of ionizing radiation upon water and upon aqueous solutions of inorganic compounds. The types of radiation considered are beta rays, gamma and X rays, and heavy particles, notably neutrons, deuterons, alpha rays and fission recoils.