From Summary: "Two topics of interest to persons attempting to apply the heat method of preventing ice formation on aircraft are considered. Surfaces moving through air at high speed are shown, both theoretically and experimentally, to be subject to important aerodynamic heating effects that will materially reduce the heat required to prevent ice. Numerical calculations of the path of water drops in an air stream around a circular cylinder are given. From these calculations, information is obtained on the percentage of the swept area cleared of drops."

"An investigation has been made to determine efficient arrangements for an internal-flow system of an aircraft when such a system operates by itself or in combination with other flow systems. The investigation included a theoretical treatment of a problem and tests in the NACA 5-foot vertical wind tunnel of inlet and outlet openings in a flat plate and in a wing. When an internal-flow system tends to decrease the final velocity of it's wake, the results showed that it should be arranged in series with the propulsive system; the inlet opening should be located at a forward stagnation point; and the outlet opening should be so shaped and located as to recover the kinetic energy of the jet without increasing the drag of other portions of the aircraft" (p. 1).

"A mathematical analysis has been made to show the method of obtaining the dimensions of the intercooler that will use the least total power for a given set of design conditions. The results of this analysis have been used in a sample calculation and, on the basis of this calculation, a new inter cooler arrangement is suggested. Because the length of the two air passages of the new arrangement is short in comparison with the third dimension, the height of the intercooler, this intercooler arrangement has unusual dimensions" (p. 1).

"A compilation of the experimentally determined moments of inertia of 32 airplanes is presented. The measurements were obtained at the laboratories of the NACA by means of a pendulum method. The airplanes tested are representative of several types of aircraft of gross weight less than 10,000 pounds. The results are presented in coefficient as well as in dimensional form. An elementary analysis of the data disclosed the possibility of grouping the results according to wing type of the airplane, as low-wing monoplanes, parasol and high-wing monoplanes, and biplanes" (p. 1).

From Summary: "A discussion is given of the important aspects of the stalling of vertical tail surfaces. The type of instability encountered is described and the possibilities of inadvertent occurrence are noted. The influence of directional flight tests on the behavior of a airplane when the tail stall takes place is discussed. In this connection, flight tests of a twin-engine airplane in which the vertical fin area was increased are cited."