Report presenting an investigation of a long column continuous over three supports to determine its critical load when the center support was given varying amounts of initial displacement. During each test, the middle support was hinged so as to be free to move parallel to the column axis during buckling. The critical loads predicted from load-deflection readings were different for the upper and lower spans.

"Flight tests were conducted on the XP-41 airplane, equipped with a Pratt & Whitney R1830-19, 14-cylinder, air-cooled engine, to determine the increase in flight speed obtainable by the use of individual exhaust stacks directly rearwardly to obtain exhaust-gas thrust. Speed increases up to 13 miles per hour at 20,000 feet altitude were obtained using stacks having an exit area of 3.42 square inches for each cylinder. A slight increase in engine power and decrease in cylinder temperature at a given manifold pressure were obtained with the individual stacks as compared with a collector-ring installation" (p. 1).

Report presenting testing of a steel cylinder barrel with aluminum fins of the optimum spacing of 0.090 inch. The primary purpose is to determine the excellence of the thermal bonds between the aluminum fins and the aluminum base and between the aluminum base and the steel and to compare the heat transfer of the barrel with that of barrels with a fin space of 0.052 inch.

Report presenting an investigation in the 7- by 10-foot wind tunnel of an NACA 23012 airfoil with a 15-percent-chord and a 25-percent-chord balanced split flap of Clark Y profile. The primary purpose was to determine the aerodynamic section characteristics of the airfoil as affected by the size, nose location, and deflection of the flap.

Report presenting testing in the 8-foot high-speed wind tunnel to determine the effect on external drag and pressure distribution of air inlet openings on the stagnation point of a streamline body. The results showed that external drag of the body with suitably designed nose-inlet and tail-outlet openings over a wide range of rates of internal air flow was no higher than the drag of the streamline body. Specific results for the streamline body, nose-inlet openings, outlet openings, and inlet-outlet combinations are provided.