"The present report deals with a comparison of mathematically and experimentally defined buckling loads of a spar-rib grill, on the assumption of constant spar section, and infinitely closely spaced ribs with rigidity symmetrical to the grill center. The loads are applied as equal bending moments at both spar ends, as compression in the line connecting the joints, and in the spar center line as the assumedly uniformly distributed spar weight" (p. 1).

The limits of the single-stage compression in superchargers at the present state of development are determined by five factors. 1) by the rotor material; 2) by the formation of the flow; 3) by the manufacture of double shrouded rotors; 4) by the bearing problem; 5) by the drive method.

"With the further development of the supercharger, requirements with regard to measuring accuracy increase while at the same time the conditions under which the measurements must be carried out become more difficult. The present paper is a contribution toward the improvement and refinement of the measuring methods. For pressure measurements some suggestions are made with regard to design and location of the measuring stations" (p. 1).

The following standards give the standardized forms for two throttling devices, standard nozzles and standard orifices, and enable them to be used in circular pipes without calibration. The definition of the standards are applicable in principle to the calibration and use of nonstandardized throttling devices, such as the venturi tube. The standards are valid, likewise, as a basis for discharge measurements in the German acceptance standards.

"The present report deals with the variation of a turbulent velocity profile in flow from rough to smooth wall and vice versa. Expressions obtained for the shear-stress distribution with respect to the distance from the point of junction of the different roughnesses and from the wall distance, are utilized to ascertain the developing velocity distributions. Under simplified assumptions, the use of these formulas renders possible the integration of the motion equations for the shear stress. This calculation is carried out and compared with the experiments" (p. 1).