Report discussing the use of magnetic fields and wire to navigate aircraft in conditions of poor visibility is presented. This field may be considered to be derived from a double lemniscate, considered in the particular case where the origin is a double point formed from the magnetic field of the slack wire, from the field produced by the return currents and from the field due to the currents induced in the conducting mass. These fields are dephased in two ways, one in the direction of the wire, the other in a direction perpendicular to it.

This report is section VIII of a series of reports on aeronautic instruments. The preceding reports in this series have discussed in detail the various types of aeronautic instruments which have reached a state of practical development such that they have already found extensive use. It is the purpose of this paper to discuss briefly some of the more recent developments in the field of aeronautic instrument design and to suggest some of the outstanding problems awaiting solution.

From Introduction: "To furnish data for the design of the fleet airship Shenandoah, a model was made and tested in the 8 by 8 foot wind tunnel for wind forces, moments, and damping, under conditions described in this report. The results are given for air of standard density. P=0.00237 slugs per cubic foot with vl/v correction, and with but a brief discussion of the aerodynamic design features of the airship."

This report contains an account of the origin of the views and fundamental principles underlying the construction of German airplanes during the war. The report contains a detailed discussion of the aerodynamic principles and their use in determining the strength of airplanes, the analysis of the strength qualities of materials and in the construction, the calculated strength of air flows and a description of tests made in determining the strength of airplanes.

The author expresses his views that engine performance would be affected only at very low temperatures is presented in this report.

In order to determine an approximate formula giving the weight of a dead load as a function of the volume (V) of the envelope and of the maximum velocity (v), we will take the relative weight of the various parts of the airship (P(sub v), M, V, A, T(sup 34)), adopting a mean value of the coefficients determined. This formula may be adopted both for semi-rigid airships with suspended nacelle and non-rigid envelope, with or without internal suspensions. It may also be adapted to airships with rigid longitudinal beam, with power units on external supports or in nacelles, and with non-rigid envelopes, with or without internal bracing cables.

On of the most important characteristics of an airfoil is the rate of change of lift with angle of attack, (sup dC)L/d alpha. This factor determines the effectiveness of a tail plane in securing static longitudinal stability. The application of the Gottingen formulas given here for calculating the variation of (sup Dc)L/d alpha with aspect ratio should be of interest to many aeronautical engineers. For the convenience of the engineer, a set of curves calculated by the method set forth here are given in graphical form. Also, the observed values of (sup dC)L/d alpha for the same airfoil at various aspect ratios follow the calculated curves closely.

This report presents the results of testing on a glider designed and built by the College Aviation Group. The design and construction were based on the following principles: 1) the glider will be made to descend as slowly as possible; 2) rigidity and resistance were arranged to meet the conditions of varied loads; 3) construction is as simple as possible; 4) and great ease in assembling and dismounting have been sought.

This report is broken up into two sections: one about the regulators for speed of wind tunnel drive motor and one about a vernier manometer with adjustable sensitivity.

Here, it is shown that the construction of an airplane model can and should be simplified in order to obtain the most reliable test data. General requirements for model construction are given, keeping in mind that the general purpose of wind tunnel tests on a model airplane is to obtain the aerodynamic characteristics, the static balance, and the efficiency of controls for the particular combination of wings, tail surfaces, fuselage, and landing gear employed in the design. These parts must be exact scale reproductions. Any appreciable variation from scale reproduction must be in the remaining parts of the model, i.e., struts, wires, fittings, control horns, radiators, engines, and the various attachments found exposed to the wind in special airplanes. Interplane bracing is discussed in some detail.

"This report deals with the results of a test made upon a B. M. W. Engine in the altitude chamber of the Bureau of Standards, where controlled conditions of temperature and pressure can be made to simulate those of the desired altitude. A remarkably low value of fuel consumption - 041 per B. H. P. hour - is obtained at 1,200 revolutions per minute at an air density of 0.064 pound per cubic foot and a brake thermal efficiency of 33 per cent and an indicated efficiency of 37 per cent at the above speed and density. In spite of the fact that the carburetor adjustment does not permit the air-fuel ratio of maximum economy to be obtained at air densities lower than 0.064, the economy is superior to most engines tested thus far, even at a density lower than 0.064, the economies superior to most engines tested thus far, even at a density (0.03) corresponding to an altitude of 25,000 feet" (p. 1).

"This report is a description of a new method of testing aerofoils in free flight devised by the National Advisory Committee for Aeronautics. The method consists in lowering below a flying airplane a large inverted aerofoil on three small steel wires in such a way that the lift on the aerofoil always keeps the wires tight. The resultant force is measured by the tension in the wires, and the direction of the resultant by the amount the wing trails backwards" (p. 1).

In summing up it may be said that the hydrodynamic theories are best confirmed by experimental results for bodies with small resistance or drag and can accordingly be used in place of experimental tests.

Different causes of airplane engine vibration are given as well as devices to measure vibration.

Report discussing the origin of air traffic dates from the war. The important development of aeronautic industries and the progress made in recent years, under the impelling force of circumstances, rendered it possible, after the close of hostilities, to consider the practical utilization of this new means of economic expansion.

Report presenting a description of the aerodynamics laboratory of the Vienna Technical High School. The main focus of this report is detailing some of the accomplishments that the laboratory has made.

From Introduction: "A model of the F-5-L seaplane was made, verified, and tested at 40 miles an hour in the 8' x 8' tunnel for lift and drag, also for pitching, yawing and rolling moments. Subsequently, the yawing moment test was repeated with a modified fin. The results are reported without VL scale correction."

The observation that airplane fabrics, after long use, lose their original strength, caused the German Experimental Institute for Aviation to carry out a series of experiments on the effect of weathering on the cloth covering of airplane wings and fuselages.

If, by some means, a steady state of motion of a perfect fluid were established in an ideal wind tunnel, there would be no losses, and the motion would persist indefinitely. In the actual tunnel, the function of the motor-fan group is overcome by the total loss of head in the tube due to friction and eddies.

Although it is well known that the strength of wood depends greatly upon the time the wood is under the load, little consideration has been given to this fact in testing materials for airplanes. Here, results are given of impact tests on clear, straight grained spruce. Transverse tests were conducted for comparison. Both Izod and Charpy impact tests were conducted. Results are given primarily in tabular and graphical form.

If it is desired to record the pressure difference given a gauge, the manometer must answer the following conditions: 1) It must respond quickly so that all speed variations will be correctly recorded; 2) It must not be affected by rectilinear or curvelinear accelerations. Hence, movable parts must be counterbalanced. An instrument which met these criteria is discussed as well as details of construction.

Necessity of adopting for all aviation fields, civil or military, a single system of markers for giving the direction for starting and landing (with an automatic indicator of the direction of the wind) and of indicating the good part of the field.

"In naval architecture, it is customary to determine the wetted surface of a ship by means of some formula which involves the principal dimensions of the design and suitable constants. These formulas of naval architecture may be extended and applied to the calculation of the surface area of airship envelopes by the use of new values of the constants determined for this purpose. Surface area coefficients were calculated from the actual dimensions, surfaces, and volumes of 52 streamline bodies, which form a series covering the entire range of shapes used in the present aeronautical practice" (p. 1).

Given here is a brief review of the fundamental principles of the propeller slip-stream theory and its further development through later researches, which demonstrate the connection between the propeller slip-stream theory and Frounde's so-called 'propeller blade theory.' The propeller slip-stream theory, especially in its improved form, now gives us the basis for determining the mutual influence of the parts of the blade, so that, in calculating the shape of the blade, we can get along with certain section characteristics, which have been determined once and for all. It is argued that new theories present the possibility of investigating the phenomena in the vicinity of the propeller, allowing us to calculate its action on the basis of fewer experimental values.