Electric power generation by conventional Rankine cycle heat engines with heat supplied by line-focus solar collectors was investigated. The objectives of the study were: (1) determine which of four types of line-focus solar collectors coupled with turbine-generators of conventional design has the potential to produce low-cost electric power with thermal energy in 100 to 300/sup 0/C range; (2) develop performance and cost relationships for organic Rankine cycle engines for power generation capacities from 3 MW/sub e/ to 300 MW/sub e/; (3) develop conceptual storage units for organic fluid systems. Evaluation procedures and study results and conclusion are presented and discussed in detail. (WHK)

From abstract: Five mines in north-central Clear Creek County- Golden Calf, Gomer, Martha E., Golden Glen, and Diamond Mountain--have high anomalous radioactivity and are considered potential sources of uranium.

From introduction: The reconnaissance was made during the summer of 1951 by two field parties: (1) a reconnaissance in parts of Oklahoma, Texas, New Mexico, and Arizona by Russell Gibson, and (2) Geological Survey reconnaissance in parts of New Mexico,.Colorado, Utah, Idaho, and Wyoming (by the writers), the results of which are summarized in this report.

From abstract: Six diamond-core holes totaling 2, 201 feet were drilled by the U. S. Bureau of Mines under contract to the U. S. Atomic Energy Commission at the Old Leyden coal mine, Jefferson County, Colo. The holes were spotted on the basis of geologic mapping by the U. S. Geological survey and were drilled to explore the lateral and downward extent of a uranium-bearing coal and the associated carnotite deposits in the adjacent sandstone. The data obtained from the diamond-core holes helped to explain the geology and structural control of the deposit. The uranium is most abundant in a coal bed that in places has been brecciated by shearing, and then altered to a hard, dense, and silicified rock. The uraniferous coal is in the nearly vertical beds of the Laramie formation of Upper Cretaceous age,

Objective is to demonstrate the effectiveness of a catalytic membrane reactor (ceramic membrane combined with catalyst) to selectively produce methanol by partial oxidation of methane. None of the membranes tested in a high pressure system could selectively remove methanol, until a cooling tube was inserted inside the membrane reactor to quench the product stream; this effectively increased methanol selectivity 2[times] during methane oxidation. For both conditions, combined selectivity for methanol and CO is constant, 85%. The remaining product is CO[sub 2]. The membranes were broken when removed from the system; this was remedied when a cooling tube with a smaller diameter was used.

Surface and subsurface soil cleanup protocols for the Gunnison, Colorado, processing site are summarized as follows: In accordance with EPA-promulgated land cleanup standards, in situ Ra-226 is to be cleaned up based on bulk concentrations not exceeding 5 and 15 pCi/g in 15-cm surface and subsurface depth increments, averaged over 100m{sup 2} grid blocks, where the parent Ra-226 concentrations are greater than, or in secular equilibrium with, the Th-230 parent. In locations where Th-230 has differentially migrated in subsoil relative to Ra-226, a Th-230 clean up protocol has been developed. The cleanup of other radionuclides or nonradiological hazards that pose a significant threat to the public and the environment will be determined and implemented in accordance with pathway analysis to assess impacts and the implications of ALARA specified in 40 CFR Part 192 relative to supplemental standards.

The U.S. Department of Energy (DOE) has prepared an environmental assessment (EA) (DOE/EA-0347) on the proposed surface remediation of the Maybell uranium mill processing site in Moffat County, Colorado. The mill site contains radioactively contaminated materials from processing uranium ore that would be stabilized in place at the existing tailings pile location. Based on the analysis in the EA, DOE has determined that the proposed action does not constitute a major federal action significantly affecting the quality of the human environment within the meaning of the National Environmental Policy Act (NEPA) of 1969, Public Law 91-190 (42 U.S.C. {section}4321 et seq.), as amended. Therefore, preparation of an environmental impact statement is not required and DOE is issuing this Finding of No Significant Impact (FONSI).

The objective of this work is to investigate, in the laboratory, the parameters associated with a chemically assisted in situ recovery procedure, using hydrogen chloride (HCI), carbon dioxide (CO{sub 2}), and steam (H{sub 2}O), to obtain-data useful to develop a process more economic than existing processes and to report all findings. The technical progress of the project is reported. The progress of the project is that experiment preparations are underway. Reactor design, process design, and experiment design have been completed. The laboratory to be used has required extensive clean-up, and is nearly ready. Safety considerations are underway. Finally, an initial literature search has revealed some important aspects that need to be considered.

The purpose of the research project was to investigate the feasibility of the chemically assisted in situ retort method for recovering shale oil from Colorado oil shale. The chemically assisted in situ procedure uses hydrogen chloride (HCl), steam (H{sub 2}O), and carbon dioxide (CO{sub 2}) at moderate pressure to recovery shale oil from Colorado oil shale at temperatures substantially lower than those required for the thermal decomposition of kerogen. The process had been previously examined under static, reaction-equilibrium conditions, and had been shown to achieve significant shale oil recoveries from powdered oil shale. The purpose of this research project was to determine if these results were applicable to a dynamic experiment, and achieve penetration into and recovery of shale oil from solid oil shale. Much was learned about how to perform these experiments. Corrosion, chemical stability, and temperature stability problems were discovered and overcome. Engineering and design problems were discovered and overcome. High recovery (90% of estimated Fischer Assay) was observed in one experiment. Significant recovery (30% of estimated Fischer Assay) was also observed in another experiment. Minor amounts of freed organics were observed in two more experiments. Penetration and breakthrough of solid cores was observed in six experiments.

Objective is to demonstrate the effectiveness of a catalytic membrane reactor (ceramic membrane combined with catalyst) to selectively produce methanol by partial oxidation of methane. None of the membranes tested in a high pressure system could selectively remove methanol, until a cooling tube was inserted inside the membrane reactor to quench the product stream; this effectively increased methanol selectivity 2{times} during methane oxidation. For both conditions, combined selectivity for methanol and CO is constant, 85%. The remaining product is CO{sub 2}. The membranes were broken when removed from the system; this was remedied when a cooling tube with a smaller diameter was used.

The objective of this work is to investigate, in the laboratory, the parameters associated with a chemically assisted in situ recovery procedure, using hydrogen chloride (HCI), carbon dioxide (CO{sub 2}), and steam (H{sub 2}O), to obtain data useful to develop a process more economic than existing processes and to report all findings. The technical progress of the project is reported. The project status is that the solutions to the problems discussed in the third quarter status, were found to function satisfactorily. Future needs have been considered, and appropriate equipment and instrumentation changes have been designed. Only one experiment was performed this quarter, with some improvement over the previous experiments. The increase in shale oil recovery followed directly from the changes discussed last quarter, but the improvement could have been larger with wider-spread implementation of the changes. Equipment was purchased to rectify the need, and will be installed shortly. Further, a minor change in the design was necessary to account for the brittleness of high temperature electrical resistance heating tapes. The focus of the work this quarter has been on the development of computer software to enable the use of on-line parameter identification, the design of the instrumentation necessary to adequately …

Abstract: The Treasure Hill area consists of eight mining-lode claims in secs. 10 and 15, T. 9 N., R. 70 W., Larimer County, Colo. All of the workings were examined and samples were taken from most of them. The results of the examination indicate that there is little or no detectable radioactivity in the schist and granite of the area.

From introduction: The primary objective of these studies is to determine the content and distribution of uranium areally and stratigraphically in the Sharon Springs member of the Pierre shale of Late Cretaceous age.

This is a geological map of the uranium region of the Colorado Plateau.

Report discussing a geological study of the Union Pacific prospect near the Golden Canyon in Jefferson County, Colorado.

Report discussing the geology of the Copper King mine area, which was worked for uranium following the discovery of pitchblende. The geology of the site is described as well as the history of the area's production.

Report summarizing the results of geological exploration of the Spring Creek Mesa area from July 11, 1951 to August 14, 1953. A brief description of the geology and ore deposits of the area is also given.

A report about a reconnaissance of the Sharon Springs member of the Pierre shale in western Kansas and eastern Colorado was conducted during 1954.

The SLD upgrade CCD vertex detector (VXD3) is described. Its 307 million pixels are assembled from 96 3.2 Mpixel CCDs of 13 cm{sup 2} each. The system has evolved from the pioneering CCD vertex detector VXD2, which has operated in SLD since 1992. The CCDs of VXD3 are mounted on beryllium ladders in three cylinders, providing three space point measurements along each track of about 5 microns resolution in all three co-ordinates. Significant improvements are achieved with VXD3 in impact parameter resolution (about a factor of two) and acceptance ({approximately}20%) through optimized geometry and reduced material. New readout electronics have been developed for this system.

The Colorado economic impact study summarizes employment and economic benefits to the state from activities associated with the Uranium Mill Tailings Remedial Action (UMTRA) Project during Colorado state fiscal year 1994 (1 July 1993 through 30 June 1994). To capture employment information, a questionnaire was distributed to subcontractor employees at the active UMTRA Project sites of Grand Junction, Naturita, Gunnison, and Rifle, Colorado. Economic data were requested from each site prime subcontractor, as well as from the Remedial Action Contractor. Information on wages, taxes, and subcontract expenditures in combination with estimates and economic multipliers is used to estimate the dollar economic benefits to Colorado during the state fiscal year. Finally, the fiscal year 1994 estimates are compared to fiscal year 1993 employment and economic information.

At two uranium mill sites in Rifle, Colorado, the US Department of Energy (DOE) Uranium Mill Tailings Remedial Action (UMTRA) Project is removing uranium mill tailings and contaminated subgrade soils. This remediation activity will result in the production of groundwater contaminated with uranium, heavy metals, ammonia, sulfates, and total dissolved solids (TDS). The initial remediation plan called for a wastewater treatment plant for removal of the uranium, heavy metals, and ammonia, with disposal of the treated water, which still includes the sulfates and TDSS, to the Colorado River. The National Pollutant Discharge Elimination (NPDES) permit issued by the Colorado Department of Health for the two Rifle sites contained more restrictive discharge limits than originally anticipated. During the detailed review of alternate treatment systems to meet these more restrictive limits, the proposed construction procedures were reviewed emphasizing the methods to minimize groundwater production to reduce the size of the water treatment facility, or to eliminate it entirely. It was determined that with changes to the excavation procedures and use of the contaminated groundwater for use in dust suppression at the disposal site, discharge to the river could be eliminated completely.

The Colorado economic impact study summarizes employment and economic benefits to the state from activities associated with the Uranium Mill Tailings Remedial Action (UMTRA) Project during Colorado state fiscal year 1993 (July 1, 1992, through June 30, 1993). To capture employment benefits, a questionnaire was distributed to subcontractor employees at the active UMTRA Project sites of Grand Junction, Rifle, and Gunnison, Colorado. An estimated 52 percent of the employees working on the UMTRA Project responded to this information request. Economic data were requested from each site prime subcontractor, as well as from the Remedial Action Contractor. The most significant benefits associated with the UMTRA Project in Colorado are summarized.

This Baseline Risk Assessment of Groundwater Contamination at the Uranium Mill Tailings Site Near Gunnison, Colorado evaluates potential impacts to public health or the environment resulting from groundwater contamination at the former uranium mill processing site. The tailings and other contaminated material at this site are being placed in an off-site disposal cell by the US Department of Energy`s (DOE) Uranium Mill Tailings Remedial Action (UMTRA) Project. Currently, the UMTRA Project is evaluating groundwater contamination. This is the second risk assessment of groundwater contamination at this site. The first risk assessment was performed primarily to evaluate existing domestic wells. This risk assessment evaluates the most contaminated monitor wells at the processing site. It will be used to assist in determining what remedial action is needed for contaminated groundwater at the site after the tailings are relocated. This risk assessment follows an approach outlined by the US Environmental Protection Agency (EPA). The first step is to evaluate groundwater data collected from monitor wells at the site. Evaluation of these data showed that the main contaminants in the groundwater are cadmium, cobalt, iron, manganese, sulfate, uranium, and some of the products of radioactive decay of uranium.

The Gunnison, Colorado, abandoned uranium mill site is one site being cleaned up by the DOE under UMTRCA authority. This site`s contaminated material is being transported to a disposal site on US Bureau of Land Management (BLM) land east of Gunnison. Remedial action activities have temporarily disturbed 0.8 acre (ac) (0.3 hectares [ha]) of wetlands and permanently eliminated 4.3 ac (1.7 ha). As required by the Clean Water Act, the US Army Corps of Engineers (USACE) prepared a Section 404 Permit that addresses the loss of wetlands as a result of remedial action at the Gunnison UMTRA Project site. The 404 permit includes this report as an attachment and it describes the wetland mitigation and monitoring plan. The DOE formulated this plan in consultation with the BLM and the USACE. This report represents a revised version of the mitigation and monitoring plan (DOE, 1992b).