From Introduction: "The purpose of the present paper is to present results obtained recently relating to the characteristics of a full-span sharp-edge spoiler with an 0.02-chord projection above the wing surface at several chordwise positions and also to the relative effectiveness of the sharp-edge spoiler and a wedge-type spoiler located at the 80-percent-chord line."

From Introduction: "A 12-percent-chord-thick wedge section and a reversed NACA 0012 section were chosen for these tests as they are representative of sections having no boat tailing and appreciable boat tailing (i.e., blunt and rounded trailing edges, respectively), and the results of this investigation are compared with those obtained from a previous investigation of the NACA 0012 section. Conclusions are drawn regarding the relative merits of the two unconventional sections and the conventional section in transonic speed range."

From Summary: "This report presents the results of a wind-tunnel investigation conducted to determine the effects of Mach number on the aerodynamic characteristics of a wing of triangular plan form."

Theoretical pressure distributions and measured lift, drag, and pitching moment characteristics at three values of Reynolds number are presented for a group of NACA four-digit-series airfoil sections modified for high-speed applications. The effectiveness of flaps applied to these airfoils and the effect of standard leading-edge roughness were also investigated at one value of Reynolds number. Results are also presented of tests of three conventional NACA four-digit-series airfoil sections.

Report discussing a wing-alone and wing-fuselage configuration with particular characteristics as part of a series of tests of wings using the transonic-bump test technique. Lift, drag, pitching moment, and root bending moment were obtained for the configurations. The effective downwash angles and dynamic-pressure characteristics in the tail region are also described.

Report discussing the aerodynamic effects of length-beam ratios 20 and 30 as compared to length-beam ratios from 6 to 15. There was slightly more longitudinal stability and slightly less directional stability than in the lower ratios and not much change in the minimum drag coefficient.

From Summary: "An investigation of turbojet-engine thrust augmentation by means of tail-pipe burning has been conducted in the NACA Lewis altitude wind tunnel. Several fuel systems and flame holders were investigated in a 29-inch-diameter tail-pipe burner to determine the effect of fuel distribution and flame-holder design on tail-pipe-burner performance and operational characteristics over a range of simulated flight conditions. At an altitude of 5000 feet, the type of flame holder used had only a slight effect on the combustion efficiency."

From Introduction: "The effects of variations in altitude, flight Mach number, and exhaust-nozzle-outlet area on the compressor performance characteristics are graphically presented. A complete tabulation of the compressor performance data is also presented."

From Introduction: "Data are presented in graphical form to show the engine performance over a range of altitudes from 5000 to 50,000 feet and flight Mach numbers from 0.21 to 0.97. Curves are presented to show the windmilling characteristics of the engine. All engine performance data obtained in the investigation are also presented in tabular form."

From Summary: "An investigation has been conducted in the NACA Cleveland altitude wind tunnel to evaluate the operational characteristics of a 3000-pound-thrust axial-flow turbojet engine over a range of simulated altitudes from 2000 to 50,000 feet and simulated flight Mach numbers from 0 to 1.04 throughout the operable range of engine speeds. Operational characteristics investigated include engine operating range, acceleration, deceleration, starting, altitude and flight-Mach-number compensation of the fuel-control system, and operation of the lubrication system at high and low ambient-air temperatures."

"An investigation was conducted in the Cleveland altitude wind tunnel to determine the performance of a Curtiss propeller with four 838-1C2-1SR1 blades on a YP-47M airplane at high blade loadings and engine powers. The study was made for a range of power coefficients between 0.30 and 1.00 at free-stream Mach numbers of 0.40 and 0.50. The results of the force measurements indicate primarily the trend of propeller efficiency for changes in power coefficient or advance-diameter ratio, inasmuch as corrections for the effects of tunnel-wall constriction on the installation have not been applied" (p. 1).

"An altitude-wind-tunnel investigation has been made to determine the performance of a Curtiss 732-1C2-0 four-blade propeller on a YP-47M airplane at high blade loadings and engine power. Propeller characteristics were obtained for a range of power coefficients from 0.30 to 1.00 at free-stream Mach numbers of 0.40 and .50" (p. 1).

From Summary: "An investigation was conducted in the NACA Cleveland altitude wind tunnel to determine the operational characteristics of the Westinghouse 19B-2, 19B-8, and 19XB-l jet-propulsion engines. The 19B engine is one of the earliest experimental Westinghouse axial flow engines. The 19XB-1 engine is an experimental prototype of the Westinghouse 15 series, having a rated thrust of 1400 pounds. Improvements in performance and operational characteristics have resulted in the 19XB-2B engine with a rated thrust of 1600 pounds. The operational characteristics were determined over a range of simulated altitudes from 5000 to 30,000 feet for the 19B engines and from 5000 to 35000 feet for the 19XB-l engine at airspeed from 20 to 380 miles per hour."

From Introduction: "Some experimental data on flame-holder pressure losses have been presented (reference 1 to 4). A theoretical analysis that assume a sudden enlargement of flow area was made at the NACA Lewis laboratory to determine the effect of flame-holder open area and combustion-chamber-inlet Mach number on the pressure losses across flame holders. The results of this analysis were then compared with experimental data obtained with several different flame-holder designs."

From Introduction: "An analytical evaluation of the effects of inlet losses on the net thrust and the fuel economy of an axial-flow-compressor type turbojet engine with a two-stage turbine is presented herein. The analysis is based on engine performance characteristics that were determined from experiments in the NACA Cleveland altitude wind tunnel (references 1 and 2). The experimental investigation did not include tests in which inlet losses were systematically varied, but the effects of these losses can be accurately estimated from the experimentally determined performance characteristics of the engine."

From Introduction: "Water injection at the compressor inlet has been successfully used to increase the thrust of turbojet engines. References 1 and 2 indicate that the sea-level static thrust of a centrifugal-flow-type turbojet engine may be increased about 25 percent by use of liquid injection. Reference 3 indicates that greater thrust augmentation is possible at a compressor pressure ratio of 11 than of 4."

Memorandum presenting a bibliography of unclassified aircraft fire literature consisting of reports from a 20-year period ending January 1, 1949. The reports are separated into the following categories: aircraft fire accidents and statistics, combustibles, ignition sources, fire protection, fire prevention, fire resistance of materials, fire detecting, fire extinguishing, and passenger protection or rescue.

This paper presents the results of the aileron investigation and includes rolling-moment, yawing-moment, and aileron hinge-moment coefficients and pressure coefficients across the aileron-balance seal through a range of angle of attack, tab deflection, and aileron deflection with flaps neutral and deflected 20 degrees and 55 degrees. Some of the effects of wing roughness and balance seal leakage on the aileron and tab characteristics are also presented.

Report presenting an analysis of the spanwise loading using two different methods on the wing of an airplane for which pressure-distribution measurements were available from flight tests up to a Mach number of 0.866. A comparison between measured and calculated distributions was made on the basis of equal wing-panel normal-force coefficients.

Report presenting control requirements and parameters for a ram jet with a variable-area exhaust nozzle, which have been analyzed from calculated performance charts covering flight Mach numbers from 0.6 to 3.0 and altitudes from sea level to 30,000 feet. Requirements for maximum efficiency, safe and stable operation, maximum range of thrust at a given flight Mach number, and control of fuel flow are discussed and control parameters are selected.

Report presenting an investigation to determine average outside surface heat-transfer coefficients for a cascade of symmetrical impulse turbine blades. Results regarding recovery factor, heat-transfer coefficients, effective gas temperature, turbine cascades, cylinders and streamline bodies, and application to rim-cooling theory are provided.

"Tests were made of a 1/18-scale dynamically similar model of the Lockheed Constellation airplane to investigate its ditching characteristics and proper ditching technique. Scale-strength bottoms were used to reproduce probable damage to the fuselage. The model was landed in calm water at the Langley tank no. 2 monorail. Various landing attitudes, speeds, and fuselage configuration were simulated" (p. 1).

Report presenting the results of an experimental investigation to determine the downwash in the region of the trailing vortex behind a trapezoidal-wing tip in a supersonic stream. Results regarding the downwash at spanwise stations, downwash at chordwise stations, and wake survey are provided.

Report presenting drag measurements made on a 10-percent-thick wing and 8-percent-thick tail and a 8-percent-thick wing, 6-percent-thick tail version of the X-1 airplane at a variety of Mach numbers. The drag of the thicker wing was found to be much higher than that of the thinner wing. The fuselage was found to cause interference with the wing of both models, making the separation of wing and fuselage drag difficult to determine.