This paper presents the results of the aileron investigation and includes rolling-moment, yawing-moment, and aileron hinge-moment coefficients and pressure coefficients across the aileron-balance seal through a range of angle of attack, tab deflection, and aileron deflection with flaps neutral and deflected 20 degrees and 55 degrees. Some of the effects of wing roughness and balance seal leakage on the aileron and tab characteristics are also presented.

"An investigation of a 1/7-scale powered model of the Kaiser Fleetwing all-wing airplane was made in the Langley full-scale tunnel to provide data for an estimation of the flying qualities of the airplane. The analysis of the stability and control characteristics of the airplane has been made as closely as possible in accordance with the requirements of the Bureau of Aeronautics, Navy Department's specifications, and a summary of the more significant conclusions is presented as follows. With the normal center of gravity located at 20 percent of the mean aerodynamic chord, the airplane will have adequate static longitudinal stability, elevator fixed, for all flight conditions except for low-power operation at low speeds where the stability will be about neutral" (p. 1).

"Summaries of the gust and draft velocities evaluated from acceleration and airspeed-altitude records taken by NACA instruments installed n P-61c airplanes participating in thunderstorm flights 12 and 13 of July 19, 1946, and July 20, 1946, respectively, are presented in tables I and II herein. These data are of the type presented in reference 1 for previous flights. Inspection of the motion picture records of the pilots' instrument panels for the present flights indicated that the milliameter connected to equipment for measuring ambient air temperature read zero throughout all traverses" (p. 1).

From abstract: "This paper discusses a method for the determination of uranium on platinum discs which does not involve direct weighing of the deposited film. A statistical analysis of the results obtained indicates that the procedure is more consistent than that based on a gravimetric method and offers a relatively quick and convenient means for obtaining uranium assay results where an accuracy of approximately 99% is desired."

Report presenting the performance of a turbosupercharger turbine with three types of exhaust hood. The results for conical hoods, flat-nozzle hoods, and short-turning-radius hoods are provided.

From Summary: "Computations are made of the performance of a propeller designed to develop 56 thrust horsepower at 100 miles per hour. The fuel consumption of the jet-operated propeller would be considerably higher than that of a reciprocating engine and a propeller. The lighter weight of the jet-operated propeller will result in a lighter weight of engine plus fuel for short-range flights. A theoretical analysis is made of a propeller powered by gas jets issuing from the blade tips."

"A six gallon quantity of 1,2,3-trimethylbenezene was prepared and purified in a four-step synthesis involving the condensation of 1,3-pentadiene with crotonaldehyde. The dimethylcyclohexencarboxaldehydes formed were hydrogenated to give the corresponding isomeric dimethylcyclohexylcarbinols. The dehydration of the carbinols and the subsequent dehydrogenation of the trimethylcyclohexenes yielded the 1,2,3-trimethylbenzene. The overall yield was 24 percent; the physical properties of the materials are given" (p. 1).

"The method used for the synthesis and purification of an 8-gallon quantity of 1-ethyl-3-methylbenzene from m-creosol consists in obtaining m-methylcyclohexanone from m-creosol by hydrogenation followed by oxidation, condensation of the ketone with ethylmagnesium bromide, dehydration of the tertiary alcohol obtained, and the dehydration of the olefins to 1-ethyl-3-methylbenzene. A yield of 28 percent of the theoretical was obtained from 98 percent commercial m-creosol. The physical properties of the 1-ethyl-3-methylbenzene are compared with selected values from the literature" (p. 1).

Report presenting an investigation of the tensile strength, stress-to-rupture characteristics, and modulus of elasticity of a sillimanite refractory at various temperatures. The tensile strength varied greatly with temperature.

"In order to determine the aerodynamic effects of an auxiliary belly fuel tank on the Grumman F8F-1 airplane, a wind-tunnel investigation was made on a 1/5 - scale model of the Grumman XF8F-1 airplane. Pitch and yaw tests were made with the model in the cruising and landing configurations for windmilling and take-off power conditions. Tuft studies and static-pressure measurements were also made to determine the flow characteristics in the region of the fuel tank" (p. 1).

The gust and draft velocities evaluated from acceleration and airspeed-altitude records taken by NACA instruments installed in P-61c airplanes participating in thunderstorm flights 9, 10, and 11 of July 12, 1946, July 17, 1946, and July 18, 1946, respectively, are presented in references 1 and 2 for previous flights. In accordance with a recent discussion with a member of the U.S. Weather Bureau staff, motion-picture records of the pilots' instrument panels for the present flights were inspected to note variations in the readings of a milliammeter used in conjunction with other equipment to indicate ambient air temperature. The inspection indicated that the instrument read zero throughout all traverses.

From Summary: "Tests have been made in Langley tank no. I of a dynamic model of the Consolidated Vultee PB2Y-3 airplane. These tests were made using an alternate hull form, the purpose of which was to reduce the bow spray and eliminate the landing instability which are objectionable features of the production design. The major differences from the PB2Y-3 hull included a deeper step to improve the landing stability , and a lengthened forebody and increased beam to reduce the sway in the propellers and on the flaps. The tests showed that the spray characteristics of the revised hull form were much better than that to the production design. In addition the take-off and landing stability of the model with the alternate hull were satisfactory."

Abstract: "A summary of the contents of numerous reports on the liquid phase proportion of uranium chloride."

The preignition characteristics of the R-2800 cylinder, as effected by fuel consumption, engine operating variables, and spark plug type and condition, were evaluated. The effects on preignition-limited performance of various percentages of aromatics (benzene, toluene, cumene, xylene) in a base fuel of triptane were investigated. Two paraffins (triptane and S + 6.0 ml TEL/gal) and two refinery blends (28-R and 33-R) were preignition rated. The effect of changes in the following engine operating variables on preignition limit was determined: inlet-air temperature, rear spark plug gasket temperature, engine speed, spark advance, tappet clearance, and oil consumption. Preignition limits of the R-2800 cylinder using Champion C34S and C35S and AC-LS86, LS87, and LS88 spark plugs were established and the effect of spark plug deterioration was investigated.

From Summary: "An investigation was conducted in the Langley 19-foot pressure tunnel to determine the lift, drag, pitching-moment and stalling characteristics of a 1/4 -scale partial-span model of the left wing of the Republic XF-12 airplane. The effects of a duct inlet, located between the nacelles at the leading edge of the wing, on those characteristics were also investigated. The Reynolds numbers for the investigation covered a range from 4,500,000 to 8,600,000. The results of the investigation indicated that maximum lift coefficients of 1.36, 1.71, and 2.11 were measured on the model with flaps neutral and deflected 20 deg and 55 deg, respectively at a Reynolds number of 8,600,000."

Abstract: The effect of temperature upon the rate of reduction of uranium trioxide by ethyl alcohol has been investigated, and a comparison of the reactivity of the dioxide produced at various temperatures has been made. The percent of carbon in the end product has been studied with respect to both temperature of reduction and length of exposure to alcohol. Optimum conditions for the reduction have been suggested.

"A high-speed wind-tunnel investigation of the aerodynamic characteristics of a full-scale model of the Consolidated Vultee Lark indicates that the missile possesses satisfactory longitudinal-stability and-control characteristics throughout the Mach number range from 0.2 to 0.85, but that the maximum lift coefficients developed are not high enough to insure interception of the target at high altitudes. A reduction in wing loading appears advisable. Although the static longitudinal stability at zero angle of attack changes with Mach number and with lift coefficient, satisfactory control should be possible at all times as the tails retain their relatively large effectiveness throughout the range of Mach numbers and lift coefficients tested" (p. 1).

From introductory paragraph: "This is the first quarterly report of the Biology Division of the Argonne National Laboratory. During the three-month period covered by this report, a large share of the time of many investigators has been spent in collating work done under the Biology Section of the Metallurgical laboratory for publication in the Plutonium Project Record. The large amount of work done under wartime pressure has made this, as in other divisions and projects, an important part of the transition to the post-war period."

"A flight investigation was made to determine the effect of various vertical-tail modifications and of some combinations of these modifications on the directional stability and control characteristics of a propeller-driven fighter airplane. Six different vertical-tail configurations were investigated to determine the lateral-directional oscillation characteristics, the sideslip characteristics, the yaw due to ailerons in rudder-fixed rolls from turns and pull-outs, the trim changes due to speed changes, and the trim changes due to power changes. Results of the tests showed that increasing the aspect ratio of the vertical tail by 40 percent while increasing the area by only 12 percent approximately doubled the directional stability of the airplane" (p. 453).

"An investigation was conducted in the Cleveland altitude wind tunnel to determine the performance of a Curtiss propeller with four 838-1C2-1SR1 blades on a YP-47M airplane at high blade loadings and engine powers. The study was made for a range of power coefficients between 0.30 and 1.00 at free-stream Mach numbers of 0.40 and 0.50. The results of the force measurements indicate primarily the trend of propeller efficiency for changes in power coefficient or advance-diameter ratio, inasmuch as corrections for the effects of tunnel-wall constriction on the installation have not been applied" (p. 1).

"An altitude-wind-tunnel investigation has been made to determine the performance of a Curtiss 732-1C2-0 four-blade propeller on a YP-47M airplane at high blade loadings and engine power. Propeller characteristics were obtained for a range of power coefficients from 0.30 to 1.00 at free-stream Mach numbers of 0.40 and .50" (p. 1).

Abstract: "The first shielded isotope, 34th Br-82 has been isolated in fission. Its fission yield is about 3 x 10-(-5)%. This is a direct measurement of the yield of a primary fission product and gives direct information as to the distribution of nuclear charge among primary fission fragments of given mass numbers as discussed by Glendenin and Coryell."

"A supersonic inlet with supersonic deceleration of the flow entirely outside of the inlet is considered. A particular arrangement with fixed geometry having a central body with a circular annular intake is analyzed, and it is shown theoretically that this arrangement gives high pressure recovery for a large range of Mach number and mass flow and therefore is practical for use on supersonic airplanes and missiles. For some Mach numbers the drag coefficient for this type of inlet is larger than the drag coefficient for the type of inlet with supersonic compression entirely inside, but the pressure recovery is larger for all flight conditions" (p. 1).

"Principles for designing the optimum hull for a large long-range flying boat to meet the requirements of seaworthiness, minimum drag, and ability to take off and land at all operational gross loads were incorporated in a 1/12-size powered dynamic model of a four-engine transport flying boat having a design gross load of 165,000 pounds. These design principles included the selection of a moderate beam loading, ample forebody length, sufficient depth of step, and close adherence to the form of a streamline body. The aerodynamic and hydrodynamic characteristics of the model were investigated in Langley tank no. 1" (p. 1).