A model for the capture spectrum of uranium is introduced in which levels occur at 7, 30, 30+D, 30+2D, ..., ev. Gamma ray and neutron widths are derived from the experimental data for values of D between 10 and 25 ev. The constants of the 7 volt level prove to be independent of D. Extrapolation, using the one level formula, gives a capture cross section at (1/40) ev of 4.9 x 10(24) cm2; this number is, however, quite sensitive to the value taken for the resonance activation. Both neutron and gamma ray widths for the higher levels are approximately proportional to D.

Prior to operating a chain reacting, graphite moderated, water cooled uranium pile at Hanford, the corrosive action of water on uranium was studied. It was necessary to enclose the uranium cylinders in Al jackets. Preliminary data were available which indicated Al jacket corrosion might be influenced by the water temperature. Therefore, in order to specify safe operating conditions, it was desirable to know the temperature at any position on the Al jacket of a slug in the tube. Because of the experimental difficulties encountered in the measurement of the correct surface temperature, the problem has been attacked primarily from a mathematical standpoint. Mathematical formulae have been developed for most of the proposed Hanford designs. The purpose of this report was to evaluate and summarize the theoretical and experimental information for calculation of Al jackets surface temperatures for the design now installed at Hanford. Also, the summarized results were to be put into a form suitable for use in routine calculations. As a result of this survey, the Al surface temperature for the Hanford tube and slug design may be calculated with 15 degrees C by employing routine methods and certain simple factors and equations contained in this report. The factors …

ABSTRACT. When solutions of high specific alpha activity are to be assayed for product, it is often difficult to obtain reproducible results by diluting the solution sufficiently to remove a small volume from which a sample can be prepared and counted at 52% geometry. In order to assay such a solution, most reproducible results have been obtained with minimum effort in sample preparation by making use of low geometry chambers. Two types of low geometry chambers are described: 1) The air-screen type which reduces the geometry simply by placing screens of various transparencies above the sample; and 2) The vacuum low geometry chamber which accomplishes geometry reduction by increasing the distance between sample and collecting electrode thus decreasing the solid angle subtended by the sample and aperture through which the particles pass into the ionization chamber. This type chamber was developed concurrently by this group and the instrument group of Chemistry Section C-I at the Metallurgical Laboratory. Because the geometry of the air-screen type chamber is quite critical to sample spreading and be- cause 12 mm sample plates are required, it has found very little use. On the other hand, the vacuum chamber, because it is noncritical to sample spreading …

Abstract. A method for calculating jacket temperatures in a region of varying heat transfer coefficients is given Some applications are made for temperatures above a supporting rib.

Abstract. Steady-state temperatures were measured in an electrically heated brass cylinder which was water cooled in a four-ribbed Al tube. Thermal transfer coefficients h were calculated from the measured temperatures. Curves of h values are presented for the regions of high and low ribs. the h curve is found to show a much sharper break in the region of high rib than in a low rib region. There is some evidence that h decreases linearly with annular thickness in the range considered. The low rib is found to exert a much greater effect than the high rib in decreasing the h value at points distant from the rib.

Experiments wee performed to evaluate the feasibility of detecting swelled slug elements in Hanford reactors by measuring the force necessary to push the slug column in its tube. These experiments are described. The results indicate the method presents no unsolvable problems.

Abstract. A particle ionization chamber of sensitivity sufficient to detect a source of one neutron per second has been used to measure the neutron yield from a thick target of sulfur upon bombardment with polonium alpha particles. The high-geometry boron trifluoride chamber used had an efficiency of 1.9 percent for fission neutrons. The neutron yield from a thick target of sulfur was measured by this instrument and found to be .0035 +- .0013 neutrons per million incident polonium alpha particles.