The following memorandum discusses experiments and methods to recover uranium from Colorado-Utah sandstone and leaving the vanadium in the tails, improving filterability.

This report was written to replace the directions submitted on April 12, 1943 with improved directions for the preparation of chemical solution X(OC₂H₅)₅.

A model for the capture spectrum of uranium is introduced in which levels occur at 7, 30, 30+D, 30+2D, ..., ev. Gamma ray and neutron widths are derived from the experimental data for values of D between 10 and 25 ev. The constants of the 7 volt level prove to be independent of D. Extrapolation, using the one level formula, gives a capture cross section at (1/40) ev of 4.9 x 10(24) cm2; this number is, however, quite sensitive to the value taken for the resonance activation. Both neutron and gamma ray widths for the higher levels are approximately proportional to D.

Prior to operating a chain reacting, graphite moderated, water cooled uranium pile at Hanford, the corrosive action of water on uranium was studied. It was necessary to enclose the uranium cylinders in Al jackets. Preliminary data were available which indicated Al jacket corrosion might be influenced by the water temperature. Therefore, in order to specify safe operating conditions, it was desirable to know the temperature at any position on the Al jacket of a slug in the tube. Because of the experimental difficulties encountered in the measurement of the correct surface temperature, the problem has been attacked primarily from a mathematical standpoint. Mathematical formulae have been developed for most of the proposed Hanford designs. The purpose of this report was to evaluate and summarize the theoretical and experimental information for calculation of Al jackets surface temperatures for the design now installed at Hanford. Also, the summarized results were to be put into a form suitable for use in routine calculations. As a result of this survey, the Al surface temperature for the Hanford tube and slug design may be calculated with 15 degrees C by employing routine methods and certain simple factors and equations contained in this report. The factors …

Abstract. The effect of various inhibitors on the production of CrIII in W waters containing chromatic has been studies at a variety of pH's in the CP-3 pile. The addition of 2 ppm NaClO3 appears to have little effect a a pH of 5.3, but 2 ppm NaClO3 cr 0.15 ppm of Cl2 (in the form of NaOCl) somewhat decreases the amount of chromatic reduced at a pH of 7.1. The inhibition is not great enough, however, to reduce the amount of CrIII formed to the maximum concentration permissible at W (0.02 ppm). The addition of 3 ppm (NH4)2S2O3 as an inhibiter will permit W water to be used a a Ph of 7.0, but not at a pH of 6.5 as far as chromate reduction is concerned. The concentration of CrIII would be 0.01 ppm and 0.05 ppm, respectively, after one passage through the pile. Previous conclusion as to the effects of temperature, pH, intensity and the addition of ammonium persulfate, which had been reached from experiments with simulation W water, have been checked by studies with solutions made from water chipped directly from Hanford. All of the effects noted were found to be similar to those already reported, …

Abstract. Wigner effects on aluminum, beryllium, and tuballoy have been studied by the electrical resistance method. Samples were exposed during an interval which would have produced an increase of approximately 22% in resistance of AGOT-K graphite. The resistance of tuballoy increased approximately 1%. It is shown that the increase can be accounted for by the amount of fission product impurity formed during the exposure. Neither aluminum nor beryllium showed any change. In the case of Be, the Wigner effect may be obscured, to some extent, by the approximately .2 - .3 atom % of impurity present in the samples. Based on the increase occurring in ADOT-K graphite, a change of approximately .2 - .5 x10-6 ohm-om might be expected in the case of Be. The accuracy of the method was sufficiently great to detect a change of this magnitude. Other experiments with Be will be undertaken when purer samples are available. Meanwhile, some samples of the present type ae being subjected to further irradiation.

ABSTRACT. When solutions of high specific alpha activity are to be assayed for product, it is often difficult to obtain reproducible results by diluting the solution sufficiently to remove a small volume from which a sample can be prepared and counted at 52% geometry. In order to assay such a solution, most reproducible results have been obtained with minimum effort in sample preparation by making use of low geometry chambers. Two types of low geometry chambers are described: 1) The air-screen type which reduces the geometry simply by placing screens of various transparencies above the sample; and 2) The vacuum low geometry chamber which accomplishes geometry reduction by increasing the distance between sample and collecting electrode thus decreasing the solid angle subtended by the sample and aperture through which the particles pass into the ionization chamber. This type chamber was developed concurrently by this group and the instrument group of Chemistry Section C-I at the Metallurgical Laboratory. Because the geometry of the air-screen type chamber is quite critical to sample spreading and be- cause 12 mm sample plates are required, it has found very little use. On the other hand, the vacuum chamber, because it is noncritical to sample spreading …

Abstract. A method for calculating jacket temperatures in a region of varying heat transfer coefficients is given Some applications are made for temperatures above a supporting rib.

Technical report with short articles on (1) Uranium-oxygen system compositions UO2 to U3O3; (2) Thorium hydride; (3) Production of cerium; and (4) Production of thorium.

Abstract. Steady-state temperatures were measured in an electrically heated brass cylinder which was water cooled in a four-ribbed Al tube. Thermal transfer coefficients h were calculated from the measured temperatures. Curves of h values are presented for the regions of high and low ribs. the h curve is found to show a much sharper break in the region of high rib than in a low rib region. There is some evidence that h decreases linearly with annular thickness in the range considered. The low rib is found to exert a much greater effect than the high rib in decreasing the h value at points distant from the rib.

Experiments wee performed to evaluate the feasibility of detecting swelled slug elements in Hanford reactors by measuring the force necessary to push the slug column in its tube. These experiments are described. The results indicate the method presents no unsolvable problems.

Abstract. A particle ionization chamber of sensitivity sufficient to detect a source of one neutron per second has been used to measure the neutron yield from a thick target of sulfur upon bombardment with polonium alpha particles. The high-geometry boron trifluoride chamber used had an efficiency of 1.9 percent for fission neutrons. The neutron yield from a thick target of sulfur was measured by this instrument and found to be .0035 +- .0013 neutrons per million incident polonium alpha particles.

Abstract. The separation of uranyl nitrate from aqueous solutions of 0.635 M thorium nitrate, 3 M nitric acid and 3 M calcium nitrate by extraction with organic solvents has been investigated. Solvents which gave good separations were 2-tthyl hexyl acetate, ethyl benzoate, n-butyl either and beta-beta- dichloroethyl ether. In general, higher esters, ethers and alcohols are better for separating uranium from thorium that the lower homologues. Several solvents were tested at lower nitric acid concentrations. Dibutyl cellosolve gave a very good separation when the solution was 0.1 M nitric acid. Of the solvent mixtures studied that of equal parts of n-butyl ether and dibutyl cellosolve gave a good separation.

Technical report describing that the use of controlled amounts of carbonate, acting both as complexing agent buffer led to a fairly satisfactory procedure for the determination of Th in Th-U alloys, using cupferron. The alloy, dissolved in NHO2, in the presence of HF, is treated with H2SO4 and the mixture is evaporated in SO2 fumes. The solution is diluted and (NH4)2CO2 is added. Th is precipitated from this solution with cupferron. The precipitate is weighed as ThO2 after ignition. An accuracy of 6% was obtained. A method was developed specifically for the determination of Th in U-Th alloys containing 1 to 10% Th. An ion exchange resin in column is used to separate Th from U, with NH2OH-HCl as complexing agent. The Th is then precipitated, ignited, and weighed in the conventional manner.

Abstract. The physico-chemical methods of determining nitric acid and thorium nitrate in solutions containing these two materials were investigated. Conductimetric titration with sodium hydroxide can be used to determine nitric acid accurately. the titration of thorium nitrate requires a separate standardization of the base however, since a basic salt is precipitated rather the normal hydroxide. The titration of thorium is reproductible however, so and empirical standardization can be used. The measurement of the specific gravity and refractivity of the solutions provides a method of determining the concentrations in terms of these two variable. Equations for the concentrations in terms of specific gravity and refractively are given, both in pure solutions and in those saturated with methyl isobutyl ketone.

Abstract: "A summary of the contents of numerous reports on the liquid phase proportion of uranium chloride."

Abstract: "The first shielded isotope, 34th Br-82 has been isolated in fission. Its fission yield is about 3 x 10-(-5)%. This is a direct measurement of the yield of a primary fission product and gives direct information as to the distribution of nuclear charge among primary fission fragments of given mass numbers as discussed by Glendenin and Coryell."

Report describing an updated method to determine traces of metals under polarographic studies, which operates at a higher cathode current density with a small area of the anode immersed in the solution where an appreciable quantity of iron was present in the solutions that were to be polarographed. The results of these studies are also presented.

The following document is a compilation of quarterly reports from August 1946 to November of 1947 from the Biology Division of the University of Chicago.

The following report covers the literature available in the Battelle library as well as the Atomic Energy Commission (New York, N.Y.) on the processing of monazite sands for thorium and rare earth contents.

Abstract: "A theoretical and experimental investigation is made of the diffraction pattern produced by a slit, whose aperture varies uniformly from a constant value A to zero. The results of this investigation are applied to a proposed high speed camera. It is shown that diffraction effects are very serious and cannot be neglected. It seems, unless the suggested design of this high speed camera is changed, the camera will be of little use for accurate measurements, and photographs will show too much blue to give details."

The following report summarizes research done on dissolving uranium from phosphate rock and superphosphate and recovering it from solution in a more concentrated form.

This is a progress report on the work of ore tressing and pyrometallurgical studies as well as a study of chemical work on phosphates. This report covers the month of November, 1947.

The following report describes how to obtain traces of cadmium using dithizone as a reagent.