Data are presented for the fundamental flame velocities of 10 pure alkadienes that have isolated, conjugated, or cumulative double-bond systems. On the basis of this limited amount of data and the flame velocities previously reported, it is concluded that unsaturation changes the flame velocity in the order alkanes ? alkenes ? alkadienes with isolated double bonds ?= alkadienes with conjugated double bonds ? alkadienes with cumulative double bonds ?= alkynes. There were no significant differences in the flame velocities of cis and trans 1,3-pentadiene. The alkadienes 1,2-pentadiene and 2,3-pentadiene, with different positions of the cumulative double bond in the straight chain, have similar flame velocities. Methyl substitution in a hydrocarbon reduces the flame velocity; the extent of the reduction increases with the degree of unsaturation of the hydrocarbon.

Abstract: "Type 347 stainless steel was selected for SIR applications requiring resistance to corrosion in sodium on the basis of limited corrosion data and extrapolation of experience in aqueous media. Subsequent testing indicated that carbide stabilization was not necessary for good resistance to corrosion in sodium. Evaluation of the unstabilized grade of 18-8 stainless steel, Type 304, was intensified because it offered a number advantages over Type 347. Type 304 was more readily available, required fewer strategic materials, was less expensive, and was reported to be weldable with less difficulty. From the results of this investigation, it appears that Type 304 can be substituted for 347 for all SIR applications where the slightly higher elevated temperature strength of 347 is not required."

Report presenting an investigation to determine the aerodynamic effects at low speed of several wing leading-edge chord-extensions incorporated on a complete model with a 40 degree sweptback circular-arc wing of aspect ratio 4 and taper ratio 0.50. Testing indicated that the effectiveness of the chord-extension in increasing the stability is mainly dependent on the spanwise inboard-end location of the device. Results regarding the static longitudinal characteristics and effect of chord-extension span and overhang on the lateral-stability parameters are provided.

Five continuous coatings were produced on zirconium coupons using an anodizing technique. These layers appear to be quite adherent and not subject to visible or audible failure caused by flaxion of the basis metal, Their abrasion resistance, though not investigated thoroughly, appears to be moderately good.

This report follows the study of the properties of eutectic uranium-chromium alloy which is of interest in the Dow-Detroit Edison power reactor. The reactor is described in this report, as well as the casting of alloy, shrinkage measurements during solidification, density measurements, microstructures and macrostructures, mechanical properties, and specific heat data.

Uranium precipitates obtained from Congo leach liquors by an ion exchange process contained more than 0.1 percent chloride. Attempts were made to reduce the chloride content of typical precipitates by calcination of dried precipitate, releaching of dried precipitate with water, and washing of wet precipitate with water. Washing of wet precipitate with an aqueous solution of 0.25 percent Na2SO4, to prevent peptization, provided a simple solution to the problem.

Boundary-layer transition data at low ratios of wall to local stream temperature have been obtained during the free flight of a highly polished cone-cylinder to a maximum Mach number of 5.02 A maximum transition Reynolds number of 32 x 10(exp 6) occurred at a distance of 25.84 inches from the cone apex. The temperature ratio at transition for a local Mach number of 4.0 was approximately 1.30 as compared with theoretical infinite stability solutions of 1.47 and 1.65 by Dunn and Lin (three-dimensional) and Van Driest (two-dimensional), respectively.

The presence of 3 to 5 percent surface-active additive gave the lowest Brookfield apparent viscosity, plastic viscosity, and yield value that were obtained for slurry fuels containing approximately 50 percent vapor-process magnesium in JP-1 fuel. The slurries settled little and were easily remixed. A polyoxyethylene dodecyl alcohol was the most effective of 13 additives tested in reducing the Brookfield apparent viscosity and the yield value of the slurry. The seven most effective additives all had a hydroxyl group plus an ester or polyoxethylene group in the molecule. The densities of some of the slurries were measured.

A study of mixtures of pure methanol and trimethyl borate showed that the composition can be accurately obtained by a simple density determination. The refractive-index determination gives the composition with much less accuracy. The potentiometric titration of boric acid is also discussed.

Performance characteristics of four hydrocarbon fuels having high Btu per gallon were determined in a single turbojet combustor. At simulated low-altitude operating conditions, the fuels with high Btu per gallon generally produced more carbon than did JP-4 and JP-5 fuels. The deposits were reduced appreciably with a fuel-oil additive. At high-altitude conditions, the high Btu-per-gallon fuels gave lower efficiencies than did JP-4 or JP-5 fuels. No attempts were made to improve performance by combustor design modification.

Report presenting a technique and the results obtained of wind-tunnel forced-oscillation tests on a model of the Douglas D-558-II airplane which was instrumented to obtain the dynamic cross derivative and static derivative. Tests were conducted for a range of Mach numbers and angles of attack. Results regarding sample calculations of the period and damping of the full-scale airplane are provided despite not being conclusive due to the inadequate number of flight conditions investigated.

Report documenting the investigation of cosmic and terrestrial background radiation. "Remeasurements in many locations furnished estimates of dosimetric increase in terrestrial levels due to fallout. Radiation measurement sin residential dwellings in he New York metropolitan areas are described" (p. 1).

This report analyzes the High-Energy Electrostatic Plasma Gun, which is to be used for propulsion.

From Introduction: "In the following pages are summarized the factors which influence neutron economy and which, therefore, are important in nuclear safety."

From introduction: The Commission's underlying objective of this program is to conduct sufficient engineering and development work to determine the most feasible and economical methods of producing nuclear super-heated steam from a boiling water reactor.

The purpose of the survey was to determine the radiation levels in the 1 D Boiler Chamber during plant operation. The conclusion of this survey is that the radiation level in the 1 D Boiler Compartment with the 1A, 1B, and 1C Main Coolant loops in service at approximately 100 per cent power ranged from .03 MR/HR to 6.0 MR/HR.