Wind tunnel construction and design is discussed especially in relation to subsonic and supersonic speeds. Reynolds Numbers and the theory of compressible flows are also taken into consideration in designing new tunnels.

"Hot-air engines with dynamic compressors and turbines offer new prospects of success through utilization of units of high efficiencies and through the employment of modern materials of great strength at high temperature. Particular consideration is given to an aerodynamic prime mover operating on a closed circuit and heated externally. Increase of the pressure level of the circulating air permits a great increase of limit load of the unit. This also affords a possibility of regulation for which the internal efficiency of the unit changes but slightly. The effect of pressure and temperature losses is investigated" (p. 1).

Drag tests at zero lift have been made at Mach numbers from 0.7 to approximately 0.95 in the high speed wind tunnel of the Institute of Aerodynamics, ETH, Zurich, on a group of untapered wings of aspect ratio 3.25, having sweep angles of 0 degree and 35 degrees. For each sweep angle, a series of geometrically similar models was tested at a constant Reynolds number to provide a verification of computed tunnel blocking corrections. Tests were also made for wings having thickness ratios of 0.09 and 0.12 and the results compared with results predicted by von Karman's similarity law.

In this report are described four different types of propellers which appeared at widely separated dates, but which were exhibited together at the last Salon de l'Aeronautique. The four propellers are the Chaviere variable pitch propeller, the variable pitch propeller used on the Clement Bayard dirigible, the variable pitch propeller used on Italian dirigibles, and the Levasseur variable pitch propeller.

"A device which does for the aircraft what change speed gears do for the automobile is the invention of Spencer Heath. It comprises a system of special blades and a mechanism for varying the pitch of the blades from zero to 360 degrees, while in flight or otherwise. By adjusting the pitch, either before starting or while the engine is running, to a less than normal angle, the engine is allowed to pick up speed and deliver its maximum power which is necessary in taking-off with a heavier load than the same airplane could otherwise normally carry" (p. 1).

The present report contains the results of a few experiments on three airfoils to which the rear portions, having chords respectively 1/4, 1/3, and 2/5 of the total chords, are hinged so as to form ailerons, especial attention being given to the shape of the slot between the aileron and the main portion of the aileron.

In order that the method may be more easily understood, we will first consider the simpler case when there is no lift, but only drag, and when the streamlines at the measuring point behind the obstacle are nearly parallel. Moreover, the flow is assumed not to deviate much from the two-dimensional flow.

It seems desirable to have some simple method for calculating quickly and with sufficient accuracy: 1) the correct position of the center of gravity; 2) the requisite tail-group dimensions; 3) and the course of the wing and tail-group moments. In out deductions, we will first replace the biplane (disregarding the effect of stagger, decalage and induced drag) by an equivalent monoplane, whose dimensions and position in space can be approximately determined in a simple manner.

Report presenting a description of considerations that go into the layout and building of an aircraft landing field or airstrip. Some of the elements considered include the shape and size of the plot, general arrangement, buildings present near the airstrip, runways, grass, roadways and railroad tracks, field markings, and some miscellaneous factors are provided.

For determination of the elastic constants of airplane tires which are required for the numerical calculations of the shimmy properties of nose and tail wheels, deformation measurements were carried out on four different tires. For this purpose, the tires were loaded in each case with a normal load and then with a lateral force, a tangential force, and a moment. Moreover, the weight and the mass moment of inertia about a vertical axis were determined for the various tires.

This report contains a list of the courses relating to aeronautics announced in Germany, both in the technical high schools and in the universities.

This report examines the take-off conditions of airplanes equipped with tractive propellers, and particularly the more difficult take-off of airplanes heavily loaded per unit of wing area (wing loading) or per unit of engine power (power loading).

This report presents methods to reduce the incidence of aviation accidents. Some of the methods discussed include enlistment and training of aviators, improvement of controls and control surfaces, and upgrading of power plants.

"In a study of journal bearings, the measurement of the oil-film strength produces some significant information. A new instrument is described by means of which the pressure of the oil film in bearings (under constant or alternating load) can be measured and recorded. With this device, the pressure distribution in the lubricating film of a bearing bushing was measured (under different operating conditions on a journal bearing) in the pulsator-bearing-testing machine" (p. 1).

"The investigation was made for the purpose of ascertaining the notch sensitivity of flat strips of light alloy with cylindrical holes under initial tension stress, with special attention to the change in notch-effect factors with the number of load cycles. Then the studies were extended to similar flat strips with pin-loaded holes (tension lugs). This report deals with fatigue tests under initial tension load on flat test specimens of 3116.5 duralumin and AZM 3510.1 electron with plain unloaded and pin-loaded holes (tension lugs) of different forms" (p. 1).

Memorandum presenting a method of calculating the dead reckoning in aerial navigation.

This report not only presents matters of practical importance in the classification of engine fuels, for which other means have proved inadequate, but also makes a few suggestions. It confirms the results of Withrow and Boyd which localize the explosive wave in the last portions of the mixture burned. This being the case, it may be assumed that the greater the normal combustion, the less the energy developed in the explosive form. In order to combat the detonation, it is therefore necessary to try to render the normal combustion swift and complete, as produced in carbureted mixtures containing benzene (benzol), in which the flame propagation, beginning at the spark, yields a progressive and pronounced darkening on the photographic film.

This airship was built by the Zeppelin Airship Company at Friedrichshafen in 1923-4, for the United States Navy, as the reparations service of the German Government in fulfillment of the treaty of peace. A description of the design, components, flight characteristics, blueprints, and photographs are provided.

Report presenting an examination of the errors that result from testing an aircraft model and applying the results to full-sized airplanes. An investigation is carried out to determine how to obtain comparable polars regardless of whether the supports are attached to the upper or lower side of the model.

"The method described in the present report makes it possible to obtain interferometer records with the aid of any one of the available Schlieren optics by the addition of very simple expedients, which fundamentally need not to be inferior to those obtained by other methods, such as the Mach-Zehnder interferometer, for example. The method is based on the fundamental concept of the phase-contrast process developed by Zernike, but which in principle has been enlarged to such an extent that it practically represents an independent interference method for general applications. Moreover, the method offers the possibility, in case of necessity, of superposing any apparent wedge field on the density field to be gauged" (p. 1).

A discussion is given of the application of Fourier series techniques to the problems of linearized supersonic flow. The formulation presented is an extension of the doublet type of "fundamental solution" to higher order types of singularity. The equations developed have application to wing theory but are primarily of importance in wing-body interaction problems. A specific example of a wing-body interference problem is discussed in light of the presented methods.

"So-called flip-flop controls (also called "on-off-course controls") are frequently preferred to continuous controls because of their simple construction. Thus they are used also for the steering control of airplanes. Such a body possesses-even if one thinks, for instance, only of the symmetric longitudinal motion - three degrees of freedom so that a study of its motions under the influence of an intermittent control is at least lengthy. Thus, it is suggested that an investigation of the basic effect of such a control first be made on a system with one degree of freedom" (p. 1).

The conditions which must be met at the slipstream boundary are developed, after which it is shown with the aid of the reflection method how these limiting conditions may be complied with in the case of an airfoil in a propeller slipstream in horizontal flow as well as for the propeller in yaw and with allowance for the slipstream rotation. In connection herewith, it is shown how the effective angles of attack and the circulation distribution with due regard to slipstream effect can be predicted and what inferences may be drawn therefrom for the distribution of lift, drag, and pitching moment.

Unduly high diving speeds can be effectively controlled by diving brakes but their employment involves at the same time a number of disagreeable features: namely, rotation of zero lift direction, variation of diviving moment, and, the creation of a potent dead air region.