In this mathematical investigation, made in collaboration with Dr. Wilhelm Schmidt, we interpret the temporary change (due to some disturbance) in the quantities which define the position of the airplane while in a flat spin. We further examine the effect of this change, of the means resorted to to produce the disturbance, and thus reveal the expedients available for recovering from a flat spin.

The method of riveting by forming the closing head under increasing pressure or by a series of hammer blows is investigated. The question as to the best edge distance, i.e. that distance from the rivet center to the plate edge below which it is unadvisable to go and, at the same time useless to go beyond, was examined. The slippage of plates which occurs under the effect of a certain stress, does not completely disappear on unloading.

"The effect of a slotted wing depends essentially on the fact that a secondary flow branches off from the main flow and passes to the suction side of the profile. It is thus possible to delay the separation greatly and increase the lift. The practical aspect of the slotted wing is less known in Germany, especially the results obtained during the last three years since the introduction of the 'auto control slot'" (p. 1).

"For some time the D.V.L. has been investigating the question of applicability of Handley Page slotted wings to German airplanes. Comparitive gliding tests were made with open and closed slots on an Albatros L 75 airplane equipped with the Handley Page "auto control slots." This investigation served to determine the effect of the auto control slot on the properties and performances of airplanes at large angles of attack. The most important problems were whether the angle of glide at small angles of attack can be increased by the adoption of the auto control slot and, in particular, as to whether the flight characteristics at large angles of attack are improved thereby and equilibrium in gliding flight is guaranteed even at larger than ordinary angles of attack" (p. 1).

This paper presents a relative determination of the wrinkling of a plate wall beam with variable number of supports and methods of attachment. The discussion is based entirely on tests with extensometer readings and number of wrinkles, with complete web and with cutout sections. The author notes that the number of corrugations increase with added stress, keeping constant edge spacing.