Practical Superconductor Development for Electrical Power Applications, Annual Report: 1993 (open access)

Practical Superconductor Development for Electrical Power Applications, Annual Report: 1993

Annual report for the superconductor program at Argonne National Laboratory discussing the group's activities and research. This report describes technical progress of research and development efforts aimed at producing superconducting components in the Y-Ba-Cu, (B1,Pb)-Sr-Ca-Cu, (Tl,Pb,BI)-(Ba,Sr)-Ca-Cu, and Hg-Ba-Ca-Cu-O oxide systems including: synthesis and heat treatment of high-Ta superconductors; formation of monolithic and composite wires, tapes, and coils; characterization of structures and superconducting and mechanical properties; fabrication and properties of films; and development of prototype components.
Date: October 1993
Creator: Argonne National Laboratory. Materials and Components Technology Division.
System: The UNT Digital Library
Radiolytic and Thermal Generation of Gases from Hanford Grout Samples : Interim Report (open access)

Radiolytic and Thermal Generation of Gases from Hanford Grout Samples : Interim Report

Gamma irradiation of WHC-supplied samples of grouted Tank 102-AP simulated nonradioactive waste has been carried out at three dose rates, 0.25, 0.63, and 130 krad/hr. The low dose rate corresponds to that in the actual grout vaults; with the high dose rate, doses equivalent to more than 40 years in the grout vault were achieved. An average G(H2) = 0.047 molecules/100 eV was found, independent of dose rate. The rate of H2 production decreases above 80 Mrad. For other gases, G(N2) = 0.12, G(O2) = 0.026, G(N2O) = 0.011 and G(CO) = 0.0042 at 130 krad/hr were determined. At lower dose rates, N2 and O2 could not be measured because of interference by trapped air. The value of G(H2) is higher than expected, suggesting segregation of water from nitrate and nitrite salts in the grout. The total pressure generated by the radiolysis at 130 krad/h has been independently measured, and total amounts of gases generated were calculated from this measurement. Good agreement between this measurement and the sum of all the gases that were independently determined was obtained. Therefore, the individual gas measurements account for most of the major components that are generated by the radiolysis. At 90 C, H2, …
Date: October 1993
Creator: Meisel, Dan; Jonah, Charles D.; Kapoor, S.; Matheson, Max S. & Mulac, W. A.
System: The UNT Digital Library
Radiolytic and Radiolytically Induced Generation of Gases from Synthetic Wastes : Final Report (open access)

Radiolytic and Radiolytically Induced Generation of Gases from Synthetic Wastes : Final Report

To better understand the processes leading to the generation and release of gases from waste tanks, the authors studied the radiolytic and thermal generation of H2, N2O, N2, O2, and NH3 in nonradioactive waste simulant solutions and slurries. The radiolytic sources for H2 are e(sub aq)⁻ and its predecessors and H atoms. Radiolysis of the water generates some H2 and an additional amount comes from the hydrogen abstraction reaction H + RH(yields) H2+R(center_dot). Nitrate scavenges e(sub aq)(sup (minus) and its predecessors whereas nitrite is the major H-atom scavenger. Computer modeling shows that if [NO3⁻] is above 0.5 M, and [NO2⁻] is above 2M, the addition of other scavengers will have little effect on the yield of H2. In the presence of organic molecules O2 is efficiently destroyed. Small yields of ammonia were measured and the yields increase linearly with dose. The nitrogen in NH3 comes from organic chelators. The yields of gases in solution depend only weakly on temperature. The rate of thermal generation of gases increases upon preirradiation, reaches a maximum, and then declines. The known radiolytic degradation products of chelators, NTA, IDA, glycolate, glyoxylate, formaldehyde, formate, oxalate, and hydroxylainine were examined for their roles in the thermal generation …
Date: October 1993
Creator: Meisel, Dan; Jonah, Charles D.; Kapoor, S.; Matheson, Max S. & Sauer, M. C.
System: The UNT Digital Library
Programming in Fortran M Revision 1 (open access)

Programming in Fortran M Revision 1

Fortran M is a small set of extensions to Fortran that supports a modular approach to the construction of sequential and parallel programs. Fortran M programs use channels to plug together processes which may be written in Fortran M or Fortran 77. Processes communicate by sending and receiving messages on channels. Channels and processes can be created dynamically, but programs remain deterministic unless specialized nondeterministic constructs are used. Fortran M programs can execute on a range of sequential, parallel, and networked computers. This report incorporates both a tutorial introduction to Fortran M and a users guide for the Fortran M compiler developed at Argonne National Laboratory. The Fortran M compiler, supporting software, and documentation are made available free of charge by Argonne National Laboratory, but are protected by a copyright which places certain restrictions on how they may be redistributed. See the software for details. The latest version of both the compiler and this manual can be obtained by anonymous ftp from Argonne National Laboratory in the directory pub/fortran-m at info.mcs.anl.gov.
Date: October 1993
Creator: Foster, Ian; Olson, Robert & Tuecke, Steven
System: The UNT Digital Library
Comparison of Cast-in-Place Concrete Versus Precast Concrete Stay-in-Place Forming Systems for Lock Wall Rehabilitation (open access)

Comparison of Cast-in-Place Concrete Versus Precast Concrete Stay-in-Place Forming Systems for Lock Wall Rehabilitation

"The objectives of this report are as follows: (a) To present the design and details utilized on the precast concrete panel rehabilitation at Troy Lock. (b) To compare the results of precast concrete panel rehabilitation with previous cast-in-place repairs, with respect to quality, cost, and schedule. (c) To recommend refinements in the details and methods of fabrication and erection of the precast panels, based on lessons learned from work performed at Troy Lock." (p. 2).
Date: October 1993
Creator: Miles, William R.
System: The UNT Digital Library
Fishery Interaction Between the Tuna Lonline and Other Pelagic Fisheries in Hawaii (open access)

Fishery Interaction Between the Tuna Lonline and Other Pelagic Fisheries in Hawaii

Abstract: The Hawaii pelagic surface fisheries and more recently the longline fisheries have grown dramatically. As a result, competition between fisheries on the fishing grounds and in the marketplace has also increased. Physical conflicts between vessels and claims of decreased fishing success by surface (troll and handline) fishermen led to the enactment of Federal regulations limiting the number of domestic longline vessels and the areas in which they can operate. The scientific evidence of biological or economic fishery interaction between longline and small-vessel fishermen is limited but suggests that intense longline fishing near the Hawaiian Islands has the potential to affect catch rates in other Hawaii fisheries. Better data collection and more research are needed to document fishery interaction and to improve fishery management.
Date: October 1993
Creator: Skillman, Robert A.; Boggs, Christofer H. & Pooley, Samuel G.
System: The UNT Digital Library