Momentum imaging experiments on dissociative electron attachment to the water molecule are combined with ab initio theoretical calculations of the angular dependence of the quantum mechanical amplitude for electron attachment to provide a detailed picture of the molecular dynamics of dissociation attachment via the two lowest energy Feshbach resonances. The combination of momentum imaging experiments and theory can reveal dissociation dynamics for which the axial recoil approximation breaks down and thus provides a powerful reaction microscope for DEA to polyatomics.

The performance of a polymer electrolyte fuel cell (PEFC) system that is fueled directly by hydrogen has been evaluated for transportation vehicles. The performance was simulated using a systems analysis code and a vehicle analysis code. The results indicate that, at the design point for a 50-kW PEFC system, the system efficiency is above 50%. The efficiency improves at partial load and approaches 60% at 40% load, as the fuel cell operating point moves to lower current densities on the voltage-current characteristic curve. At much lower loads, the system efficiency drops because of the deterioration in the performance of the compressor, expander, and, eventually, the fuel cell. The results also indicate that the PEFC system can start rapidly from ambient temperatures. Depending on the specific weight of the fuel cell (1.6 kg/kW in this case), the system takes up to 180s to reach its design operating conditions. The PEFC system has been evaluated for three mid-size vehicles: the 1995 Chrysler Sedan, the near-term Ford AIV (Aluminum Intensive Vehicle) Sable, and the future P2000 vehicle. The results show that the PEFC system can meet the demands of the Federal Urban Driving Schedule and the Highway driving cycles, for both warm and …

The Remote Low Light Imaging (RULLI) system responds to individual photons using a modification to conventional image intensifier technology and fast timing electronics. Each photon received at the detector is resolved in three dimensions (X, Y, and time). The accumulation of photons over time allows the system to image with very low light levels, such as starlight illumination. Using a low power pulsed laser and very fine time discrimination, three dimensional imaging has been accomplished with a vertical resolution of five cm.

Achieving parallelism in simulations that use Monte Carlo transport methods presents interesting challenges. For problems that require domain decomposition, load balance can be harder to achieve. The Monte Carlo transport package may have to operate with other packages that have different optimal domain decompositions for a given problem. To examine some of these issues, we have developed a code that simulates the interaction of a laser with biological tissue; it uses a Monte Carlo method to simulate the laser and a finite element model to simulate the conduction of the temperature field in the tissue. We will present speedup and load balance results obtained for a suite of problems decomposed using a few domain decomposition algorithms we have developed.

The corrosion of spent nuclear fuel and subsequent mobilization of radionuclides is of great concern in a geologic repository, particularly if conditions are oxidizing. Corroding A516 steel may offset these transport processes within the proposed waste packages at the Yucca Mountain Repository (YMR) by retaining radionuclides, creating locally reducing conditions, and reducing porosity. Ferrous iron, Fe{sup 2+}, has been shown to reduce UO{sub 2}{sup 2+} to UO{sub 2(s)} [1], and some ferrous iron-bearing ion-exchange materials adsorb radionuclides and heavy metals [2]. Of particular interest is magnetite, a potential corrosion product that has been shown to remove TcO{sub 4}{sup -} from solution [3]. Furthermore, if Fe{sup 2+} minerals, rather than fully oxidized minerals such as goethite, are produced during corrosion, then locally reducing conditions may be present. High electron availability leads to the reduction and subsequent immobilization of problematic dissolved species such as TcO{sub 4}{sup -}, NpO{sub 2}{sup +}, and UO{sub 2}{sup 2+} and can also inhibit corrosion of spent nuclear fuel. Finally, because the molar volume of iron material increases during corrosion due to oxygen and water incorporation, pore space may be significantly reduced over long time periods. The more water is occluded, the bulkier the corrosion products, and the …

None

A new method that combines staggered grid Arbitrary Lagrangian-Eulerian (ALE) techniques with structured local adaptive mesh refinement (AMR) has been developed for solution of the Euler equations. The novel components of the combined ALE-AMR method hinge upon the integration of traditional AMR techniques with both staggered grid Lagrangian operators as well as elliptic relaxation operators on moving, deforming mesh hierarchies. Numerical examples demonstrate the utility of the method in performing detailed three-dimensional shock-driven instability calculations.

The heat exchanger of the calciner consists of a vessel into which unfired, horizontal, bayonet tubes extend in a fluidized bed. Strain measurements were taken on several of the tubes under simulated operating conditions and the associated dynamic stresses were calculated. Vibrations greater than design limitations for indefinite operation were found to exist. To restrict these vibrations and prevent further tube fatigue cracking, a tube support was installed. Since the installation of the support, the calciner has operated satisfactorily over 1275 hours. (auth)

The objectives of this study were to demonstrate that the pump speed control system will respond as defined in the equipment specifications and to determine optimum values of controlling variables that will minimize the oscillations that occur in the Na flow rate when transient signals are imposed on the pump speed control system. (W.L.H.)

The traveler spent the year at CERN primarily to test, calibrate, and prepare a BGO photon detector system for use in the August 1990 run of WA80 with sulfur beams and for use in future planned runs with an expanded BGO detector. The BGO was used in test-beam runs in December 1989 and April--May 1990 and in the August data-taking run. The Midrapidity Calorimeters (MIRAC) were also prepared in a new geometry for the August run with a new transverse energy trigger. The traveler also continued to refine and carry out simulations of photon detector systems in present and future planned photon detection experiments. The traveler participated in several WA80 collaboration meetings, which were held at CERN throughout the period of stay. Invited talks were presented at the Workshop on High Resolution Electromagnetic Calorimetry in Stockholm, Sweden, November 9--11, 1989, and at the International Workshop on Software Engineering, Artificial Intelligence, and Expert Systems for High-Energy and Nuclear Physics at Lyon, France, March 19--24, 1990. The traveler participated in an experiment to measure particle--particle correlations at 30-MeV/nucleon incident energies at the SARA facility in Grenoble from November 11--24, 1989.

The Ca II absorption lines observed in the late time optical spectra of Type I supernovae are analyzed in the context of the /sup 56/Ni model. The analysis indicates that a metal rich atmosphere of mass approx. 0.2 M/sub solar mass/ surrounds the /sup 56/Ni core. This result is consistent with properties of the atmosphere derived from spectra near maximum light.

This packaging design criteria provides the criteria for the design, fabrication, safety evaluation, and use of the steel waste package (SWP) to transport remote-handled waste and special-case waste from the 324 facility to Central Waste Complex (CWC) for interim storage.

The growth of Cu Layers deposited on Ru(0001) substrates at temperatures between 500 K and 850 K was studied using surface x-ray diffraction. Results are consistent with a Stransky-Krastanov growth mode with a two layer critical thickness.

The use of electron impact broadened resonance lines to diagnose near-term high density diagnostics is discussed. In particular, the question of how to choose seed and pusher materials to have discernible broadening effects while maintaining line visibility is discussed.

Soft X-ray imager mirrors have been designed, calibrated and fabricated at Lawrence Livermore National Laboratory and characterized at the Advanced Light Source for their performance between 200 and 1300 eV. The mirrors are coated with a multilayer coating consisting of 70 bilayers of W/ SiC. The mirrors are to reflect at 22.5 deg from grazing angle at 1.50 nm wavelength and the width of the reflectivity peak should be at least 1.3%. Also, the mirrors should be non-reflective elsewhere. Our multilayer design was optimized to satisfy these requirements. The coating is very challenging since the individual layer thicknesses need to be less than 1 nm thick and reproducibility from layer to layer is crucial. To minimize the second harmonic peak we designed a multilayer with {Gamma} = 0.5 (W and SiC layer thicknesses are the same). This way we end up with a mirror that has only the 1st and 3rd harmonic peak as shown in Figure 1. To suppress reflectivity outside the first peak we used our novel approach, an antireflective coating. Modeling predicted substantial reduction in reflectivity, especially for lower energies as shown in Figure 1. The experimental results of the soft x-ray imager mirror as measured at …

Grain growth experiments and simulations exhibit self-similar grain size distributions quite different from that derived via a mean field approach by Hillert [ 1]. To test whether this discrepancy is due to insufficient anneal times, two different two-dimensional grain structures with realistic topologies and Hillert grain size distributions are generated and subjected to grain growth via the Monte Carlo Potts Model (MCPM). In both cases, the observed self-similar grain size distributions deviate from the initial Hillert form and conform instead to that observed in MCPM grain growth simulations that start from a random microstructure. This suggests that the Hillert grain size distribution is not an attractor.

Insight into plasma microturbulence and transport is being sought using linear simulations of drift waves on the National Spherical Torus Experiment (NSTX), following a study of drift wave modes on the Alcator C-Mod Tokamak. Microturbulence is likely generated by instabilities of drift waves, which cause transport of heat and particles. Understanding this transport is important because the containment of heat and particles is required for the achievement of practical nuclear fusion. Microtearing modes may cause high heat transport through high electron thermal conductivity. It is hoped that microtearing will be stable along with good electron transport in the proposed low collisionality International Thermonuclear Experimental Reactor (ITER). Stability of the microtearing mode is investigated for conditions at mid-radius in a high density NSTX high performance (H-mode) plasma, which is compared to the proposed ITER plasmas. The microtearing mode is driven by the electron temperature gradient, and believed to be mediated by ion collisions and magnetic shear. Calculations are based on input files produced by TRXPL following TRANSP (a time-dependent transport analysis code) analysis. The variability of unstable mode growth rates is examined as a function of ion and electron collisionalities using the parallel gyrokinetic computational code GS2. Results show the microtearing …

None

By the end of August, 2005, the Russia Federation delivered to the United States (U.S.) more than 7,000 metric tons (MT) of low enriched uranium (LEU) containing approximately 46 million SWU and 75,000 MT of natural uranium. This uranium was blended down from weapons-grade (nominally enriched to 90% {sup 235}U) highly enriched uranium (HEU) under the 1993 HEU Purchase Agreement that provides for the blend down of 500 MT HEU into LEU for use as fuel in commercial nuclear reactors. The HEU Transparency Program, under the National Nuclear Security Administration (NNSA), monitored the conversion and blending of the more than 250 MT HEU used to produce this LEU. The HEU represents more than half of the 500 MT HEU scheduled to be blended down through the year 2013 and is equivalent to the elimination of more than 10,000 nuclear devices. The HEU Transparency Program has made considerable progress in its mission to develop and implement transparency measures necessary to assure that Russian HEU extracted from dismantled Russian nuclear weapons is blended down into LEU for delivery to the United States. U.S. monitor observations include the inventory of in process containers, observation of plant operations, nondestructive assay measurements to determine {sup …

The authors present preliminary BaBar measurements of hadronic cross sections in e{sup +}e{sup -} annihilation using the radiative return technique. The cross sections for e{sup +}e{sup -} {yields} p{bar p}, 3({pi}{sup +}{pi}{sup -}), 2({pi}{sup +}{pi}{sup -})2{pi}{sup 0}, and K{sup +}K{sup -}2({pi}{sup +}{pi}{sup -}) are measured. Measurements of the proton form factor and of the ratio G{sub E}/G{sub M} are also shown.

This paper presents the results of inclusive searches for the strange pentaquark states {Theta}{sup +}(1540), {Xi}{sub 5}{sup --}(1860) and {Xi}{sub 5}(1860){sup 0} as well as the anti-charm pentaquark state {Theta}{sub c}(3099){sup 0} in a dataset of 123.4 fb{sup -1} collected on and 40MeV below the {Upsilon}(4S) resonance by the BABAR detector at the e{sup +}e{sup -} PEP-II storage rings. No evidence for the pentaquark states is found and upper limits on the rate of {Theta}{sup +}(1540) and {Xi}{sub 5}{sup --}(1860) production in e{sup +}e{sup -} annihilation are obtained.

The Hazards Mitigation Center at Lawrence Livermore National Laboratory (LLNL) updated the seismic hazard and design parameters at the Pantex Plant. The probabilistic seismic hazard (PSH) estimates were first updated using the latest available data and knowledge from LLNL (1993, 1998), Frankel et al. (1996), and other relevant recent studies from several consulting companies. Special attention was given to account for the local seismicity and for the system of potentially active faults associated with the Amarillo-Wichita uplift. Aleatory (random) uncertainty was estimated from the available data and the epistemic (knowledge) uncertainty was taken from results of similar studies. Special attention was given to soil amplification factors for the site. Horizontal Peak Ground Acceleration (PGA) and 5% damped uniform hazard spectra were calculated for six return periods (100 yr., 500 yr., 1000 yr., 2000 yr., 10,000 yr., and 100,000 yr.). The design parameters were calculated following DOE standards (DOE-STD-1022 to 1024). Response spectra for design or evaluation of Performance Category 1 through 4 structures, systems, and components are presented.

We have begun building the ''Mercury'' laser system as the first in a series of new generation diode-pumped solid-state lasers for inertial fusion research. Mercury will integrate three key technologies: diodes, crystals, and gas cooling, within a unique laser architecture that is scalable to kilojoule energy levels for fusion energy applications. The primary performance goals include 10% electrical efficiencies at 10 Hz and 100 J with a 2-10 ns pulse length at 1.047 pm wavelength. When completed, Mercury will allow rep-rated target experiments with multiple target chambers for high energy density physics research.

The DECOVALEX project is an international cooperative project initiated by SKI, the Swedish Nuclear Power Inspectorate, with participation of about 10 international organizations. The general goal of this project is to encourage multidisciplinary interactive and cooperative research on modeling coupled thermo-hydro-mechanical-chemical (THMC) processes in geologic formations in support of the performance assessment for underground storage of radioactive waste. One of the research tasks, initiated in 2004 by the U.S. Department of Energy (DOE), addresses the long-term impact of geomechanical and geochemical processes on the flow conditions near waste emplacement tunnels. Within this task, four international research teams conduct predictive analysis of the coupled processes in two generic repositories, using multiple approaches and different computer codes. Below, we give an overview of the research task and report its current status.