The purpose of this report is to describe a method of obtaining deuterons from the 184-inch cyclotron of higher energy than can be achieved from direct acceleration.

Progress report on programs in target research and in accelerator research.

Recent studies on the separation of cobalt and nickel and on the behavior of iron in hydrochloric acid on Dowex-1 resin in relation to the selective adsorption of chloride complexes of these elements have suggested the use of resin for the separation of iron and cobalt.

A calculation method has been developed in order to correlate continuous-flow extraction results in mixer-settlers with rate data for batch experiments. This correlation utilizes dynamic extraction coefficients (E's) that are calculated from the rate data and the equilibrium extraction coefficients. The dynamic coefficients may then be used in stage-by-stage calculations, or their average values used in equations derived herein from the overall performance of center-fed columns.

Let F be the flux of radiation going from a sample of radius R2 to a counter of radius B1 then the emitted intensity of radiation per unit solid angle. Then the flux between two elements of area do1 and do2 will be given by [equation] since [equation] and [equation]. Calculations and equations follow.

This report was written from the notes used by Dr. York in delivering his three lectures on considerations pertinent to the problem of utilizing controlled thermonuclear reactions for the production of power. The first lecture discussed fundamental properties of the DD and DT reactions and the reacting substances. The second lecture described the stellarator, a proposed machine for the controlled production of power from the above reactions. The third lecture described the pinch effect and considered its possible application to the thermonuclear power problem.

Quarterly report on projects - special M.T.A. distribution

Sparking: The most obvious conclusion about 200 m.c. sparking is that it follows strictly surface gradient and does not depend upon total voltage. In order to arrive at this conclusion, a quantitative means for measuring the probability of sparking had to be constructed, since it was clearly evident that the d.c. notion of sparking was inadequate.

A need for a small vertical cylinder-type furnace arises frequently in the Chemistry Department at the Lawrence Radiation Laboratory (LRL). Adequate heat is the major requirement; close control or calibration is not usually necessary. A heating unit of this type can either be used for quickly concentrating solutions in centrifuge cones or, by the addition of a refractory pedestal--can be made into a crucible furnace for size 0 and 00 crucibles. Because much of the chemistry done at LRL is with radioisotopes, disposal of contaminated equipment is an important consideration. In general, furnaces are difficult to decontaminate, hence there was a need for a disposable type. Because nothing meeting the requirements seemed to be commercially available, the Health Chemistry Department made up a simple furnace that has proved useful.

The increasing popularity of liquid-hydrogen targets in physics research has emphasized the need for containers with maximum beam transparency (i.e., thin walls and low Z) and suitable strength at cryogenic temperatures. Fabrication of a Mylar container satisfying these requirements is described here.

It is shown that a radial pressure gradient exists in the silver chloride when it is used as the pressure transmitting medium in Bridgman anvils. The gradient can be obviated by the use of circular sections of wire. The center of curvature of the wire hoop is made coincident with the anvil center. When the inner and outer diameters of the pyrophyllite retaining ring are 1/2 and 7/16" respectively, the pressure, P, is P = (0.725 + 0.468R) L where R is the fractional displacement from the center, and L is the average pressure as determined from the total load and area of the anvil face. The above appears to be valid to 125 Kbars. The Bismuth 6-8 transition is found to accur at 88+3 Kbars.

Calorimetric measurements by Rao and Giauque (1960) showed some unaccountable residual entropy in crystals of [formula] at low temperatures. We have investigated the crystal structure in search of an explanation of the disorder. The resulting structure offers no possibility of disordered rings of hydrogen bonds such as were found in [formula], nor do we find any other explanation of the entropy discrepancy.

The purpose of this Note is to point out the advantages of the sideband technique over the derivative method in wideline NMR spectroscopy. In the sideband technique the absorption spectrum is recorded directly and the modulation amplitude is no longer a determining factor in the resolution.

A system for scintillations from nuclear events has been developed and is presently in use at the Lawrence Radiation Laboratory. This paper primarily describes the pulsed light source used to simulate nuclear events; it also describes the necessary nanosecond pulse techniques to measure the light source parameters and to operate large numbers of lamps. Considerations concerning distribution networks are shown. Use of the light source as a spark gap trigger is also discussed.

This system presents a method for making remote sealed-bag passouts from a multicurie-level chemistry processing enclosure. In addition, the polyethylene bags are changed remotely without exposing contaminated surfaces while always maintaining a low leak-rate seal. Our system employs an interchange box (the Passout Box) attached to the chemistry enclosure. Integrated with the box is a hydraulically operated jack that raises and lowers the bags, and a welder-cutter for sealing them. A single master-slave manipulator teamed with the above units handles all operations.

Molecular sieves are synthetic zeolites which, when dehydrated, contain a network of empty pores and cavities that constitute almost 50% of the total volume of the crystals. They have the unique property of adsorbing within these cavities only those molecules that are small enough to pass through the pores of the crystals, Molecular sieves have a very strong affinity for water and other polar molecules. It is this selective property plus their stability and reasonable cost that make them of interest for the application described herein.

In a previous publication we reported measurements of the momentum spectra of He<sup>3 and H<sup>3 nuclei produced in collisions of 740-MeV protons with deuterium. The He<sup>3 spectrum exhibited an anomaly in the form of a peak in the region corresponding to double pion production. For reactions resulting in a He<sup>3 the two pions (or particle) can be isotopic spin states 0 or 1; if a H<sup>3 nucleus results only 1 = 1 is allowed. We have since repeated the experiment with a new arrangement which enabled us to measure both the He<sup.3 and H<sup>3 spectra with improved resolution and accuracy.

Two IBM-704 codes have been written which are auxiliary to the Bevatron orbit code BOC. The first, BEFCYF, interpolates among tabulated values of the median-plane magnetic flux density of the Bevatron to produce an equivalent array of values in a form appropriate to BOC. The second, DBDT, produces azimuthal derivatives of the fields produced by BEFCYF. The internal operation of BEFCYF and DBDT is described, and instructions for their execution are given.

The principal types of particle accelerators are described briefly according to operation and history. Known operating particle accelerators are listed with their pertinent dimensions.

This report is a corrected copy of the authors "rapporteur talk" at the 1959 Kiev Conference on High Energy Physics. It contains data on the rapporteur system and on interactions of strange particles with protons and neutrons, using data from bubble chambers, counters, and emulsions.

The atomic beam magnetic-resonance method with separated oscillatory fields has been used to measure the hyperfine structure separation and magnetic dipole moment of the isotopes Rb85 and 18.6d Rb86 in the 2S1/2 electronic ground state. Observation of the separation of a [formula] doublet in the intermediate field region gives the value of the moment; the minimum value of the mean doublet frequency gives the value of [formula]. Observation of another [formula] doublet in low field also yields a value for [formula].

This report describes the design and testing of a 1.17-Bev/c separated K{sup -} beam designed in the fall of 1958 in connection with a 15-in. hydrogen bubble chamber experiment.

To date limited agreement has been obtained between theory and experiment for 4f to 4f transitions for Tm (IV) (4f12). It is clear from the considerations that have appeared so far in the literature that intermediate coupling is important in the case of Tm (IV). Solutions of the intermediate field equations yield [formula], and [formula]. Experimental agreement to [formula] was obtained.

The writer has initiated a comprehensive program of equipment development designed to give the maximum practical aid to the physicists and technicians who are carrying out track measurements. Some attention has also been given to developing systems of data handling using International Business Machine (IBM) equipment and Keysort cards. In addition, some of the steps to insure the accuracy of the emulsion data are taken long before the emulsion is studied under the microscope.