A multi-purpose program for processing exponential data has been prepared for the 709 computer. The main purposes of the program is to compute the material buckling from raw data (given counts, time, and counter information) or from previously calculated Athermal's. It is also possible to compute only CeCh (end and harmonic corrections) for a given B11 or series if B11's no counting data being entered. In every case, pile measurements must be submitted as input for corrections.

Different methods of decontaminating plutonium contaminated skin were studied by contamination localized areas of pig skin and then testing the different decontamination methods. Results indicate that the most effective of the decontamination methods tested involved the application of a plastic adherent material to the skin and its later removal by peeling.

Disposal on a specific retention basic of certain radioactive liquid waste solutions emanating from separations from separations plants has been practiced at Hanford since 1944. As used at Hanford, the term "specific retention" is defined as that volume of waste liquids that may be disposed to the soil* and be held against the force of gravity by the molecular attraction between sand grains and the surface tension of the water, when expressed as percent of packed soil volume. In practice it represents the volume of liquid that may be discharged to a disposal pit of known dimensions without leakage to the ground, water, expressed as percent of the total volume of a column of soil with the same cross section as the pit, and extending from the bottom of the pit to the water table. It is recognized that some degree of lateral spreading will occur which has the effect of enlarging the volume of soil contacted by the liquid.

Since the start of E-metal processing in December, 1958, critical mass control in the Redox dissolvers has been provided by a combination of administrative controls, revised dissolver charging procedures, and new dissolving processes and operation control procedures. These were all based on a maximum allowable charge of E-Metal to the dissolvers which was equivalent to 45 percent of the minimum critical mass.

In the field of nondestructive testing the ultrasonic test method is used extensively. In this method ultrasonic energy generated by a transducer is caused to enter the test specimen. The effect on the transducer is cause to enter the test specimen. The effect on the transmission or reflection of the ultrasonic energy by differing test specimen structure is used as an indirect measure of test specimen characteristics.

The referenced memo asked several questions on the operation of the Purex Plant which are of interest to the Eurochemic personnel. These questions are answered below. 1. A qualitative description of the nitric acid recovery systems is desired -- flow of materials, number of pieces of equipment, etc.

The relative neutron capture gamma production in several prospective iron thermal shielding materials for the New Production Reactor was measured to determine the merit of adding boron to the metal. It was found that for the beam geometry the used addition of 1 1/2 percent boron to the iron before casting reduced the soft gamma production by a factor of 6.5 and the hard gamma production by a factor of 10. No attempt was made to measure gamma or neutron transmissions.

Report describing a series of tests performed to review the safety procedures and systems of Hanford Laboratories' N-Reactor.

Aid in redesign of the calibration facility in order to: 1. Reduce the rate of exposure for calibration personnel below 1 mr/hr; 2. Reduce the rate of exposure outside of the 3745 Building; 3. Reduce the risk of breaking radium sources; 4. Improve the efficiency of calibration procedures by: a. Allowing calibration to be done faster; b. Providing several calibration ranges which can operate simultaneously in the present space allowed; c. Allowing instrument survey work to proceed while calibration work is done. A well-type calibration installation is proposed and a brief description of the required shielding is included.