Report issued by the Brookhaven National Laboratory discussing progress of waste concentration studies. As stated in the introduction, "the present report covers all experimental hot runs up to the time the still was turned over to the Waste Control Section for intermediate handling of laboratory D waste" (p. 1). This report includes tables, illustrations, and photographs.

Report describing the maintenance system in place for the coolant system of an Engineering Test Reactor (ETR).

Report presenting in-pile loop experiments DD, EE, FF, GG, L-412, L-413, and L-418, which were seven of a series designed to test the radiation corrosion of zirconium, titanium, and stainless steel alloys in solutions under various conditions of radiation intensity, temperature, solution composition, and velocity of flow. Steel specimens exposed in the loop cores showed increases in corrosive attack over that expected out-of-radiation.

Quarterly report discussing progress on the Fast Ceramic Reactor Development Program, "an integrated analytical and experimental program directed toward the development of fast reactors employing ceramic fuels, with particular attention to mixed plutonium-uranium oxide" (p. 1).

From foreword: "This report consists of two volumes which comprise the Phase III Design Analysis for the Army Package Power Reactor." The first volume discusses design analysis of the reactor.

Abstract: Cast and Wrought specimens and restrained wrought specimens of unalloyed uranium were irradiated in the Materials Testing Reactor, as the first in a series of experiments to develop fuel materials for sodium cooled reactors.

The following report analyzes equations of motion for somewhat idealized circulating-fuel reactor that have been previously discussed, specifically the assumptions that the instantaneous power density is constant along the length of the fuel tubes, that the excess radioactivity depends only upon the average fuel temperature, and that the fuel temperature at the inlet is kept constant.

Report summarizing work done by the Ames Laboratory from April, 1951 through June, 1951 in the fields of metallurgy, chemistry, physics, and engineering.

The following preliminary report describes obliquity factors for shields of various shapes.

Abstract: (1) Grain growth in UO2 pellets was studies between 100 C and 2600 C. The pellets were encapsulated in small vacuum-tight tungsten containers in an argon atmosphere. (2) The grain size-time relationship could be expressed by an equation. A low exponent, m>_ 1/3, was found in those experiments and is related to the type of UO2 investigated. An activation energy of 65 kcal/mole was obtained for the grain growth process. The time exponent, m, increased with increasing temperature if the pellets were not contained in closed capsules bu heated under an argon pressure of 1.5 atm. (3) An interaction between tungsten and UO2 could be observed at a a temperature of 2600 C after prolonged heat treatment.

"Heat production resulting from the absorption of gamma ray photons in thermal shields and the leakage of neutrons and photons from ferritic thermal shields are investigated. The gamma rays considered arise from three types of reactor radiation -- thermal neutrons, fast neutrons, and core and reflector gammas. The energy spectra of the fast neutron leakage and absorption have been investigated in some detail because of the significant contribution of fast neutrons to the heating of the concrete biological shield."

Abstract. the electrodeposition of uranium metal, in the form of tree-like deposits, from molten strontium halide baths is described. Under the best conditions studied, approximately 40% recovery is attained. Freedom from side-reactions of the reduced uranium with anode products and/or refractory materials, and high cathode current densities appear to be essential to the success of the process. the refining of uranium under similar conditions appears to occur quite readily, with approximately 50% current efficiency. The preparation of UI3 is also described.

Introduction. Some forty different uranium compounds have now been given diffraction study at Ames. Reports of these investigations are scattered in the Project literature; many have been reported in a sentence or two as a note along with chemical or metallographic reports. To make the results of this crystal structure work more available this summary of the Ames work has been compiled. (A similar summary has already been published from the Chicago laboratory.)

Abstract. The distribution coefficient of U(VI) between perchloric acid solutions and benzene solutions of TTA has been measured as a function of the acidity. It was possible to interpret the data in terms of the charge on the U(VI) species present in the aqueous phase. The experiments indicate that U(VI) exists as an ion charge +2 at acidities from 0.1M to 2.5M. In the interpretations of the distribution data, it was necessary to know the acidity coefficient of the uranyl chelate in the benzene solution. This was determined by measurement of the solubility of the compound UO2K2 - xH2). The activity coefficient of UO2K2 was found to decrease rapidly as the concentration of TTA in the benzene phase increased above 0.1M. This is probably due to the formation of a species involving more than two TTA molecules per U(VI)

"This is the first quarterly report on Task II of the subject Utilization of Radioactive Isotopes in Coal Process Research. There were two separate projects on Tank I; I. methods Development for Tritium Labeling of Coal Product Hydro-carbons, and II. Applications of Radio-Tracer Techniques to the Study of Fluidized Particle Mechanics. The following extended work on Task II concerns only Methods Development of Radio-Tracing With Tritium."