Pacific Northwest National Laboratory (PNNL) established an area monitoring dosimeter program in accordance with Article 514 of the Department of Energy (DOE) Radiological Control Manual (RCM) in January 1993. This program is to minimize the number of areas requiring issuance of personnel dosimeters and to demonstrate that doses outside Radiological Buffer Areas are negligible. In accordance with 10 CFR Part 835.402 (a)(1)-(4) and Article 511.1 of the PNNL Radiological Control Program Description, personnel dosimetry shall be provided to (1) radiological workers who are likely to receive at least 100 mrem annually, and (2) declared pregnant workers, minors, and members of the public who are likely to receive at least 50 mrem annually. Program results for calendar years 1993-2003 confirm that personnel dosimetry is not needed for individuals located in areas monitored by the program.

The performance of two large NaI(Tl) scintillation detectors has been determined as a function of detector type and as a function of temperature. One detector had dimensions of 4?4?16 in.3 with a stainless steel shell while the other detector was 2?4?16 in.3 with an aluminum shell. Absolute counting efficiencies for photopeaks and total counts were measured at 0.46 m and 2.0 m for gamma sources ranging in energy from 25 keV to 2500 keV. Photopeak resolutions were measured over the same energy range. The changes in pulse height and photopeak resolution were measured as a function of temperature over the range -50 C to +60 C. As expected from prior literature data, the scintillator light output decreases at both higher and lower temperatures compared to room temperature. However, the maximum peak height in this work occurred at 0 C whereas the literature gives the maximum light output at about 40 C. This difference is attributed to the fact that in this work, the phototubes and preamplifiers were heated and cooled along with the scintillator. Both detectors continued to function successfully over the entire temperature range studied in this work. The pulse height decreased by about 33% at -50 C and …

The monocular passive ranging (MPR) problem in remote sensing consists of identifying the precise range of an airborne target (missile, plane, etc.) from its observed radiance. This inverse problem may be set as a global optimization problem (GOP) whereby the difference between the observed and model predicted radiances is minimized over the possible ranges and atmospheric conditions. Using additional information about the error function between the predicted and observed radiances of the target, we developed GMG, a new algorithm to find the Global Minimum with a Guarantee. The new algorithm transforms the original continuous GOP into a discrete search problem, thereby guaranteeing to find the position of the global minimum in a reasonably short time. The algorithm is first applied to the golf course problem, which serves as a litmus test for its performance in the presence of both complete and degraded additional information. GMG is further assessed on a set of standard benchmark functions and then applied to various realizations of the MPR problem.

In this report we investigate order, stability, and phase transformations for a series of actinide-based alloys. The statics and kinetics of precipitation and ordering in this class of alloys are modeled with a scheme that couples fundamental information on the alloy energetics obtained from experimental and assessed thermo-chemical data to the CALPHAD approach commonly used in industry for designing alloys with engineering specificity with the help of the Thermo-Calc software application. The CALPHAD approach is applied to the study of the equilibrium thermodynamic properties of Pu-based alloys, Pu-X, where X=Al, Fe, Ga. The assessment of the equilibrium phase diagrams in the whole range of alloy composition has been performed with the PARROT module of the Thermo-Calc application software. Predictions are made on the low temperature and Pu-rich side of the phase diagrams of Pu-Ga and Pu-Al for which controversy has been noted in the past. The validity of the assessed thermo-chemical database will be discussed by comparing predicted heats of transformation for pure Pu with measured values from differential scanning calorimetry analysis. An overall picture for the stability properties of Pu-Ga and Pu-Al that reconciles the results of past studies carried out on these alloys is proposed. Results on phase …

None

None

This report provides historical context and reviews some of the factors inspiring debate related to funding for rail freight.

None

This report addresses Class Action Fairness Acts of 2003 and 2004 related to class actions and legislative proposals in the 108th congress.

None

Differences caused by BPM reading one bunch and multi-bunch average need to be well understood before the beam parameters, such as the synchrotron tune, betatron tune, and chromaticity, are extracted from those BPM data. It is easy to perform such a study using numerical simulation other than modifying the BPM electronics.

The purpose of this task is to characterize the physical properties of kaolin/sand slurry used to test the performance of a new submersible mixer pump which is undergoing performance testing at the TNT Waste Tank mockup facility. Three different sample locations, the SMP cooling water exit, the SMP fluid flow field, and SMP effective cleaning radius were used for sampling over the seven day test. The physical properties determinations for the kaolin/sand slurry samples include rheology, weight percent total solids (wt TS), density, and particle size distribution were requested, though not all these determinations were performed on all the samples. The physical properties determinations are described in more detail in section 1.0. Measurements were performed at Savannah River National Laboratory in accordance with the Technical Assistance Request (TAR)1. The data, average of two measurements, is shown in the table below. This data clearly shows that the SMP-CWE samples contained more so lids than those at other sample locations for a given sample day. The SMP-FFF and SMP-ECR were similar in solids content. The rheology of the samples is dependent on the wt solids concentration and are all within the bounds stated in the TAR.

This report presents wind speed and direction summaries for a wide area of the Southeastern United States (including EPA Region 4) and portions of the Ohio and Mississippi River Valleys in a monthly time series format that is further broken down for eight hours of the day (01:00, 04:00, 07:00, 10:00, 13:00, 16:00, 19:00, 22:00 EST). The data used for these summaries were obtained from the International Station MeteorologicalClimate Summary (FCCA, 1996), a publicly available source of tabular data from weather stations around the world distributed through the National Climatic Data Center. The advantage of examining the data in the form presented in this report is that it is far easier to examine and understand regional and diurnal weather patterns than would be possible with the tabular data in its original format. The winds presented here can be viewed online in any of three formats through an Internet link. The first format is the traditional wind rose as used in our earlier reports f or 13 stations in the Southeast, c.f., Weber, Buckley, and Parker 2002 and Weber, Buckley, and Kurzeja 2003. The second format is the mode, or most frequent wind direction sector from the wind rose plots (i.e., …

This work studies the stability of the toroidicity-induced Alfven Eigenmodes (TAE) in the proposed ITER burning plasma experiment, which can be driven unstable by two groups of energetic particles, the 3.5-MeV {alpha}-particle fusion products and the tangentially injected 1-MeV beam ions. Both species are super-Alfvenic but they have different pitch-angle distributions and the drive for the same pressure gradients is typically stronger from co-injected beam ions as compared with the isotropically distributed {alpha}-particles. This study includes the effect of anisotropy of the beam-ion distribution function on TAE growth rate directly via the additional velocity space drive and indirectly in terms of the enhanced effect of the resonant particle phase space density. For near parallel injection, TAEs are marginally unstable if the injection aims at the plasma center where the ion Landau damping is strong, whereas with the off-axis neutral-beam injection the instability is stronger with the growth rate near 0.5% of TAE mode frequency. In contrast, for perpendicular beam injection TAEs are predicted to be stabilized in nominal ITER discharges. In addition, the effect of TAEs on the fast-ion beta profiles is evaluated on the bases of a quasi-linear diffusion model which makes use of analytic expressions for the local …

The dispersion properties of ion acoustic waves (IAW) are sensitive to the strength of ion-ion collisions in multi-species plasma in which the different species usually have differing charge-to-mass ratios. The modification of the frequency and damping of the fast and slow acoustic modes in a plasma composed of light (low Z) and heavy (high Z) ions is considered. In the fluid limit where the light ion scattering mean free path, {lambda}{sub th} is smaller than the acoustic wavelength, {lambda} = 2{pi}/k, the interspecies friction and heat flow carried by the light ions scattering from the heavy ions causes the damping. In the collisionless limit, k{lambda}{sub th} >> 1, Landau damping by the light ions provides the dissipation. In the intermediate regime when k{lambda}{sub th} {approx} 1, the damping is at least as large as the sum of the collisional and Landau damping.

Demand patterns for world oil and oil products show significant diversity by country, region, and product groupings. As a result of this diversity it is not possible to attach blame for the current level of price to any one nation, region, or product segment. The view that the oil market is international in scope and tightly interrelated is enhanced by the demand data. As a result of the integrated nature of the world oil market it is unlikely that any one nation acting on its own can implement policies that isolate its market from broader price behavior. As new major oil importers, notably China, and potentially India, expand their demand, the oil market likely will have to expand production capacity. This promises to increase the world’s dependence on the Persian Gulf members of the Organization of Petroleum Exporting Countries, especially Saudi Arabia, and maintain upward pressure on price.

None

None

None