Weekly newspaper from Albany, Texas that includes local, county, and state news along with extensive advertising.

Daily newspaper from Altus, Oklahoma that includes local, state, and national news along with advertising.

Weekly newspaper from Archer City, Texas that includes local, state, and national news along with advertising.

Many of today's automated real-time testing systems for embedded systems were developed using expensive custom hardware and software. In this article they describe how to use commercially available off-the-shelf hardware and software to design and develop an automated real-time test systems for Embedded Programmable Logic Controller (PLC) Based Control Systems. The system development began with the implementation of the VALI/TEST Pro testing methodology as a means for structuring the testing. Using this methodology, they were able to decompose system requirement documents for a Personnel Safety System (PSS) into its high, intermediate and detail level requirements. next, the validation procedures for the PSS system were decomposed into testing units called builds, test runs and test cases. To measure the PSS system's test coverage three levels of system requirements were mapped to their respective unit level of test using a specially constructed validation matrix that was designed to handle over 150 test cases and requirements. All of the above work led to the development of an Automated Real-Time Test System (ARTTS) that is capable of performing complete black box testing in real-time for Embedded PLC Based Control Systems. Also note, that the PSS system under test and mentioned in this paper is …

Daily newspaper from Baytown, Texas that includes local, state, and national news along with advertising.

Weekly newspaper from Bogata, Texas that includes local, state, and national news along with advertising.

A boundary plasma turbulence code BOUT is presented. The preliminary encouraging results have been obtained when comparing with probe measurements for a typical Ohmic discharge in CT-7 tokamak. The validation and benchmark of BOUT code and experimental diagnostic tools for fusion boundary plasma turbulence is proposed.

Radionuclide and metal contaminants are present in the vadose zone and groundwater throughout the U.S. Department of Energy (DOE) weapons complex. Demonstrating in situ immobilization of these contaminants in vadose zones or groundwater plumes is a cost-effective remediation strategy. However, the implementation of in situ remediation requires definition of the mechanism that controls sequestration of the contaminants. One such mechanism for metals and radionuclides is co-precipitation of these elements in authigenic calcite and calcite overgrowths. Calcite, a common mineral in many aquifers and vadose zones in the arid western U.S., can incorporate divalent metals such as strontium, cadmium, lead, and cobalt into its crystal structure by the formation of solid solutions. The rate at which trace metals are incorporated into calcite is a function of calcite precipitation kinetics, adsorption interactions between the calcite surface and the trace metal in solution, solid solution properties of the trace metal in calcite, and also the surfaces upon which the calcite is precipitating. A fundamental understanding of the coupling of calcite precipitation and trace metal partitioning and how this may occur in aquifers and vadose environments is lacking. The focus of the research proposed here is to investigate the facilitated partitioning of metal and …

Weekly newspaper from Canadian, Texas that includes local, state and national news along with extensive advertising.

Weekly newspaper from Rusk, Texas that includes local, state and national news along with extensive advertising.

Weekly newspaper from The Colony, Texas that includes local, state, and national news along with advertising.

Weekly newspaper from Comanche, Texas that includes local, state, and national news along with advertising.

We characterize the performance of a complete 64-pixel compact gamma camera imaging module consisting of optically isolated 3 mm 3 mm 5 mm CsI(Tl) crystals coupled to a custom array of low-noise Si PIN photodiodes read out by a custom IC. At 50 V bias the custom 64-pixel photodiode arrays demonstrate an average leakage current of 28 pA per 3 mm 3 mm pixel, a 98.5 percent yield of pixels with <100 pA leakage, and a quantum efficiency of about 80 percent for 540 nm CsI(Tl) scintillation photons. The custom 64-channel readout IC uses low-noise preamplifiers, shaper amplifiers, and a winner-take-all (WTA) multiplexer. The IC demonstrates maximum gain of 120 mV / 1000 e-, the ability to select the largest input signal in less than 150 ns, and low electronic noise at 8 ms peaking time ranging from 25 e- rms (unloaded) to an estimated 180 e- rms (photodiode load of 3 pF, 50 pA). At room temperature a complete 64-pixel detector module employing a custom photodiode array and readout IC demonstrates an average energy resolution of 23.4 percent fwhm and an intrinsic spatial resolution of 3.3 mm fwhm for the 140 keV emissions of 99mTc. Construction of an array …

This report summaries the computer modeling studies and how the results of these studies were used to estimate contaminant releases to the groundwater. These modeling studies were used to improve saltstone landfill designs and are the basis for the current reference design. With the reference landfill design, EPA Drinking Water Standards can be met for all chemicals and radionuclides contained in Savannah River Plant waste salts.

A sudden drop in power after a beam interruption leads to thermal fatigue effects in structural components in the blanket of an accelerator driven system. These thermal fatigue effects limit component lifetimes. A sudden return to power after a beam interruption can contribute significant additional thermal fatigue and greatly reduce component lifetimes. One obvious solution is a gradual return to power after a beam interruption. There are two potential problems with this solution. One problem involves interruptions that are longer than the thermal time constants of thin structural members but shorter than the time constants of thick structural members. In such a case, a gradual return to power reduces the additional thermal fatigue in the thin structural members but increases the thermal fatigue in thick structural members. Some compromise is necessary. The other problem is that for thick components with long thermal time constants a long, gradual return to power is required to minimize additional thermal fatigue. Such a slow return to power can reduce the utilization or the effective load factor of the system. Specific examples of beam interruptions with various assumptions on return to power are provided for a preliminary design for the blanket of the Accelerator Driven …

Daily newspaper from Perry, Oklahoma that includes local, state, and national news along with advertising.

Deposit summary of $35.00 made on August 9, 2001.

This report describes the shielding model development for the JB-Line Upgrade project. The product of this effort is a simple-to-use but accurate method of estimating the personnel dose expected for various operating conditions on the line. The current techniques for shielding calculations use transport codes such as ANISN which, while accurate for geometries which can be accurately approximated as one dimensional slabs, cylinders or spheres, fall short in calculating configurations in which two-or three-dimensional effects (e.g., streaming) play a role in the dose received by workers.

Weekly newspaper from Dublin, Texas that includes local, state, and national news along with advertising.

Weekly newspaper from Electra, Texas that includes local, state, and national news along with advertising.

Daily newspaper from Chickasha, Oklahoma that includes local, state, and national news along with advertising.

Weekly newspaper from Garber, Oklahoma that includes local, state, and national news along with advertising.

Recent development in geophysical methods allows us to accurately map the distribution of seismic velocity, density and electrical conductivity beneath the surface and between boreholes. These physical properties are dependent on porosity, fluid saturation, fluid conductivity, pressure, temperature, clay content, and in some circumstances, permeability. Hydrological parameters may be measured or inferred from drill hole experiments or directly from core samples. The point measurements in a drill hole are then interpolated to the interwell volume using either statistical properties of the local geology or reasonable estimates of the geological structure and lithology. More direct evidence is obtained from well tests, and interference tests between multiple wells, but these are ill posed inverse problems when it comes to defining the properties of the entire interwell volume. Furthermore such tests are impossible in the vadose zone. The interpolation of well data is often inaccurate or misleading and the central problem for all these studies is the lack of these fundamental parameters throughout the subsurface volume of interest.

Weekly newspaper from Goldthwaite, Texas that includes local, state, and national news along with extensive advertising.