Various properties of duralumin as used in aircraft construction are discussed, including the effects of temperature, working, tempering, and strength.

The general basis of the theory of lifting surfaces is discussed. The problem of the flow of a fluid about a lifting surface of infinite span is examined in terms of the existence of vortexes in the current. A general theory of permanent flow is discussed. Formulas for determining the influence of aspect ratio that may be applied to all wings, whatever their plane form, are given.

Given here is the most recent research on skin frictional resistance of plane surfaces in air that was conducted by Dr. Wieselsberger under the direction of Dr. Prandtl of Gottingen University. In all, 16 models were tested. These were divided into four groups, as follows: 1) cloth, in the original condition; 2) cloth, with the nap singed off; 3) cloth, with three coats of dope; and 4) cloth, with six coats of dope. Each group consisted of four models of uniform width, 1 meter, and of lengths of 0.5, 1.0, 1.5, and 2.0 meters.

"The study of the motion of perfect fluids is of paramount importance for the understanding of the chief phenomena occurring in the air surrounding an aircraft, and for the numerical determination of their effects. The author recently successfully employed some simple methods for the investigation of the flow of a perfect fluid that have never been mentioned in connection with aeronautical problems. These methods appeal particularly to the engineer who is untrained in performing laborious mathematical computations, as they do away with these and allow one to obtain many interesting results by the mere application of some general and well-known principles of mechanics" (p. 1-2).

"The laws of curvilinear motion are established and the transverse forces on elongated airship hulls along a curved path are investigated" (p. 1).

"The results of the two preceding notes are applied to airships and checked with wind tunnel tests" (p. 1).

Emphasized here is the desirability of using recording instruments in the investigation of the characteristics of airplanes with particular reference to the National Advisory Committee for Aeronautics (NACA) control force recorder. Given here are photographs, records, and a description of the instrument developed by NACA for investigations on different types of aircraft. Described here is an instrument for recording control forces.

Report presenting the theory of the ideal propeller, which is important for solving the problem of the action of propellers. Several different theories of propeller action are described and compared to determine which ones seem to be the most accurate.

"This note, prepared for publication by the National Advisory Committee for Aeronautics, is a collection of the tables of the factor of apparent mass that have been published up to now. The theory of the motion of solids in a perfect fluid is of the greatest value for the study of most aerodynamic problems, and the additional apparent mass of an immersed solid is the most important characteristic for such theoretical numerical computations. It will therefore be helpful to have the most important values of the apparent mass - for some elementary cases - collected in a convenient form" (p. 1).

This report records observations and recommendations resulting from an inspection trip to representative aircraft manufacturing establishments and repair stations. This inspection was made for the Navy Department and was specifically in reference to gluing practice at the various places visited. The period of the visits was between November 23, 1926 and February 16, 1927.

In order to experimentally study the conditions leading to ice formation on aircraft surfaces, an aircraft was equipped with small auxiliary surfaces and aerodynamic shapes similar to struts, wires, Pitot heads, etc. This airplane was flown at an altitude where a temperature of 32 F was encountered, at such times as cloud formations could be found at the coincident altitude. Here it was discovered that ice formed rapidly in regard to quantity, character, shape, and rapidity of formation.

Given here is a brief history of the design and construction of the "Spirit of St. Lewis", the airplane that Charles Lindbergh flew solo across the Atlantic. Although the plan was to modify a standard model Ryan M-2, it was quickly determined that modification was less practical than redesign. Given here are the general dimensions, specifications, weight characteristics, and man hours required to build the aircraft.

"A successful take-off can be made with an airplane so heavily loaded that it cannot climb to a height greater than the span of its wings. The explanation is that the power required to maintain level flight at an altitude of the order of the wing span may be as much as 50 per cent greater than that necessary when the airplane is just clear of the ground. The failure of heavily loaded airplanes to continue climbing at the rate attained immediately after the actual take-off is a grave hazard and has resulted in great risk or catastrophe in three notable cases which are cited" (p. 1).

Note presenting an investigation undertaken to answer the question of what cycle of heat phases should be selected for small high speed engines running on solid or airless injection with compression ignition, and what the relative proportions of the heat phases should be.

This report is on the changes in forces on each wing of a biplane cellule when either the stagger or the gap is varied. Since each test was carried up to a 90 degree angle of attack, the results may be used in the study of stalled flight and of spinning as well as in the structural design of biplane wings.

The results of tests to determine the effect of wheel brakes on the landing run of an airplane under conditions of load and at various wind velocities are presented.

"This investigation on the relative wear of several bearing materials lubricated by gasoline was conducted at the Langley Memorial Aeronautical Laboratory, as part of a general research on fuel injection engines for aircraft. The specific purpose of the work was to find a durable bearing material for gear pumps to be used for the delivery of gasoline and diesel engine fuel oil at moderate pressures to the high pressure pumps of fuel injection engines" (p. 1).

This note describes tests of the drag due to a Wright "Whirlwind" (J-5) radial air-cooled engine mounted on a cabin type airplane. The tests were made in the 20-foot Propeller Research Tunnel of the National Advisory Committee for Aeronautics. The drag was obtained with three different types of exhaust stacks: Short individual stacks, a circular cross section collector ring, and a streamline cross section collector ring.

"The various speeds of an airplane can only be measured in horizontal flight, since there are no means for measuring the angle of ascent or descent. The measurements must be corrected for the density of the air. This is obtained by simultaneous pressure and temperature measurements during flight" (p. 1).

Discussed here is the suggested installation of the 'unbalanced' 8-cylinder VE-engine. The suggestion was that a flexible mounting be used instead of bolting the engine rigidly to the airplane structure. It was concluded that a flexible connection between the engine and the airplane is probably possible. A flexible connection primarily diminishes the vibrations due to inertia and, to a lesser degree, those due to torque variation. However, engines vibrate more when freely suspended than when rigidly mounted, and this vibration has a detrimental effect on all connections between the engine and the airplane. Therefore, in view of the relatively insignificant advantages which may be derived from the elastic suspension of the engine, the present rigid mounting is to be preferred. Vibration reduction can be achieved by incorporating in the fuselage as many of the rigid airplane parts as possible.

The problem before us is to determine the total stresses in an axially loaded column of any degree of restraint which is also subject to transverse bending both from a uniformly distributed load and from concentrated loads. The solution of this problem is of special importance in the design of aircraft which consist of slender columns" (p. 1).

Ballistics is a science hundreds of years old and this report is an attempt to show how these older principles can be used in the newer science of aerodynamics.

In short, the "politics of aviation" lies in a few propositions: the need of having as large a number of fields as possible and of sufficient area; the utilization of the larger part of the existing military fields; the selection of uncultivated or unproductive fields, whenever technical conditions permit; ability to disregard (save in exceptional cases) objections of an agricultural nature.

The establishment of air service in the Belgian Congo is detailed in this report. The airplanes, landing fields, and air routes are all discussed.