Report presenting an experimental investigation of thrust augmentation of an axial-flow-type turbojet engine with a 4000-pound-thrust rating using a water-alcohol injection at the compressor inlet at sea-level conditions and zero ram. Three injection systems were investigated in order to obtain satisfactory atomization and distribution of the injected liquids. Results regarding engine performance and engine operation are provided.

Report presenting an adhesive, FPL-710, which produces higher strength at temperatures up to 600 degrees Fahrenheit than previously obtained and possesses good resistance to aging at high temperatures. It also has acceptable resistance to creep and immersion in various organic solvents. Results regarding its strength properties, heating and aging resistances, and variables affecting bond strength are provided.

"An investigation was conducted with a single combustor from a British Rolls-Royce Nene turbojet engine to determine the altitude performance characteristics of AN-F-58 fuels. Three fuel blends conforming to AN-F-58 specifications were prepared in order to determine the influence of fuel boiling temperatures and aromatic content on combustion efficiencies and altitude operational limits. The performance of the three AN-F-58 fuels was compared in the range of altitudes from sea level to 65,000 feet, engine speeds from 40- to 100- percent normal rated, and flight Mach numbers of 0.0 and 0.6" (p. 1).

Memorandum presenting aerodynamic characteristics of the NACA 64-010 and 64A010 airfoil sections as determined from wind-tunnel tests at Mach numbers from 0.3 to 0.9. Comparisons are made which indicate the only significant differences in the characteristics of the two sections to be a consistently greater lift-curve slope and an approximately 10-percent greater maximum section lift coefficient at Mach numbers above 0.7 for the NACA 64-010 airfoil section.

"The relation of Whitcomb's "area rule" to the linear formulas for wave drag at lightly supersonic speeds is discussed. By adopting an approximate relation between the source strength and the geometry of a wing-body combination, the wave-drag theory is expressed in terms involving the areas intercepted by oblique planes or Mach planes. The resulting formulas are checked by comparison with the drag measurements obtained in wind-tunnel experiments and in experiments with falling models in free air. Finally, a theory for determining wing-body shapes of minimum drag at supersonic Mach numbers is discussed and some preliminary experiments are reported" (p. 757).

"An investigation was made of the take-off characteristics of a 1/10-scale dynamic model of the Convair XF2Y-1 airplane. This airplane is a water-based, jet-propelled, delta-wing fighter incorporating a hydro-ski landing gear. Tests were made with the original configuration, with the beaching wheels removed, and with the wheels installed and fairings added in front of the wheels" (p. 1).

"The compression plane is intended for operation on or close to the surface of the water, and has a hull with a concave bottom which forms the upper surface of a tunnel into which air is forced under pressure to support part of the load. The results of the tests made in Langley tank no. 1 include values of the horizontal forces, trimming moment, and static pressure in the tunnel for a wide range of loads and speeds and two power conditions, and are presented in the form of curves against speed with load as a parameter. The results are scaled up to 10 times the model size for three conditions at which the model is self-propelled at a steady speed" (p. 1).

Report presenting an investigation to determine the effects of camber on the aerodynamic characteristics of a series of rectangular wings with various aspect ratios and thickness-to-chord ratios using the transonic-bump method. Testing occurred over a range of Mach and Reynolds numbers. Lift, drag, and pitching-moment characteristics are presented for wings of 5 aspect ratios, NACA 63A2XX and 63A4XX sections, and 5 thickness-to-chord ratios.

Report presenting the results of an investigation of cross-sectional-area distribution, nacelle configuration, and landing-gear-fairing configuration on the minimum drag characteristics of a model of a four-engine bomber airplane with a low-aspect-ratio triangular wing. The lateral stability characteristics are also included.

From Summary: "A method is presented for calculating the lift and centers of pressure of wing-body and wing-body-tail combinations at subsonic, transonic, and supersonic speeds. A set of design charts and a computing table are presented which reduce the computations to routine operations. Comparison between the estimated and experimental characteristics for a number of wing-body and wing-body-tail combinations shows correlation to within + or - 10 percent on lift and to within about + or - 0.02 of the body length on center of pressure."

Memorandum presenting an analysis of the two-dimensional, geared, trailing-edge flap-tab combination at supersonic speeds to determine if the combination could be used to reduce the hinge moments to extremely small values while retaining a large part of the lift effectiveness of a plain flap with the same ratio of flap chord to wing chord.

Report presenting an investigation of the flow properties of a constant-outer-wall annual diffuser in combination with a tailpipe in order to come up with a configuration suitable for turbojet afterburners. Information about axial inlet flow and whirling inlet flow is provided. During testing, a vena contrata region formed downstream from the center body terminal and rendered the first 1/2 diameter of the tailpipe ineffective.

Report presenting the results of pitching-moment and lift measurements on a model of the D-558-1 airplane with no nose-inlet flow at several tail and elevator settings at a range of Mach numbers. Information about the stability, control, and downwash results is provided.