The authors compare frequency doubling of broadband light in a single nonlinear crystal with doubling in five crystals with intercrystal temporal walk off compensation, and with doubling in five crystals adjusted for offset phase matching frequencies. Using a plane-wave, dispersive numerical model of frequency doubling they study the bandwidth of the second harmonic and the conversion efficiency as functions of crystal length and fundamental irradiance. For low irradiance the offset phase matching arrangement has lower efficiency than a single crystal of the same total length but gives a broader second harmonic bandwidth. The walk off compensated arrangement gives both higher conversion efficiency and broader bandwidth than a single crystal. At high irradiance, both multicrystal arrangements improve on the single crystal efficiency while maintaining broad bandwidth.

Information technology is being used to provide interactive access to data collected from the electro-metallurgical treatment of spent fuel. The data are results from many hundreds of experiments performed to better characterize the processes by which uranium is separated from the waste products. Web-based display and relational database query capabilities facilitate the identification of trends in the data and the relating of these trends to the underlying electrochemistry. The objectives are to ensure that the process behavior is well understood, to make readily accessible the necessary data for development and validation of models, and to identify unexpected trends in the data as indications of phenomena not yet represented in the models.

Understanding the exchanges of carbon between the atmosphere and ocean and the fate of carbon delivered to the deep sea is fundamental to the evaluation of ocean carbon sequestration options. An additional key requirement is that sequestration must be verifiable and that environmental effects be monitored and minimized. These needs can be addressed by carbon system observations made from low-cost autonomous ocean-profiling floats and gliders. We have developed a prototype ocean carbon system profiler based on the Sounding Oceanographic Lagrangian Observer (SOLO; Davis et al., 1999). The SOLO/ carbon profiler will measure the two biomass components of the carbon system and their relationship to physical variables, such as upper ocean stratification and mixing. The autonomous observations within the upper 1500 m will be made on daily time scales for periods of months to seasons and will be carried out in biologically dynamic locations in the world's oceans that are difficult to access with ships (due to weather) or observe using remote sensing satellites (due to cloud cover). Such an observational capability not only will serve an important role in carbon sequestration research but will provide key observations of the global ocean's natural carbon cycle.

The design of high-power lasers such as those used for inertial confinement fusion demands accurate modeling of the interaction between lasers and plasmas. In inertial confinement fusion, initial laser pulses ablate material from the hohlraum, which contains the target, creating a plasma. Plasma density variations due to plasma motion, ablating material and the ponderomotive force exerted by the laser on the plasma disrupt smooth laser propagation, undesirably focusing and scattering the light. Accurate and efficient computational simulations aid immensely in developing an understanding of these effects. In this paper, we compare the accuracy of two methods for calculating the propagation of laser light through plasmas. A full laser-plasma simulation typically consists of a fluid model for the plasma motion and a laser propagation model. These two pieces interact with each other as follows. First, given the plasma density, one propagates the laser with a refractive index determined by this density. Then, given the laser intensities, the calculation of one time step of the plasma motion provides a new density for the laser propagation. Because this procedure repeats over many time steps, each piece must be performed accurately and efficiently. In general, calculation of the light intensities necessitates the solution of …

A broad baseline study of the levels and distributions of trace metals and PCB compounds in sediments has been undertaken. PCB concentrations in surface sediments reflect the source of these contaminates in the region. The highest PCB concentrations as Aroclor 1260 (approximately 10 ng g{sup -1}) were found in sediments near the outflow of the Po river. The lowest concentrations (1.5 ng g{sup -1} dry) were associated with the sediments from the Jabuka Pit in the Middle Adriatic. These values are quite similar to total PCBs (<1.0-17) measured in surface sediments sampled off the coast of Croatia in 1977-78. Thus, based on the limited amount of new data available, it appears that there has been little, if any, decrease in PCB loading in Adriatic sediments over the past 15 years. Downcore profiles of PCBs in sediment cores are also discussed from a pollution history standpoint. Likewise, total mercury in surface sediments was also highest at stations off the Po (403-499 ng g{sup -1} dry) and lowest (67-224 ng g{sup -1}) in the Jabuka Pit. In one core located just south of the Po outflow, total Hg concentrations at all depths were relatively high decreasing gradually from approximately 400 ng g{sup …

In the past several years there have been several large (M{sub w} > 7.0) earthquakes in the eastern Mediterranean region (Gulf of Aqaba, Racha, Adana, etc.), many of which have had aftershock deployments by local seismological organizations. In addition to providing ground truth data (GT << 5 km) that is used in regional location calibration and validation, the waveform data can be used to aid in calibrating regional magnitudes, seismic discriminants, and velocity structure. For small regional events (m{sub b} << 4.5), a stable, accurate magnitude is essential in the development of realistic detection threshold curves, proper magnitude and distance amplitude correction processing, formation of an M{sub s}:m{sub b} discriminant, and accurate yield determination of clandestine nuclear explosions. Our approach provides a stable source spectra from which M{sub w} and m{sub b} can be obtained without regional magnitude biases. Once calibration corrections are obtained for earthquakes, the coda-derived source spectra exhibit strong depth-dependent spectral peaking when the same corrections are applied to explosions at the Nevada Test Site (Mayeda and Walter, 1996), chemical explosions in the recent ''Depth of Burial'' experiment in Kazahkstan (Myers et al., 1999), and the recent nuclear test in India. For events in the western U.S. …

The survivability and performance of the debris shields on the National Ignition Facility (NIF) are a key factor for the successful conduct and affordable operation of the facility. The improvements required over Nova debris shields are described. Estimates of debris shield lifetimes in the presence of target emissions with 4 - 5 J/cm{sup 2} laser fluences (and higher) indicate lifetimes that may contribute unacceptably to operations costs for NIF. We are developing detailed guidance for target and experiment designers for NIF to assist in minimizing the damage to, and therefore the cost of, maintaining NIF debris shields. The guidance limits the target mass that is allowed to become particulate on the debris shields (300 mg). It also limits the amount of material that can become shrapnel for any given shot (10 mg). Finally, it restricts the introduction of non-volatile residue (NVR) that is a threat to the sol-gel coatings on the debris shields to ensure that the chamber loading at any time is less than 1 pg/cm{sup 2}. We review the experimentation on the Nova chamber that included measuring quantities of particulate on debris shields by element and capturing shrapnel pieces in aerogel samples mounted in the chamber. We also …