Abstract: "Stainless steel-clad fuel sheet 0.020 in. thick with a 0.008-in. core of stainless steel plus UO2 was produced by roll cladding a powder metal compact. The effects of processing variables, core-matrix composition, quantity of oxide, and oxide particle size on the properties of the sheet were investigated. The strength and ductility of the core decreased sharply as the quantity of oxide in the core increased from 20 to 40 w/o. Over the range of matrix compositions investigated the particle size of the oxide had little affect on the core strength. In cores containing 21 w/o of oxide. 18 w/o chromium, 82 w/o iron matrix prepared from the elemental metal powders had the highest strength and ductility, but this matrix was susceptible to cracking during thermal cycling. As elemental 18 w/o chromium, 9 w/o nickel, 73 w/o iron matrix was the most satisfactory from the standpoint of fabrication and over-all characteristics of the resulting sheet."

This report follows experiments on the acute effects of 200 kv X-ray treatments on chickens in a series of 200 animals exposed to doses of 2 r to 1200 r, with an additional 100 chickens.

Four D-12 coil nests have failed since the start-up of the Redox Separations plant. Due to the high contamination and radiation levels of these vessels, the cost of decontamination has prevented the examination of all but one of the four. It was hoped that the examination of D-12 pot #2 would lead to an explanation of all four failures. This report will deal primarily with the metallurgical examination of the failure of D-12 pot #2.

Technical report with short reports from the (1) Physics Section I; (2) Physics Section II ; and (3) Physics Section III.

"The canonical (hamiltonlan) formulation of a relativistic dynamical theory is outlined, and the existence and explicit construction of general hamiltonian theories of relativiatic interacting particles are discussed. These hamiltonian theories are shown to contain certain elements of arbitrariness which are eliminated in manifestly coveriant formulations."

The desirability of operating many of the Purex columns at elevated temperatures, ca. 50-70 C, has made it necessary to obtain data on the stability of the solvent at these higher temperatures. Since the present diluent, Shell Spray Base, will not be entirely safe at the upper temperature limit, a number of diluents with higher flash point have been investigated concurrently with Shell Spray Base. This report presents data covering the first phases of this investigation, namely, the effect of nitric and nitrous acid on the solvent at 71 C. or higher temperatures.

The following is an attempt to explain the method by which the precision associated with an observed volume reading in a process vessel (E-12, C-1) should be calculated based upon a regression analysis of cumulative data. There are two types of volume measurement consists of estimating the total volume in a vessel at some inventory time. A transfer measurement consists of estimating the volume between two levels within a tank.

From July through December, a total of 1750 hr of computer time was used by programmers in "debugging" and in running problems. With the acquisition of a second operator, the evening shift was initiated. A night-shift operator is presently being trained, and third-shifts operations will probably begin after completion of the magnetic-tape memory. / Engineering time is regularly scheduled for 4 hr each morning and 1/2 hr late in the afternoon. An electronic technician is on duty during evening-shift operations. / Installations of the magnetic-tape memory units is complete, and the units are expected to go into operation in the near future. Work is continuing on the new input-output system.

In a section of the area occupied by the Atomic Energy Commission in Grand Junction, Colorado, a pilot plant is being erected to test a resin-in-pulp process. The process is based on the adsorption of uranium by resin from acid pulps. The first ores to be treated at this plant will be Monticello Stockpile Material. Samples of the various stockpiles sere subjected to a series of leaching, filtering and settling tests, the results of which are presented in this report.