We present the search for the lepton flavour violating decay {tau} {yields} lK{sup 0}{sub s} with the BaBar experiment data. This process and many other lepton flavour violating {tau} decays, like {tau} {yields} {mu}{gamma} and {tau} {yields} lll, are one of the most promising channel to search for evidence of new physics. According to the Standard Model and the neutrino mixing parameters, branching fractions are estimated well below 10{sup -14}, but many models of new physics allow for branching fractions values close to the present experimental sensitivity. This analysis is based on a data sample of 469fb{sup -1} collected by BABAR detector at the PEP-II storage ring from 1999 to 2007, equivalent to 431 millions of {tau} pairs. the BABAR experiment, initially designed for studying CP violation in B mesons, has demonstrated to be one of the most suitable environments for studying {tau} decays. The tracking system, the calorimeter and the particle identification of BABAR, together with the knowledge of the {tau} initial energy, allow an extremely powerful rejection of background events that, for this analysis, is better than 10{sup -9}. Being {tau} {yields} lK{sup 0}{sub s} a decay mode without neutrinos, the signal {tau} decay can be fully reconstructed. …

The lifetime of the B{sup {+-}} meson is measured using the decay channel B{sup +} {yields} {bar D}{sup 0}{pi}{sup +}. The measurement is made using approximately 1.0 fb{sup -1} of Tevatron proton-anti-proton collision data at {radical}s = 1.96 TeV collected by the CDF detector. The data were collected using impact parameter based triggers that were designed to select events with a secondary vertex. The trigger selection criteria result in data rich in a variety of B hadron decays, but intrinsically bias the lifetime distribution of the collected signal events. The traditional way to compensate for the bias is to use information from simulation. Presented here is a new method for correction of the lifetime bias using an analytical technique that uses information from the data only. This eliminates measurement uncertainty due to data and simulation agreement, ultimately resulting in a smaller systematic measurement uncertainty. The B{sup {+-}} lifetime measurement is the first measurement using this new technique and demonstrates its potential for use in future measurements. The B{sup {+-}} lifetime is measured to be {tau}(B{sup {+-}}) = 1.662 {+-} 0.023(stat) {+-} 0.015(syst)ps.

In the past decades, there has been increasing interest in pulsed high power RF sources for building high-gradient high-energy particle accelerators. Passive RF pulse compression systems have been used in many applications to match the available RF sources to the loads requiring higher RF power but a shorter pulse. Theoretically, an active RF pulse compression system has the advantage of higher efficiency and compactness over the passive system. However, the key component for such a system an element capable of switching hundreds of megawatts of RF power in a short time compared to the compressed pulse width is still an open problem. In this dissertation, we present a switch module composed of an active window based on the bulk effects in semiconductor, a circular waveguide three-port network and a movable short plane, with the capability to adjust the S-parameters before and after switching. The RF properties of the switch module were analyzed. We give the scaling laws of the multiple-element switch systems, which allow the expansion of the system to a higher power level. We present a novel overmoded design for the circular waveguide three-port network and the associated circular-to-rectangular mode-converter. We also detail the design and synthesis process of …

The standard model (SM) of particle physics is a theory, describing three out of four fundamental forces. In this model the Cabibbo-Kobayashi-Maskawa (CKM) matrix describes the transformation between the mass and weak eigenstates of quarks. The matrix properties can be visualized as triangles in the complex plane. A precise measurement of all triangle parameters can be used to verify the validity of the SM. The least precisely measured parameter of the triangle is related to the CKM element |V{sub td}|, accessible through the mixing frequency (oscillation) of neutral B mesons, where mixing is the transition of a neutral meson into its anti-particle and vice versa. It is possible to calculate the CKM element |V{sub td}| and a related element |V{sub ts}| by measuring the mass differences {Delta}m{sub d} ({Delta}m{sub s}) between neutral B{sub d} and {bar B}{sub d} (B{sub s} and {bar B}{sub s}) meson mass eigenstates. This measurement is accomplished by tagging the initial and final state of decaying B mesons and determining their lifetime. Currently the Fermilab Tevatron Collider (providing p{bar p} collisions at {radical}s = 1.96 TeV) is the only place, where B{sub s} oscillations can be studied. The first selection of the 'golden', fully hadronic decay …

This thesis presents the measurement of energy dependence of the neutrino-nucleon inclusive charged current cross section on an isoscalar target in the range 3-50 GeV for neutrinos and 5-50 GeV energy range for antineutrinos. The data set was collected with the MINOS Near Detector using the wide band NuMI beam at Fermilab. The size of the charged current sample is 1.94 x 10{sup 6} neutrino events and 1.60 x 10{sup 5} antineutrino events. The flux has been extracted using a low hadronic energy sub-sample of the charged current events. The energy dependence of the cross section is obtained by dividing the charged current sample with the extracted flux. The neutrino and antineutrino cross section exhibits a linear dependence on energy at high energy but shows deviations from linear behavior at low energy. We also present a measurement of the ratio of antineutrino to neutrino inclusive cross section.

Top quarks are predominantly produced in pairs via the strong interaction in {bar p}p collisions at {radical}s = 1.96 TeV . The top quark has a weak isospin 1/2, composing a weak isospin doublet with the bottom quark. This characteristic predicts not only top quark pair production via strong interaction but also single production together with a bottom quark via weak interaction. However, finding single top quark production is challenging since it is rarely produced ({sigma}{sub singletop} = 2.9 pb) against background processes with the same final state like W+jets and t{bar t}. A measurement of electroweak single top production probes the W-t-b vertex, which provides a direct determination of the Cabbibo-Kobayashi-Maskawa (CKM) matrix element |V{sub tb}|. The sample offers a source of almost 100% polarized top quarks. This thesis describes an optimized search for s-channel single top quark production and a measurement of the single top production cross section using 2.7 fb{sup -1} of data accumulated with the CDF detector. We are using events with one high-p{sub T} lepton, large missing E{sub T} and two identified b-quark jets where one jet is identified using a secondary vertex tagger, called SecVtx, and the other jet is identified using SecVtx or …

The observation of neutrino oscillations (neutrino changing from one flavor to another) has provided compelling evidence that the neutrinos have non-zero masses and that leptons mix, which is not part of the original Standard Model of particle physics. The theoretical framework that describes neutrino oscillation involves two mass scales ({Delta}m{sub atm}{sup 2} and {Delta}m{sub sol}{sup 2}), three mixing angles ({theta}{sub 12}, {theta}{sub 23}, and {theta}{sub 13}) and one CP violating phase ({delta}{sub CP}). Both mass scales and two of the mixing angles ({theta}{sub 12} and {theta}{sub 23}) have been measured by many neutrino experiments. The mixing angle {theta}{sub 13}, which is believed to be very small, remains unknown. The current best limit on {theta}13 comes from the CHOOZ experiment: {theta}{sub 13} < 11{sup o} at 90% C.L. at the atmospheric mass scale. {delta}{sub CP} is also unknown today. MINOS, the Main Injector Neutrino Oscillation Search, is a long baseline neutrino experiment based at Fermi National Accelerator Laboratory. The experiment uses a muon neutrino beam, which is measured 1 km downstream from its origin in the Near Detector at Fermilab and then 735 km later in the Far Detector at the Soudan mine. By comparing these two measurements, MINOS can obtain …

Presented is a measurement of the simultaneous production of a W{sup {+-}} boson in association with a second weak boson (W{sup {+-}} or Z{sup 0}) in p{bar p} collisions at {radical}s = 1.96 TeV. Events are consider with one electron or one muon, missing transverse energy, and at least two hadronic jets. The data were collected by the D0 detector in Run IIa of the Tevatron accelerator and correspond to 1.07 fb{sup -1} of integrated luminosity for each of the two channels (WW/WZ {yields} e{nu}q{bar q} and WW/WZ {yields} {mu}{nu}q{bar q}). The cross section for WW + WZ production is measured to be 20.2 {+-} 2.5(stat) {+-} 3.6(sys) {+-} 1.2(lum) pb with a Gaussian significance of 4.4 standard deviations above the background-only scenario. This measurement is consistent with the Standard Model prediction and represents the first direct evidence for WW and WZ production with semi-leptonic decays at a hadron collider.