Report presenting the results of an investigation to determine the static longitudinal and lateral stability and control characteristics of a model of the Republic MX-1554 airplane at a specified Mach and Reynolds number. No analysis was provided in the paper in order to expedite publication.

Memorandum presenting the application of the nuclear-reactor simulator to an investigation of the validity of the customary assumption of uniform distributions of fuel burnup and fission-product poisoning in a reactor core. The two-group calculation results show the effects of the approximation on the reactivity, power distribution, and xenon-135 distribution for a specific power reactor in which the initial power density varied by a factor of approximately 4 over the core volume.

Memorandum presenting a supersonic wind-tunnel investigation of the origin and distribution of store interference in the 4- by 4-foot supersonic pressure tunnel at Mach number 1.6 in which separate forces on a store, a fuselage, a swept wing, and a swept-wing-fuselage combination were measured. The store was separately sting-mounted on its own six-component internal balance and was traversed through a wide systematic range of spanwise, chordwise, and vertical positions.

Performance of experimental annular turbojet combustors at simulated high altitude supersonic flight conditions.

Memorandum presenting a supersonic wind-tunnel investigation of the origin and distribution of store interference performed in the 4- by 4-foot supersonic pressure tunnel at Mach number 1.61 in which separate forces on a store, a fuselage, a swept wing, and a swept-wing-fuselage combination were measured. The report presents data on a configuration which simulated a heavy-bomber airplane with stores of several shapes and sizes.

"Comparisons are made of experimental and theoretical zero-lift wave drag for several nose shapes, wing-body combinations, and models of current airplanes at Mach numbers up to 1.0. The experimental data were obtained from tests in the Ames 6- by 6-foot supersonic wind tunnel and at the NACA Wallops Island facility. The theoretical drag was found by use of linear theory utilizing model area distributions" (p. 1).

Memorandum presenting a preliminary evaluation of three types of combustor configuration in a 48-inch-diameter ramjet engine in order to select the one with the greatest promise of efficient and stable combustion at low fuel-air ratios and low combustor-inlet pressures. Results regarding the inlet conditions, performance, and a comparison of the configurations are provided.

Report presenting a full-scale, free-jet investigation to determine the performance of a side-inlet supersonic diffuser designed for a flight Mach number of 2.75. Several internal modifications made to improve diffuser-outlet flow uniformity were also evaluated. Results regarding the general characteristics of the diffuser and effect of diffuser modifications on flow distribution are provided.

Report presenting an investigation of three cone-cylinder bodies to obtain boundary-layer-transition data at very low ratios of wall to local stream temperature. Surface finishes at several levels of roughness height were tested. Results regarding the smooth body and rough bodies are provided.

From Summary: "The effects of primary and runback ice formations on the section drag of a 36 deg swept NACA 63A-009 airfoil section with a partial-span leading-edge slat were studied over a range of angles of attack from 2 to 8 deg and airspeeds up to 260 miles per hour for icing conditions with liquid-water contents ranging from 0.39 to 1.23 grams per cubic meter and datum air temperatures from 10 to 25 F. The results with slat retracted showed that glaze-ice formations caused large and rapid increases in section drag coefficient and that the rate of change in section drag coefficient for the swept 63A-009 airfoil was about 2-1 times that for an unswept 651-212 airfoil. Removal of the primary ice formations by cyclic de-icing caused the drag to return almost to the bare-airfoil drag value. A comprehensive study of the slat icing and de-icing characteristics was prevented by limitations of the heating system and wake interference caused by the slat tracks and hot-gas supply duct to the slat. In general, the studies showed that icing on a thin swept airfoil will result in more detrimental aerodynamic characteristics than on a thick unswept airfoil."

Report discussing an investigation to determine the effect of spin on the aerodynamic characteristics of the Army Ordnance Corps 60-millimeter T-24 mortar shell with several tail-fin configurations. Tests were performed at several airspeeds, speeds of rotation, and angles of attack. Under all test conditions, the models were statistically stable and the yawing moment increased with speed of rotation at higher angles of attack.

"A principle formerly used in an instrument for cloud detection was further investigated to provide a simple and rapid means for measuring the liquid-water content of clouds at temperatures above and below freezing. The instrument consists of a small cylindrical element so operated at high surface temperatures that the impingement of cloud droplets creates a significant drop in the surface temperature. The instrument is sensitive to a wide range of liquid-water content and was calibrated at one set of fixed conditions against rotating multicylinder measurements. The limited conditions of the calibration Included an air temperature of 20 F, an air velocity of 175 miles per hour, and a surface temperature in clear air of 475 F" (p. 1).

Report presenting an investigation to determine the longitudinal stability and afterbody pressure characteristics of the TX-14 and TX-16 special weapons at transonic and supersonic speeds. Results regarding dynamic testing and pressure testing are provided.

"Flight tests were made to determine the total-pressure recovery of a split-wing ram-jet inlet with a fixed area exit 20 percent larger than the inlet throat over a Mach number range from 1.4 to 3.16. Total-pressure-recovery measurements at the diffuser exist station indicated abrupt pressure changes in the total-pressure profile throughout the Mach number range. Comparisons of average total-pressure recovery with the theoretical total-pressure recovery showed good agreement" (p. 1).

Report presenting testing of a fineness-ratio-2.71 right circular cylinder and a fineness-ratio-4.0 circular cylinder with a rounded nose and flared afterbody over a range of Mach and Reynolds numbers. Time histories, cross plots of force coefficients, rolling velocity, and longitudinal-force coefficient are provided for the two cylinders.

Report presenting the results of a wind-tunnel investigation to determine the effects of various free-flight rocket-model booster-adapter configurations on the aerodynamic characteristics in pitch and sideslip of a swept-wing, fighter airplane model with a Mach number of 2.01. Results regarding the effect of adapter shape and aerodynamic characteristics of the model alone are provided.

Memorandum presenting a technique for predicting the influence of body vortices and the wing shock-expansion field on the pitch-up characteristics of supersonic airplanes to supplement the calculative methods for wing vortices which are well known. The method is applied to the prediction of the pitch-up characteristics of four airplanes with high tails, of which one serves as a calculative example.

Memorandum presenting an investigation made with an electrical heat-flow analog to determine the effect of internal modifications to a wing leading edge on the surface-temperature rise and temperature distribution for conditions of transient aerodynamic heating at high supersonic speeds. Results regarding the leading-edge temperature rise, influence of conduction on leading-edge temperature for skins of uniform thickness, and surface-temperature distribution are provided.

Memorandum presenting wind tunnel tests performed on a family of missiles. This paper summarizes some of the performance and stability and control characteristics of the missiles.

Memorandum presenting an investigation in the 7- by 10-foot tunnel to determine the effect of wing-root leading-edge- and scoop-type jet-engine air-inlet configurations on the static lateral stability characteristics of a scale model of the MX-1764 airplane. The addition of the inlet configurations to the model generally had only small effects on the lateral stability.

Report presenting a summary of NACA research on afterburners for turbojet engines during the past 5 years. The references present over 1000 afterburner configurations and about 3500 hours of operation. The report covers the following topics: burner-inlet diffusers, fuel-injection systems, flameholders, combustion space, combustion instability, starting and transient performance, effects of diluents, and burner-shell cooling.

Wedge and scoop air inlet performance and thrust minus drag comparisons at free stream in supersonic wind tunnel test.

"An investigation of the aerodynamic characteristics of several hypersonic missile configurations with various canard controls for an angle-of-attack range from 0 deg to about 28 deg at sideslip angles of about 0 deg and 4 deg at a Mach number of 2.01 has been made in the Langley 4- by 4-foot supersonic pressure tunnel. The configurations tested were a body alone which had a ratio of length to diameter of 10, the body with a 10 deg flare, the body with cruciform fins of 5 deg or 15 deg apex angle, and a flare-stabilized rocket model with a modified Von Karman nose" (p. 1). Various canard surfaces for pitch control only were tested on the body with the 10 deg flare and on the body with both sets of fins. The results indicated that the addition of a flared afterbody or cruciform fins produced configurations which were longitudinally and directionally stable. The body with 5 deg fins should be capable of producing higher normal accelerations than the flared body. A l l of the canard surfaces were effective longitudinal controls which produced net positive increments of normal force and pitching moments which progressively decreased with increasing angle of attack.

Memorandum presenting a single J33 combustor and an experimental tubular combustor incorporating a fuel vaporizer as operated with gaseous hydrogen at temperatures slightly above the boiling point of the fuel. Data were obtained to explore possible effects of the fuel temperature on combustor performance and on the control and measurement of fuel flow.