The results of transonic flight measurements of the longitudinal stability characteristics of the Douglas D-558-II research airplane in the original configuration and with outboard fences mounted on the wings are presented. The levels of normal-force coefficient at which the stability decreases and pitch-up starts have been determined for both airplane configurations at Mach numbers up to about 0.94.

Report presenting an investigation of the performance of pentaborane fuel in a flight-type, 9.75-inch-diameter ramjet engine mounted in a connected-pipe altitude facility. Combustor efficiency was above 85 percent throughout the range of test conditions. Results regarding the connected-pipe performance and estimated flight performance are provided.

Memorandum presenting pressure-distribution and force data at various angles of attack of a triangular wing of aspect ratio 2 and having an NACA 0005 modified section. The wing had a plain, constant-chord, trailing-edge flap which was deflected 0 and 10 degrees. Results regarding the gross force characteristics of the wing, including lift, drag, pitching-moment, and flap hinge-moment coefficients are provided.

Report presenting a flight investigation to determine the static-pressure errors for nose-boom airspeed installations of 17 airplanes. Both research-type and service-type aircraft are covered in the investigation. Results indicated that the magnitude of static-pressure errors for the airspeed installations of all the airplanes is shown to vary with airplane geometric characteristics that include nose-boom length, fuselage diameter, and nose fineness ratio.

"An investigation was made in the Langley 300 MPH 7- by 10-foot tunnel to determine the aerodynamic characteristics of three deep-stepped planing-tail flying-boat hulls differing only in the amount of step fairing. The hulls were derived by increasing the unfaired step depth of a planing-tail hull of a previous aerodynamic investigation to a depth about 92 percent of the hull beam. Tests were also made on a transverse-stepped hull with an extended afterbody for the purpose of comparison and in order to extend and verify the results of a previous investigation" (p. 1).

As a part of this investigation, the acceleration characteristics of the engine, using the standard engine fuel-control system, were obtained for conditions simulating flight at altitudes of 35,000 and 50,000 feet with a flight Mach number of 0.4. Rapid and wave-off type accelerations were made at each flight condition, and the transient performance of the engine was recorded with a multiple-channel oscillograph. The parameters are presented graphically in the form of time histories, augmented by short segments of the oscillograph recordings, in order to more completely describe the behavior of the engine parameters when surge was encountered.

Report presenting a theoretical investigation of the lateral stability of a towed high-speed fighter plane using a fighter cruising at supersonic speed at 50,000 feet and a 1000-foot cable. The motion of this configuration was shown to have highly unstable oscillation caused by the towline restraint, but the configuration can be stabilized by choosing the right position for the towline connection and several types of automatic controls.

Report discussing an investigation to determine the drag of a configuration with a body of fitness ratio 12 with stabilizing tail surfaces and a 12-percent-thick 30-degree swept-forward wing using the free-fall method. The drag oft he wing and the total drag were measured separately and compared. The swept-forward wing was found to greatly increase the effect of drag on the body-tail combination.

Report presenting testing of several underslung scoop-type inlets mounted on a body of revolution at several Mach numbers through a range of angles of attack. Geometric differences between inlets included ramp angle, frontal area, splitter-plate height, and aspect ratio. Results regarding inlet stability, peak pressure recoveries, and total-pressure distortions are provided.

Memorandum presenting the performance of a scoop-type inlet on the bottom of a body of revolution at several Mach numbers and angles of attack. The investigation included a study of the effects of altering the approach surface ahead of the inlet, extending the boundary-layer splitter plate, and bleeding air at the throat and exit of the diffuser.

Memorandum presenting a study of the performance of a scoop-type inlet on the bottom of a body of revolution at a range of Mach numbers and angles of attack to 10 degrees. The investigation included a study of the effects of altering the approach surface ahead of the inlet, extending the boundary-layer splitter plate, and bleeding air at the throat and exit of the diffuser. Results regarding the flow survey ahead of the inlet, alternative configurations, internal-flow details of the basic configuration, air bleed at the throat, and air bypass at the engine face are provided.