Introduction: "The need for a method of acid determination which could be used for small samples and easily adapted to remote control led to the investigation of the use of electrolytically generated base for the titration of acid in certain solutions. The use of electrolytically generated base for the titration of acetic acid in the presence of nitric acid has been reported (1)."

From introduction: "The following report presents a body of information obtained in the Health Instrument Development Laboratory from September, 1948, to the present, and is intended to be a preliminary review of [the study of electrodeposition of plutonium]. Many improvements in technique and methods and investigations along lines not explored are suggested by the present work. These will be undertaken as time permits, and reported at a later time."

This report covers an investigation made to develop a gasometric determination that can determine 1.2 x 10-(-5) g. of nitrite with a precision (99% limits) of +/- 8%, and discusses how this procedure works.

This report analyzes infrared absorption measurements that were made in the regions of carbonyl band and hydroxyl band absorptions on solutions of water in hexone and water in acetone, confirming intermolecular association of water and hexone.

The following report provides data from completed tests for corrosion testing of stellite-T347 stainless steel test cylinders.

The following report describes methods used to determine tributylphosphate in a deodorized shell base. An infrared absorption method is developed to emphasize toward determination of TBP in RCW streams, the organic waste streams.

The reports aims to determine the solubility limitation of concentrations of uranium in the food preparation step of the tributyl phosphate waste metal recovery process, and the subsequent solubilities in the RA column.

A report which describes a number of experiments conducted to compare the effects of different methods of surface preparation on x-ray diffraction patterns of uranium obtained by the spectrometer technique.

Introduction: In anticipation of the design of equipment for heat transfer tests, a series of short exposure corrosion tests was initiated in an effort to determine the order of magnitude of the corrosion involved. Information was required on the effect on corrosion rates of applying a potential between two concentric tubes, the annulus between them containing condensate water.

This report follows the study of the oxidation of plutonium III and IV to the plutonyl state.

This report studies tritium oxides and tritium in water vapor, a product of P-10.

A report which discusses the data submitted for evaluation. This data is about optical densities from infrared spectrometer readings on eight standard samples, ranging in percent TBP from 6.71 to 17.85.

"The following is an alphabetical listing of terms and units in common usage at Hanford Atomic Products Operation. Other terms and definitions may be added as the need becomes apparent or as revisions or additional terms are issued by the NCRP and ICRP."

From summary: The object of the study was to determine if the heavy metal ions within the concentration ranges normally found in pile cooling water were responsible for corrosion of aluminum.

Introduction: "The problem of determining the properties and necessary controls on the TBP Plant waste disposal to eliminate transport line plugging and to permit higher concentration prior to return of this to the tank farms was studied. A report of preliminary findings was made to L. W. Finsh on January 31, 1953. This report compiles information in the aforementioned report and findings since its issuance. Previous studies related to this problem are summarized in the U. R. Technical Manual, HW-19140."

Abstract: "Laboratory production of an explosion between UNH and "red oil" under calcination conditions has been accomplished. Attempted production of a vapor phase explosion was unsuccessful below 150-160 C. Since such severe conditions are necessary to obtain an explosive reaction, it appears that present Purex plant design is adequate to avoid explosive conditions."

Introduction: "In the evaluation of pile designs it is necessary to know how the production varies with the number of tubes. It has been possible to solve the problem in terms of some general parameters whose values may be quickly computed for any specific design when the pertinent information is available."

The following report describes work carried out to investigate whether the Hanford IB column as designed in a previous report will decontaminate the uranium adequately from plutonium, particularly if there's any slowness in either the rate of reduction or transfer of the plutonium.

Measurements of k∞, f, p, and ∈ have been performed in the PCTR in support of the EGCR Program. The values listed below were obtained for the 21.875-inch cell used in the PCTR measurements. They are for a nonabsorbing (helium or vacuum) atmosphere.

A coolant line rupture during operation of a high temperature gas cooled graphite moderated reactor would present a serious hazard. The reactor would immediately depressurize and a great deal of air would be introduced into the coolant stream. As the air passed over the graphite moderator a runaway oxidation reaction would probably ensue unless an adequate safety system were available. This investigation was designed to evaluate chlorine as a reactor safeguard to be used to control a runaway reaction. Throughout this study, a small amount of chlorine in an air stream has demonstrated the ability to substantially reduce the oxidation rate of graphite. This has been the case even where the principal oxidizing agent was molecular oxygen or ozone.

A report intended to correlate the RA and RC Column uranium equilibrium data presented in the reports cited in the introduction.

This report summarizes the research and development work carried out during June, July, and August, 1959, for Budget Activity 2790- Separations Development for Non-Production Reactors. The effort on Activity 2790 - Separations Development for Non-Production Reactors. The effort on Activity 2790 will enable Hanford to begin reprocessing in January, 1962, the fuel elements from power reactors which employ depleted or slightly enriched uranium fuels.

This report summarizes experimental results obtained for the General Electric Company under terms of Design, Development and Research Contrast DDR-33. A discussion of the results, the manner in which they were obtained and their probable accuracy are included. Suggested improvements or modifications of properties of this nature be contemplated.

Fused uranium dioxide has desirable characteristics for fabricating high density nuclear fuel elements by swaging. Methods of preparing dense uranium dioxide particles being investigated at HAPO include are arc fusion, and sintering and crushing of low density powder. This paper reports the results of exploratory experiments to prepare fused uranium dioxide by induction heating of low density powder in graphite crucibles.