Serial/Series Title
Atomic Energy Commission Reports
26
Hanford Works Reports
12
AEC research and development report
9
HW (Series)
8
NACA Research Memorandums
8
North American Aviation Reports
6
NBS monograph
5
National Bureau of Standards Reports
5
Report (U.S. Atomic Energy Commission)
4
General Electric Company Atomic Power Reports
3
27 More
Country
Month
Day
59 Matching Results
Results open in a new window/tab.
Results:
1 - 24 of
59
next
The Coulometric Determination of Acid
Introduction: "The need for a method of acid determination which could be used for small samples and easily adapted to remote control led to the investigation of the use of electrolytically generated base for the titration of acid in certain solutions. The use of electrolytically generated base for the titration of acetic acid in the presence of nitric acid has been reported (1)."
Date:
March 1, 1950
Creator:
Carson, W. N. & Ko, Roy
System:
The UNT Digital Library
The Development of Plutonium Electrodeposition Methods : Interim Report
From introduction: "The following report presents a body of information obtained in the Health Instrument Development Laboratory from September, 1948, to the present, and is intended to be a preliminary review of [the study of electrodeposition of plutonium]. Many improvements in technique and methods and investigations along lines not explored are suggested by the present work. These will be undertaken as time permits, and reported at a later time."
Date:
March 1, 1950
Creator:
Schwendiman, L. C.
System:
The UNT Digital Library
Final Report: Investigation of Boiling Flow Regimes and Critical Heat Flux
From abstract: A program to investigate the mechanism of the critical heat flux condition from the standpoint of flow regimes has been initiated at Dynatech for the AEC. This report covers the work done on this investigation in the first year.
Date:
March 1, 1965
Creator:
Suo, M.; Bergles, Arthur E.; Doyle, Edward F.; Clawson, L. & Goldberg, P.
System:
The UNT Digital Library
Magnetic Properties of Insulators : Quarterly Report No. 8 Covering the Period from November 16, 1962 to February 15, 1963
The following quarterly progress report covers the period from November 16, 1962 to February 15, 1963. This report summarizes three activities that study the ratio of the maximum absorption of the K band to the maximum absorption of the F band has been made in additively colored and [gamma]-irradiated rubidium chloride.
Date:
March 1, 1963
Creator:
Markham, Jordan J.
System:
The UNT Digital Library
Conceptual Design of an Advanced Engineering Test Reactor
From abstract: This report describes a conceptual design for an Advanced Engineering Test Reactor. The reactor is a large graphite assembly penetrated by parallel Zircaloy tubes through which flow as heavy water solution of uranyl sulfate. Reactor power is 220 megawatts.
Date:
March 1, 1957
Creator:
Mallon, R. G.; Saldick, J. & Gibbons, R. E.
System:
The UNT Digital Library
Static Corrosion Behavior of Construction Materials in an Environment of Liquid Bismuth Base Metals at 550° C
Technical report presenting preliminary results obtained in the static corrosion test program to screen promising construction materials for a proposed liquid fuel power breeder reactor.
Date:
March 1, 1952
Creator:
Cordovi, M. A.
System:
The UNT Digital Library
Progress Report for the Month of February, 1952
This progress report of the Battelle Memorial Institute covers information in many categories for February, 1952. These include development of ceramic fuel elements, general ceramics, uranium and its alloys, thorium and its alloys, development of metallic fuel elements and assemblies, metals and alloys for reactor components, miscellaneous metallurgical work, liquid coolants and fuels, reactor engineering studies, and mechanism development.
Date:
March 1, 1952
Creator:
Russell, H. W.; Nelson, H. R. & Dayton, Russell W.
System:
The UNT Digital Library
Manual of Radiation Protection Standards
"The following is an alphabetical listing of terms and units in common usage at Hanford Atomic Products Operation. Other terms and definitions may be added as the need becomes apparent or as revisions or additional terms are issued by the NCRP and ICRP."
Date:
March 1, 1960
Creator:
General Electric Company
System:
The UNT Digital Library
Evaluation of Irradiated OMRE Fuel Elements First Core Loading
Abstract: Irradiated fuel elements from the Organic Moderated Reactor Experiment (OMRE) first core loading have been examined and evaluated to determine: (1) the stability of the floating plate fuel element design, (2) the stability of the stainless steel clad UO2 - stainless steel cermet core fuel plates under irradiation and exposure to the organic coolant, (3) the extent and nature of deposits on the fuel element services, and (4) the distribution of burnup in the fuel elements.
Date:
March 1, 1960
Creator:
Walter, J. H.; Leirich, J. F. & Calkins, G. D.
System:
The UNT Digital Library
Development of High-Temperature Electrical Ground Test Heaters for the SNAP 10A Program
Introduction: The development and qualification of the system acceptance test heaters and the reactor simulator heater are described in this progress report.
Date:
March 1, 1965
Creator:
Blevitt, R.; Paine, G. & Sudar, S.
System:
The UNT Digital Library
KEWB Program Quarterly Progress Report: July-September 1956
From abstract: The response of the reactor to forced oscillations has been investigated with the pile oscillator technique and the data are presently being analyzed.
Date:
March 1, 1957
Creator:
North American Aviation. Atomics International Division. Kinetic Experiments on Water Boilers Program.
System:
The UNT Digital Library
Hallam Nuclear Power Facility, Reactor Operations Analysis Program: Semiannual Progress Report Number 2, March-August 1963
From summary: The full 140 element loading of the core was completed on October 10, 1962. At this point, critical operation was begun for operator training and post-critical testing purposes.
Date:
March 1, 1964
Creator:
Darley, D. K.
System:
The UNT Digital Library
Multi-Channel Boiling Stability for Sodium Graphite Reactors
Abstract: This report presents an analysis of coolant boiling in sodium graphite reactors.
Date:
March 1, 1962
Creator:
Cappel, H. H.
System:
The UNT Digital Library
Radioactivity of the Cooling Water
The most important source of radioactivity at the exit manifold of the pile will be due to O19, formed by neutron absorption of O18. A recent measurement of Fermi and Weil permits to estimate that it will be safe to stay about 80 minutes daily close to the exit manifolds without any shield. Estimates are given for the radioactivities from other sources -- both in the neighborhood and farther away from the pile.
Date:
March 1, 1943
Creator:
Wigner, Eugene Paul, 1902-1995.
System:
The UNT Digital Library
Radiometric Analysis of Thick Samples
Introduction: Measurements of polonium content in solids are usually performed by dissolving the material and preparing a thin sample which can be measured with one of the available instruments. A measurement of the radiation emerging from the thick sample should be sufficient to evaluate the polonium content. For this reason a calculation has been performed and the results have been compared with those obtained by the thin sample method. Obviously this proposed method using thick samples would be faster.
Date:
March 1, 1944
Creator:
DeBenedetti, Sergio
System:
The UNT Digital Library
Minimum-drag ducted and pointed bodies of revolution based on linearized supersonic theory
The linearized drag integral for bodies of revolution at supersonic speeds is presented in a double-integral form which is not based on slender-body approximations but which reduces to the equal slender-body expression in the proper limit. With the aid of a suitably chosen auxiliary condition, the minimum-external-wave-drag problem is solved for a transition section connecting two semi-infinite cylinders. The projectile tip is a special case and is compared with the Von Karman projectile tip. Calculations are presented which indicate that the method of analysis gives good first-order results in the moderate supersonic range.
Date:
March 1, 1954
Creator:
Parker, Hermon M.
System:
The UNT Digital Library
Investigation of downwash and wake characteristics at a Mach number of 1.53 1: rectangular wing
The results of an experimental investigation of the downwash and wake characteristics behind a rectangular plan-form wing of aspect ratio 3.5 are presented. The airfoil section was a 5-percent-thick, symmetrical double wedge. The tests were made at a Mach number of 1.53 and a Reynolds number of 1.25 million. A comparison between experimental and theoretical values of the downwash angles is made.
Date:
March 1, 1949
Creator:
Perkins, Edward W. & Canning, Thomas N.
System:
The UNT Digital Library
Preliminary investigation of the delay of turbulent flow separation by means of wedge-shaped bodies
Report presenting an experimental investigation of pyramidal, wedge-like bodies as devices for delaying separation of a turbulent boundary layer. Within certain limits, effective boundary-layer control was obtainable with wedges of different geometry, but the drag of the wedges was high, making it desirable to keep their size to a minimum. Greater maximum lift was obtainable by placing the wedges well forward along the chord and by allowing open spaces between adjacent wedges.
Date:
March 1, 1951
Creator:
McCullough, George B.; Nitzberg, Gerald E. & Kelly, John A.
System:
The UNT Digital Library
Summary of Spin and Recovery Characteristics of 12 Models of Flying-Wing and Unconventional-Type Airplanes
Report presenting a compilation of free-spinning model results of investigations of the spin and recovery characteristics of 12 flying-wing and unconventional-type designs. Dimensional data, mass data, and three-view drawings of the models that correspond to each of the 12 airplane designs are provided. Results regarding erect spins, inverted spins, and spin-recovery parachutes are also provided.
Date:
March 1, 1951
Creator:
Stone, Ralph W., Jr. & Hultz, Burton E.
System:
The UNT Digital Library
Low-speed wind-tunnel investigation of leading-edge porous suction on a 4-percent-thick 60 degree delta wing
Report presenting testing of a 60-degree delta-wing-fuselage model with a 4-percent-thick airfoil section with large leading-edge radius in the 19-foot pressure tunnel to determine the effectiveness of porous-leading-edge suction in delaying and reducing the leading-edge separation and accompanying high drag. Results regarding the delta wing, including pump power, lift, pitching moment, pressure distributions, the clipped wing, and some comments on the application of leading-edge suction to delta wings are provided.
Date:
March 1, 1955
Creator:
Yates, E. Carson, Jr.
System:
The UNT Digital Library
Analysis of spanwise temperature distribution in three types of air-cooled turbine blade
From Summary: An approximate method for determining the allowable stress-limited blade-temperature distribution is included, with brief accounts of a method for determining the maximum allowable effective gas temperatures and the cooling-air requirements. Numerical examples that illustrate the use of the various temperature-distribution equations and of the nondimensional charts are also included.
Date:
March 1, 1950
Creator:
Livingood, John N. B. & Brown, W. Byron
System:
The UNT Digital Library
Characteristics of loads in rough air at transonic speeds of rocket-powered models of a canard and a conventional-tail configuration
Report presenting results from flight tests at transonic speeds for a canard and a conventional-tail rocket-powered model in continuous rough air. The use of an airspeed-fluctuation instrument for measuring the turbulence intensity experienced is described as well as the resulting improvement in the technique of testing rocket models in rough air. The short-period frequency was dominant in the center-of-gravity normal-acceleration response for both models.
Date:
March 1, 1955
Creator:
Vitale, A. James
System:
The UNT Digital Library
Model investigation of the effect of mounting hydro-skis on shock absorbers
Report presenting a rough-water landing investigation of a model of a hydro-ski seaplane design to determine the effect on the landing motions and vertical accelerations of mounting the hydro-ski on shock-absorber struts. The tests occurred at one landing trim and wave height over a range of wave length for three hydro-ski configurations. Results regarding the landings, effect of artificial stabilization, damping in trim, and reductions in vertical accelerations are provided.
Date:
March 1, 1955
Creator:
Hoffman, Edward L. & Fisher, Lloyd J.
System:
The UNT Digital Library
The Hydrodynamic Force Characteristics of Streamline Bodies of Revolution Having Fineness Ratios of 6, 9, and 12 With and Without Chine Strips
Report presenting hydrodynamic force characteristic for three streamline bodies of revolution equipped with chine strips and with fineness ratios of 6, 9, and 12. Testing was also performed on the bodies with the chine strips removed and with the tail cones removed. Hydrodynamic resistance, pitching moment, wetted length, and height of the model above the water surface for a range of trim, load, and speed are provided.
Date:
March 1, 1955
Creator:
Weinflash, Bernard & Fontana, Rudolph E.
System:
The UNT Digital Library