Expressions are presented for the electric and magnetic fields due to a pulse of charge, which may be oscillating transversely while moving down an infinitely long highly conducting pipe of circular cross section. The expressions are evaluated at large distances from the pulse and the fields are shown to decrease algebraically in the distance behind the pulse. In the absence of transverse oscillations the longitudinal electric field varies as the inverse three-halves power of the distance; in the presence of oscillations the dominant field component is the transverse magnetic field, which decreases as the inverse one-half power. In the long-range limit the amplitude of the fields is proportional to the square root of the wall resistivity. The phase of the field associated with the oscillating pulse is shown to be the phase of the pulse at the time when it passed the point of observation.

None

None

The Lawrence Livermore Laboratory undertook an investigation of the properties of ferrite materials to be used in a 5-MeV, 50-ns linear induction accelerator. The investigation, on a part-time basis, lasted about one year and had the cooperation and helpful suggestions of several manufacturers: TDK of Japan, Phillips of Holland, and Stackpole of the U.S.A. Ferrites have been widely used as tuning cavities for proton synchrotron accelerators at radio frequencies. In such an application, the ..mu..Qf factor is used in describing the figure of merit for ferrites where a high duty factor requires low loss ferrites. In a linear induction accelerator with an average reprate of 5-Hz, the ferrite losses are negligible and the concept of complex permeability in describing the losses will not be introduced, but a large signal ..delta..B/..delta..H will be used to describe their properties. The properties of interest in designing the accelerating cavity were (1) flux swing ..delta..B = B/sub r/ + B/sub m/ greater than 0.5T; (2) a residual flux density B/sub r/ greater than or = to 0.15T with a reset no greater than 2 Oer; (3) a relatively high incremental ..mu.. greater than 400 to keep the excitation current small in relation to the …

To view and align Shiva laser targets, two new telemicroscopic instruments integral with TV camera and HeNe laser illuminator have been designed. The common requirement of both instruments is the capability of imaging two objects of different sizes on a TV screen: the large surrogate target (5 mm diameter) and the laser fusion target (0.250 mm diameter) with the same resolution (better than 7 ..mu..m). Both instruments have an optical relay which images the targets on a fixed reference reticle; the object is to center each target on the reticle. One of the instruments reimages the reticle plane onto the TV dectector using a zoom arrangement. This instrument translates the TV camera-zoom assembly in three axes and is thereby capable of exploring an object-space volume of 1 cm/sup 3/. In the other instrument, the reticle plane is reimaged by a zoom lens and this enlarged image is relayed to the TV detector by a cluster of five lenses. Four lateral lenses image the periphery of the surrogate target and the reticle for coincidence. The central objective images the center of the reticle and the fusion target when it is centered.

The resources and talents of many national and international organizations and laboratories, both governmental and industrial, are being used to establish analysis methods for predicting the embritlement condition of light water reactor (LWR) primary systems.. The exact interrelationships and responsibilites between those developing, uderstanding, combining, and apply state-of-the-art technology in dosimetry, metallurgy, and fracture mechanics for reactor systems analysis are being carefully reviewed and studied. This has resulted in a more comprehensive definition of the scope of new and updated ASTM standards required for the analysis and interpretation of LWR pressure vessel survillance results. Fifteen new and updated ASTM standards have now been identified, together with a restructuring of the main interfaces between the individual standard practices, guides, and methods. This paper briefly discusses these standards and the initial results of multi-laboratory research work involved in their validation and calibration.

This report discusses a computer automated stage and Scanning Electron Microscopy (SEM) system for detecting defects in glass spheres for inertial confinement laser fusion experiments. This system detects submicron defects and permits inclusion of acceptable spheres in targets after examination. The stage used to examine and manipulate the spheres through 4..pi.. steradians is described. Primary image recording is made on a roster scanning video disc. The need for SEM stability and methods of achieving it are discussed.

Information is presented concerning assessments of current seismic design methods; systematic evaluation program for older operating reactors; seismic vulnerability of fuel reprocessing facilities; and advisability of seismic scram.

A nonlinear, multivariable, blanket optimization technique is applied to the Cascade inertial confinement fusion reactor concept. The thickness of a two-zone blanket, which consists of a BeO multiplier region followed by a LiAlO/sub 2/ breeding region, is minimized subject to constraints on the tritium breeding ratio, neutron leakage, and heat generation rate in Al/SiC tendons that support the chamber wall.

Parametric studies were carried out for a heavy ion beam (HIB) fusion electric power plant to investigate the effects on the cost of electricity (COE) of variations in several design parameters. In particular, we examined the effects of maximum achievable chamber pulse rate, driver cost, target gain, electric conversion efficiency, and net electric power. We find that with a combination of improvements over our base case, HIB fusion can be economically competitive with other future power sources.

The conceptual design of an ICF tritium production reactor is described. The chamber design uses a beryllium multiplier and a liquid lithium breeder to achieve a tritium breeding ratio of 2.08. The annual net tritium production of this 532 MW/sub t/ plant is 16.9 kg, and the estimated cost of tritium is $8100/g.

Newspaper article from The Galveston Daily News detailing history and information about Harvey Houses as well as Harvey girls, including an interview with Madge Saenz.

More than a decade ago individuals from three significant institutions in East Bay Area began discussions in response to the apprehensions that were so deep in the early 1980s. These apprehensions were a result of the intense rhetoric between the two superpowers and the casual commentary about ``limited nuclear war.`` The discussions spoke to the mortal danger as well as to the profound moral question revolving around nuclear arms. The issuance of the US Bishops` Pastoral on War and Peace in 1983 gave the group focus and momentum. The Chancellor at the University of California at Berkeley, the President of the Graduate Theological Union (the consortium of theological schools in Berkeley), and the Director of the Lawrence Livermore National Laboratory (one of the chief designers of American nuclear arms) encouraged us to complete plans for a symposium. It was an era of activism. We chose, however, to serve the theme expressed by Albert Einstein, ``Peace cannot be kept by force, it can only be achieved by understanding.`` After a decade, all of us can commend the leadership of the three institutions and the individuals involved for their perseverance. Their commitments to the pursuit of peace and to the development of …

The performance of the Ni/NiCl{sub 2} positive electrode for the Na/NiCl{sub 2} battery has been significantly improved compared to that of our earlier electrodes, representative for 1990. This improvement has been achieved by lowering the impedance and increasing the usable capacity through the use of chemical additives and a tailored electrode morphology. The improved electrode has excellent performance even at 250{degrees}C and can be recharged within one hour. The performance of this new electrode was measured by the conventional interrupted galvanostatic method and under simulated driving profiles. These measurements were used to project the performance of 40- to 60-kWh batteries built with this new electrode combined with the already highly developed sodium/{beta}{double_prime}-alumina negative electrode. These calculated results yielded a specific power of 150--400 W/kg and a specific energy of 110--200 Wh/kg for batteries with single-tube and bipolar cell designs. This high performance, along with the high cell voltage, mid-temperature operation, fast recharge capability, and short-circuited failure mode of the electrode couple, makes the Na/NiCl{sub 2} battery attractive for electric vehicle applications.

Article discussing auditory cortex neurons and primary culture and ion channel activity in rat.

Image-converter (IC) camera photography has provided spectacular images and quantitative records of liner collapse and early jet formation in shaped charges. We have extended the application of the IC camera to observations of shaped charge jet surfaces undergoing particulation. Sequential, high-resolution photographs were taken following the same 10-cm portion of jet at 2.5-{mu}s intervals. Simultaneous color rotating-mirror framing camera photographs and 450-keV flash x-ray radiographs were also taken of the same region. This combination provides a detailed record of the evolution of surface structure during jet necking and particulation. In the high-resolution photographs, individual features on the jet surfaces as small as {approximately}100 {mu}m can easily be detected and followed as they evolve over time. The jet surface structure is rough with overlapping slip dislocation lines running along the surface at 45{degree} to either side of the jet axis. This is similar to the texture that develops in long rods undergoing static tension. We discuss the implications of these images for increasing jet particulation times.

In 1997 NASA will launch the Cassini scientific probe to the planet Saturn. Electric power for this probe will be provided by Radioisotope Thermoelectric Generators thermally driven by General Purpose Heat Source modules.

The Idaho National Engineering Laboratory (INEL) has been involved in nuclear reactor research and development for over 40 years. One of the earliest major projects involved the development of a nuclear powered aircraft engine, a long-term venture which used mercury as a shielding medium. Over the course of several years, a significant amount of mercury was spilled along the railroad tracks where the test engines were transported and stored. In addition, experiments with volume reduction of waste through a calcine process employing mercury as a catalyst resulted in mercury contaminated calcine waste. Both the calcine and Test Area North wastes have been identified in Department of Energy Action Memorandums to be retorted, thereby separating the mercury from the various contaminated media. Lockheed Idaho Technologies Company awarded the Mercury Retort contract to ETAS Corporation and assigned Parsons Engineering Science, Inc. to manage the treatment field activities. The mercury retort process entails a mobile unit which consists of four trailer-mounted subsystems requiring electricity, propane, and a water supply. This mobile system demonstrates an effective strategy for retorting waste and generating minimal secondary waste.

The Idaho National Engineering Laboratory (INEL), formerly the National Reactor Testing Station (NRTS), encompasses 890 square miles and is located in southeast Idaho. In 1949, the United States Atomic Energy Commission, now the Department of Energy (DOE), established the NRTS as a site for the building and testing of nuclear facilities. Wastes generated during the building and testing of these nuclear facilities were disposed within the boundaries of the site. These mixed wastes, containing radionuclides and hazardous materials, were often stored in underground tanks for future disposal. The INEL has 11 buried mixed waste storage tanks regulated under the Comprehensive Environmental Response, Compensation and Liability Act (CERCLA) ranging in size from 400 to 50,000 gallons. These tanks are constructed of either stainless or carbon steel and are located at 3 distinct geographic locations across the INEL. These tanks have been grouped based on their similarities in an effort to save money and decrease the time required to complete the necessary remediation. Environmental Restoration and Technology Development personnel are teaming in an effort to address the remediation problem systematically.

None

Encyclopedia article on "exile literature," a collective term that describes all literature produced by writers during a period of voluntary or forced exile from their homeland.

Encyclopedia article on literature produced in the German Democratic Republic (GDR), the eastern, socialist part of divided German from 1949-1990.

Encyclopedia article on literary themes in texts that focus on the sexual change (from man to woman or from woman to man) of a main character.

An in vivo study of vascular welding with a fiber-delivered argon laser was conducted using a canine model. Longitudinal arteriotomies and venotomies were treated on femoral vein and artery. Laser energy was delivered to the vessel wall via a 400 {micro}m optical fiber. The surface temperature at the center of the laser spot was monitored in real time using a hollow glass optical fiber-based two-color infrared thermometer. The surface temperature was limited by either a room-temperature saline drip or direct feedback control of the laser using a mechanical shutter to alternately pass and block the laser. Acute patency was evaluated either visually (leak/no leak) or by in vivo burst pressure measurements. Biochemical assays were performed to investigate the possible laser-induced formation or destruction of enzymatically mediated covalent crosslinks between collagen molecules. Viable welds were created both with and without the use of feedback control. Tissues maintained at 50 C using feedback control had an elevated crosslink count compared to controls, while those irradiated without feedback control experienced a decrease. Differences between the volumetric heating associated with open and closed loop protocols may account for the different effects on collagen crosslinks. Covalent mechanisms may play a role in argon laser vascular …