This report discusses a nuclear spectroscopic study of the radiations resulting from the electron capture decay of Ta-176, Ta-177, and Ta-178, analyzing data of nuclear decay schemes.

Abstract: "Indium was bombarded with protons in the energy range 2 to 6 Bev. Cross sections are reported for the (p,px+), (p,pn), and (p,p') reactions, as well as those for the formation of Be-7 and several neutron deficient isotopes of cadmium and indium. It was found that the (p,pn) yield increases slowly in the energy range 2 to 6 Bev, while the (p,px+) and (p,p') yields are approximately constant. The variation of the (p,pn) and (p,px+) yields with target thickness is discussed. The yields of several isomeric levels are correlated with their nuclear spin."

"In the past ten years quantities of alpha-, beta-, gamma- and neutron-emitting isotopes handled in enclosures have increased from microcuries to kilocuries. Contaminated-atmosphere problems have increased accordingly. Developments at Berkeley are reviewed with particular emphasis on recent equipment, viz: a multiple-purpose gas scrubber and a total-capture system for slug-dissolver off gas."

Abstract: "The analysis of an immobilized plasma is here extended to the case where the geometry is cylindrical rather than Cartesian. (This report, UCRL-4439 (Rev, 4 constitutes Part II of the report series (UCRL-4466, Parts I, III, and IV) dealing with this general problem.)"

Introduction: "In connection with conducting neutron experiments in a pit with earth and concrete walls, it was proposed that the background flux of neutrons might be reduced by lining the walls of the pit with a neutron absorber such as boron. To determine how much liner material would be desirable and what diminution in the neutron background could be expected, the following measurements were undertaken."

Abstract: Experimentally measured promp-neutron decay constants for sub-critical systems are of considerable value as normalization data for calculations of prompt-neutron time constants. A method of measuring these decay constants with a pulsed neutron source, neutron detector and multi-channel time-delay analyzer has been developed and used on a number of fast-spectrum subcritical systems. An analysis of this method based on the one-energy group, one-delayed-neutron group reactor kinetic equations is presented and discussed. The curve of neutron flux versus time predicted by the kinetic equations is compared with the observed curve obtained with a 13.1-cm. diam. enriched-uranium sphere to indicate the application and limitations of the analysis.

Report discussing the torus model of elementary particles such as the electron and proton. Figures illustrating a simple torus model as well as a more complex version of the model are presented.

Introduction: A proposal for using an energetic neutral deuteron beam for injection into a mirror machine has been made by Eugene Lauer. This report describes an experimental attempt to produce a large neutral deuteron beam. The beam from the NTA ion source was passed through a target of hydrogen gas where the charge exchange mechanics produced a beam of energetic neutral deuterium atoms.

This report discusses methods of high energy plasma. It elaborates on these methods and their use of high energy particles.

The following report describes the process of epoxy resin casting of high-voltage transformers, bushings, and potheads.

The following report describes the investigations of the microwave solution and the Astron solution, to produce high current electron beams.

The following report describes the injection and trapping of high current electron beams in order to construct an electron gun and the first 2 Mev section of the accelerator.

Report discussing part of a study that aims to understand plasma stability and confinement in mirror geometries.

The report summarizes results obtained since September, 1951, by total neutron yield experiments using 190 Mev deuterons and the MnSo4 tank method (UCRL-1375 and UCRL-1480). A new method of beam monitoring has resulted in establishing firmly the absolute yield for solid uranium and thorium primary targets backed by a solid uranium secondary. The beam monitoring was done by using a primary target built into a faraday cup. This method circumvents errors caused by recombination in the ionization chambers used previously.

From preface: The following bibliography on high pressure-high temperature, and high pressure, is the result of an investigation into the equipment and experimental technique needed to increase the density of powdered compounds, especially those compounds which possess a high vapor pressure of hydrogen at moderate temperature and pressure.

The following report describes the Astron Thermonuclear Program initiated at Livermore, California in 1957.

"The injection of the E-layer electrons into the Astron reactor is described by following the electrons as they emerge from the anode of the 1-Mev electron gun through the various steps up to their injection in the reactor volume. Several problems are imposed by this injection process and their solutions are discussed briefly. The detailed mathematical theory and calculations will be presented in a separate paper now in preparation."

This report focuses on the study of the stabilized pinch program made to increase the plasma temperature and improve the plasma conductivity and containment. One method proposed is the usage of a large toroidal stabilized pinch, which is described here.

This report discusses the problem of obtaining thermonuclear temperatures as part of reaching a controlled fusion reaction for fusion power. Tables covering radiation losses and thermonuclear reaction rates are included. Talk before JCAEC in Washington, D. C.

This is parta bibliography containing documents on gaseous thermal diffusion. The open literature provided are dated between the years 1940 to 1957.

The following report describes test experiments with an inexpensive practical phaseplate and to present in greater detail the theory of its operation in a schlieren optical system.

Introduction. With the development of fission and subsequently of thermonuclear explosives, a very large source of cheap energy has become available. The problem of using this energy for peaceful purposes safely and economically presents itself as one of the most interesting and important of our time. In explosions the energy is released very suddenly. Conversion of this sudden release of energy at extremely high temperature and pressure into the form of useful work, either mechanical or chemical or thermal, must be accomplished in order for such explosions to have nonmilitary uses. The technical feasibility of such conversions in a number of different instances will be described in this article. At the same time one must be able to control nuisance effects. Examples of these are seismic effects, the blast and heat which at least in the atmosphere always accompany such explosions, and the problem of radioactivity. Even given the technical feasibility of these accomplishments, which in some cases seems quite clear from what is known already, one must prove economic feasibility. That is to say, one must show that the cost of certain nonmilitary undertakings will be considerably less by the use of nuclear explosions than by conventional methods.

Abstract. The preparation and properties of a new explosive, liquid over the range -65 degrees F to +165 degrees F, are presented. This explosive, called NTN, is a 5/1/1 mole ration of nitromethane, tetranitromethane, 1 -nitropropane. The sensitivity and stability of NTN meet military requirements.

Quarterly summary report of studies conducted through the Radiation Laboratory, University of California. Some results reported in the report may be of a preliminary or incomplete nature.