Report presenting the results of flight investigations showing that a beveled trailing-edge aileron gives as low or a lower profile drag than a contour aileron. Section profile drag and lift coefficients with two different types of ailerons were obtained at 3 different Reynolds numbers.

Wing pressure distribution diagrams for several angles of attack and flap deflections of 0 degrees, 20 degrees, and 40 degrees are presented. The normal force coefficients agree with lift coefficients obtained in previous test of the same model, except for the maximum lifts with flap deflection. Pressure distribution measurements were made at Reynolds Number of about 6,000,000.

Report presenting pressure distribution measurements on two 24-inch chord models equipped with Fowler flaps in the two-dimensional low-turbulence pressure tunnel. Results regarding pressure-distribution diagrams and normal-force and moment coefficients are provided.

"The knock-limited performance of blends of 0,50; and 100 percent by volume of 2,2,3-trimethylpentane in 28-R fuel determined with a modified F-4 engine at three sets of conditions varying from severe to mild at each of three compression ratios (6.0, 8.0, and 10.0). A comparison of the knock-limited performance of 2,2,3-trimethylpentane with that of triptane (2,2,3-trimethylbutane) is included. The knock-Limited performance of 2,2,3-trimethylpontane was usually more sensitive to either compression ratio or inlet-air temperature than 28-R fuel, but the ratio of the knock-limited indicated mean effective pressure of a given blend containing 2,2,3-trimethypentane and 28-R to the indicated mean effective pressure of 28-R alone was not greatly affected by compression ratio if the engine operating conditions were mild" (p. 1).

Report presenting a investigation covering the physical and chemical properties of various ethers as components of aviation fuels. Their antiknock effectiveness and methods of preparation and purification are included. Methyl tert-butyl ether gave the best knock-limited rich mixture response, but isopropyl tert-butyl ether and di-tert-butyl ether gave better results at lean mixtures.

Report presenting results from a series of flight tests of the maximum speed and cooling characteristics in full-throttle level flight of the XP-42 airplane equipped with a short-nose high-inlet velocity cowling. The results of the tests indicated a maximum speed of 336 miles per hour at 960 horsepower at 25,000 feet. Results regarding maximum speed and pressure and temperatures are provided.

Report presenting tests of airplane models that included investigations to determine the longitudinal stability and control, effects of various constituent parts or their modification on longitudinal stability and control, critical speed, and distribution of wing load. Some of the changes made in attempts to improve longitudinal control and to increase critical speed included auxiliary control flaps on the lower surface of the wing, revision of the windshield, increase in dimensions of outboard nacelles, and alteration in profile of wing leading edge.

Report presenting tests made in order to determine the differences in high-speed aerodynamic characteristics between models of a four-engine transport airplane and a similar bomber airplane. The main conclusion found is that the critical Mach number of the transport model is about 0.05 less than that of the bomber model.

Report providing charts to assist with estimating F-3 and F-4 knock-limited performance ratings for several ternary and quaternary fuel blends. Several unusual behaviors were noted in the F-3 engines using the aromatic-paraffinic blends, so the charts for them may not be as accurate. General trends observed in different types of fuel are also described.

"The effect on the propulsive efficiency of locking or windmilling one propeller of a six-blade dual-rotating propeller installation was determined in the Langley propeller-research tunnel. Tests were made of both pusher and tractor configurations, with the unpowered propeller both leading and following the powered propeller, which was set at a blade angle of 40 degrees. The maximum propulsive efficiency of the powered propeller in combination with the locked or windmilling propeller was, in all cases, lower than that of the powered propeller operating alone" (p. 1).

Report presenting an exact solution and a closely concurring approximate energy solution for the buckling of an infinitely long flat plate under combined shear and transverse direct stress with edges elastically restrained against rotation. An appreciable fraction of the critical stress in pure shear may be applied to the plate without any reduction in the transverse compressive stress necessary to produce buckling.

Report presenting determinations of boundary-layer transition on the NACA 0012 and 23012 airfoils in the high-speed wind tunnel over a range of Reynolds numbers. For all of the lift coefficients that testing occurred at, transition occurred in the region of estimated laminar separation at low Reynolds numbers and approached the point of minimum static pressure as a forward limit at high Reynolds numbers.

Report presenting power-off wind tunnel tests of a scale model of a twin-engine cargo airplane equipped with amphibious floats. Longitudinal and lateral stability and control characteristics were investigated for three flap positions.

Report presenting stability testing of two dynamic models in tank no. 1 in order to investigate the effects of adding a small projection, or hook, on the planing bottom of the forebody near the step of a seaplane. Tests with two different projections had a rather large effect on all of the trim limits and the landing stability.

Report presenting testing in the full-scale tunnel to provide data for estimating the longitudinal stability and control characteristics of the Curtis XP-55 airplane. Testing included lift, drag, pitching-moment, hinge-moment, and elevator pressure measurements for various combinations of angle of attack, elevator deflection, and elevator tab settings. The results of the force tests and some correlation of the results of the force tests and the pressure measurements are presented in the report.

Report discussing an investigation into several types and sizes of flaps and spoilers located forward of the elevators on the upper surface of the horizontal stabilizer of a model of a radial-engine pursuit airplane. Information about the elevator characteristics, elevator-fixed and elevator-free balance lift coefficient, and trim drag coefficient for a range of Mach numbers is provided.

Report presenting a determination of the mean effective emissivity as a function of temperature for the surfaces of several metals and insulating materials. A description and discussion of the measuring technique is presented. The results are plotted on a variety of graphs.

Report presenting testing in the two-dimensional low-turbulence pressure tunnel and the two-dimensional low-turbulence tunnel of two models made by the Consolidated Aircraft Corporation, one of the outboard section and one of the inboard section.

Report presenting knock-limited small-scale-engine tests of isopropyl-benzene, benzene, and o-xylene blended individually in various concentrations with selected base fuels. Data were obtained to determine the blending sensitivity, lead susceptibility, and sensitivity of the blends to inlet-air temperatures. Isopropylbenzene was found to be the most effective overall.

Supplement using data from a previous report to show the cargo that can be carried at various ranges, pounds of cargo that can be carried per pound of fuel, and other graphs to simplify the problem of determining which cargo can be carried at any range. The assumptions, parameters, and equations from the original report are carried over in the supplement.

Report discussing tests of the drag clean-up and stability of the Bell YP-59A jet-propelled airplane. The general stability, static stability, and control characteristics were examined. Specific details are also included about the effects of the exhaust jet on air flow at the tail.

Report presenting tests of the Northrop MX-334 airplane in the full-scale tunnel. The results are of particular interest since the MX-334 is an all-wing glider-type airplane without a conventional fuselage or vertical surfaces. The primary purpose was to obtain sufficient data with which to determine the longitudinal and lateral stability and control characteristics of the airplane.

Report discusses a method of correlating engine-cooling data and its application to a representative engine-cooling test. Considerations for the correlation method are given, but the application to specific engine-cooling problems should be simple and direct. Information about experimental procedure and an example with specific values are included.

Report presenting an investigation in the two-dimensional low-turbulence tunnels for the purpose of developing an optimum flap configuration for maximum lift on an airfoil section for the Republic XF-12 airplane equipped with a double slotted flap. Lift and flap loads were obtained at several flap deflections for two flap paths. Results regarding lift, drag, and flap loads are provided.