Equilibrium krypton and xenon adsorption isotherms were obtained for four varieties of charcoal and for Linde Molecular Sieves Types 4A and 5A, generally at 0, 25, and 60°c. Such data are of interest in connection with design and evaluation of adsorbers for radioactive noble gas fission products. The isotherms were fitted, by linear regression analysis, to straight-line forms of the Freundlich and Langmuir equations. The Freundlich linear equation gave the better fit and the parameters of this equation are presented for each of the isotherms. Also presented are the constants for an equation representing the temperature dependence of arbitrary adsorption coefficients, the coefficients having been calculated from the Freundlich isotherm parameters. Some aspects of the applicability and accuracy of these results are discussed.

A proposed modification to the experiment off-gas system for the EGCR-LITR Capsule Experiment is evaluated by comparing the atmospheric radiation doses to laboratory personnel that could result in the event of an experiment failure while utilizing the present off-gas system to those doses that would result if various modifications to the existing system were effected. The modifications considered include the addition of an iodine vapor adsorber and a krypton-xenon adsorber. The addition of an iodine vapor adsorber to the off-gas system, which presently includes an absolute filter, reduces the atmospheric dose to the thyroid from 510 mr to 1.4mr. The total body dose is also reduced from 2.2 to 1.3 mr. The total body dose can be further reduced to 0.7 mr if a large krypton-xenon adsorber is included. Basd upon these calculated atmospheric radiation doses it is concluded that the addition of an activated charcoal iodine vapor adsorber will reduce the atmospheric hazard to an acceptable level.

A short-term study was made to investigate the removal of radioiodine vapor from air-steam mixtures as could occur immediately following a nuclear incident in a pressurized water reactor. Activated charcoal traps, designed to simulate a small section of a commercial charcoal canister, were tested at gas velocities of 23.9 to 74.9 ft/min over the temperature range of 75 to 118°C. The iodine removal efficiency was found to range from 99.80 to 99.4% with an average of 99.9%. One test performed at a temperature of 105°C and with gas velocity of 290 ft/min indicated that the iodine removal efficiency was reduced to 99.54%. Activated charcoal exhibits a high efficiency for iodine vapor removal under these test conditions and appears suitable for application in the decontamination of air-steam mixtures.

This report supersedes ORNL CF-57-2-1, which was an extension and revision of ORNL CF-54-6-72. Details concerning a recommended system of flow-plan symbols and drawing are given. The system is designed to identify the function of all major instrument components and to show schematically the operation of the instrument relative to the particular process. The system is used for identification and designation. The system is a modification of the Instrument Society of American Recommended Practice (RP 5.1).

The performances of aqueous-homogeneous (AHBR), molten-salt (MSBR), liquid-bismuth (LBBR), gas cooled graphite-moderated (GGBR), and deuterium-moderated gas-cooled (DGBR) breeder reactors were evaluated in respect to fuel yield, fuel cycle costs, and development status. A net electrical plant capability of 1000 Mwe was selected, and the fuel and fertile streams were processed continuously on-site.

The performances of aqueous-homogeneous (AHBR), molten-salt (MSBR), liquid-bismuth (LBBR), gas-cooled graphite-moderated (GCBR), and deuterium-moderated gas-cooled (DGBR) breeder reactors were evaluated in respect to fuel yield, fuel cycle costs, and development status. A net electrical plant capability of 1000 Mwe was selected, and the fuel and fertile streams were processed continuously on-site.

Oscillations have been observed in a magnetically supported cylindrical rod of plasma. This rod of plasma can be the discharge occurring in the defining aperture of a Mode II, pressure gradient arc. Similar oscillations can also occur in the column of a Mode I arc. These oscillations appear to be the mechanism that drives the Mode II blowup phenomena.

A program has been coded for the ORACLE which will solve, using Monte Carlo technique, the transport problem for monodirectional, monoenergetic gamma radiation incident at an angle Θ, upon an infinite laminated slab of finite thickness. Each of the laminations (or regions) is itself an infinite, homogeneous slab of finite thickness. The code is designed to give estimates of energy deposition, energy flux, tissue dose rate, reflected and transmitted energy current, and the angular and energy distribution of the reflected and transmitted energy current. All the answers except for energy deposition and reflected and transmitted energy current are optional.

The thermal-neutron flux prevailing near the upper hole in the HRE-2 core wall was determined from measurements of the induced activity in a specimen cut from the edge of the hole. The specimen was removed following run 21 and was thus exposed to reactor neutrons during runs 13, 14, 16,17, 18. 19, 20, and 21. The neutron flux, calculated for an average core power level of 2 Mw, was 2.8 x10^13 neutrons/cm^2 sec. the core wall area from which the specimen was removed was located approximately 16-in. from the core center.

Results of the examinations of corrosion specimens exposed in the HRT are presented. Specimens examined included (1) core screen samples, (2) core specimen array No. 1, (3) blanket specimen array No. 2, (4) core solution line specimen arrays No. 103 and 103A, (5) blanket solution line specimen array No. 203. Complete information is still not available on all the specimens removed from the reactor, however, those data which have been accumulated are presented. These include corrosion rates, computed from specimen weight-changes, and results of chemical analyses of scales removed from the specimens or specimen holders. Also included in the report is a summary of the HRT operating schedule during exposure of the specimen and of the status of examinations for those specimens removed from the reactor prior to run 20.

A stimulation study of the deign as of June 1960 of the gas-cooled ORR Loop No. 1 was made using the ORNL analog computer. The proposed method of temperature control is evaluated, and the dynamic behavior of the loop for accidents and component failures is presented in graphical form.

The ORNL analog computer was used to simulate four widely different experiment conditions in the small EGCR in-pile loops. Various control and safety systems were evaluated in each case. Curves are included which show the response to postulated accidents and component failures. The results indicate that one standard control and safety system will probably be adequate for a wide variety of test conditions.

This manual represents the recommendations of the Instrumentation and Controls Division committee on Electrical and Electronic Symbols and Drawing that have been issued to date. Section I consists of copies of the American Standards Association Graphical Symbols for Electrical Diagrams, with certain variations or additions that have been recommended by the Committee to clarify or more positively identify the device or element symbolized. Since publication of the present ASA standards, certain elements, such as the transistor, have come into common use. Committee and represent the symbols have been selected after considerable study by the Committee and represent the symbols that seem to be standard Reference Information series, Interim E--1.

This manual represents the recommendations of the Instrumentation and Controls Division committee on Electrical and Electronic Symbols and Drawing that have been issued to date, and supersedes the previously issued ORNL Electrical Symbols List and CF-58-12-141, Electrical and Electronic Drawing Standards for Wiring and Device Coding and Applications.

On 3/14/60 the Applied Physics Corporation was awarded a subcontract for the design and development of a high-temperature high-pressure spectrophotometer system based on the Cary Model 14pm Spectrophotometer insofar as possible, and consistent with our specifications, No. CTD-2, December 16, 1959.

This semiannual progress report and future reports will be published as two documents to permit a wider distribution of the unclassified material. The report numbers are assigned in sequence so that the two reports will fall together when filed by report number.

Test work was completed on development of a stripping method for the amine extraction (Amex) process which produces a concentrated uranyl nitrate solution for shipment to the refinery. This procedure offers potential cost savings by simplifying the overall mill-refinery flowsheet. The process involves treatment of the amine extract with calcium nitrate solution to convert the uranium in the solvent to a nitrate complex, stripping the uranium with water or dilute nitric acid, and recovery of nitrate from the solvent for recycle by contact with a lime slurry.

Studies are being made on the recovery of thorium (and uranium) from granitic rock, since this source represents a very large potential thorium reserve for the nuclear power industry. In preliminary leaching studies on 16 granite samples (containing 8-95 ppm thorium and 1.5-16 ppm uranium), maximum recoveries of thorium and uranium ranged 30-85% and 15-65% respectively, and sulfuric acid consumption was high (30-120 lbs H2SO4 per ton of granite). A relatively high acidity was needed to obtain rapid and efficient dissolution of the soluble thorium fraction. The cost of treating granite was estimated at $3.50-5.20 per ton, variations within this range being dependent primarily on differences in acid consumption for different granites. Estimated costs per pound of thorium plus uranium recovered ranged $30-500.

A chemical flowsheet is proposed for recovery of strontium and rare earths from Purex wastes. The iron in the waste is first complexed with tartrate and the pH is adjusted with caustic. Strontium and rare earths are extracted by a solvent comprised of di(2-ethylhexyl)phosphoric--sodium di (2-ethylhexyl) phosphate--tributyl phosphate -- Amsco 125-82. and are stripped with nitric acid. Processing the strip product through additional solvent extraction cycles yields isolated, concentrated strontium and rare earth fractions.

This report describes the preprocessing stage to be added to the present ORACLE-Algol translator which will enable it to translate programs containing procedures. The Algol 60 procedure is an extremely flexible tool, and its full implementation presents a number of difficulties. Since it is undesirable to undertake major revisions of the existing parts of the translator and impossible to solve all of these difficulties in a processing stage, it was necessary to impose certain restrictions on the use of procedures. The result, however, retains the more basic features of the Algol 60 procedure concept. Most of the algorithms published in the Communications of the Association for Computing Machinery can be handled by the preprocessor with few minor or no changes.

In the Communications of the ACM of April, 1960, p. 240, there appeared two Algol algorithms for the computation of In, the modified Bessel function of the first kind. One of these algorithms uses a convergent series and the other an asymptotic series. Their author, Dorothea S. Clarke, did not give any information with regard to which algorithm is more appropriate in a given situation (a given situation meaning the computation of In (x) for a definite pair of numbers n and x). Such information is necessary, however, if the algorithms are to be useful, particularly since the asymptotic series is in many cases not valid.

The absorption in lead of Bremsstrahlung X radiation from a Sr^90 TiO3 pellet in the proximity of Hastelloy "C" was measured. The tenth value layer of the more energetic components of the X-ray continuum was determined to be 1.60 inches.

In a gas-cooled reactor operating at very high power density the thickness of the reflector may be determine by the requirement that the steel pressure vessel be protected from an excessive dose of fast neutrons, rather than by the usual requirements of neutron economy and power distribution. It is important the the reflector not be made thicker than necessary, since an increase in pressure vessel diameter can result in a marked increase in cost, as well as a decrease in the permitted gas pressure level.

The equilibrium and maximum override values for xenon and samarium poisoning have been computed using the recently issued effective cross sections of C. H. Westcott. Values are given as a function of specific power, neutron temperature, and epithermal flux content.