The following report follows a series of experiments on the freezing points of 25 UN-H2O-HNO3 solutions.

Abstract: "A method for determination of dibutyl phosphate in solvent streams containing tributyl phosphate is outlined. The method is based on analysis for total uranium of total phosphate after removal of uranium and phosphate in excess of that present as uranyl dibutyl phosphate. Results on plant solvent samples are presented. Difficulties with precipitation of [...] dibutyl phosphate, when fresh solvents were employed, are discussed. Small amounts of nonphosphate uranium-complexing agents were found in plant solvents. Diluent degradation is postulated as the source of these components. Emulsion-formation tendencies appeared to correlate better with concentrations of these contaminants than with dibutyl phosphate content."

The following report describes two rapid, micro methods for the determination of UNH in Redox waste samples that had been developed fir the concentration range 0.2 to 100 g/l.

The following report analyzes the results taken from studies on the characteristics of the bond interface formed between zircaloy 2 and uranium-12 w/o molybdenum alloys.

Abstract: And investigation of the interactions between 300-Mev neutrons and xenon was made by means of a cloud chamber in a pulsed magnetic field of 21,700 gauss placed in the neutron beam of the 184-inch Berkeley cyclotron. Eighty-seven negative pion events and 257 other stars were analyzed. In addition an experimental check was made on the energy of the incoming neutrons. Classification, identification, and angular and energy distributions of prongs associated with all events are presented. Interpretations of results are given.

From summary: The object of the study was to determine if the heavy metal ions within the concentration ranges normally found in pile cooling water were responsible for corrosion of aluminum.

Abstract: "Laboratory production of an explosion between UNH and "red oil" under calcination conditions has been accomplished. Attempted production of a vapor phase explosion was unsuccessful below 150-160 C. Since such severe conditions are necessary to obtain an explosive reaction, it appears that present Purex plant design is adequate to avoid explosive conditions."

Technical report. Areas covered are properties of uranium halides, properties of uranium nitrides, and hydride formation at high pressure.

The resonance absorption of a lump is described in terms of three components. Calculations of resonance absorption are carried out using the model for the resonance spectrum of uranium recently derived; calculations are also made with variations of this model which involve local fluctuations in level strengths. For metal and oxide lumps the agreement with observation is satisfactory. For dilute mixtures, whose resonance activation was measured by Mitchell, computed values fall 20% to 30% above measured ones.

Abstract. If a pile rod gets bowed within its cooling tube it becomes warmer on the side which approaches the tube wall, and thermal expansion tends to warp it in the same direction as the original displacement. This was discussed roughly in N-601, and it was there concluded that the mechanism was not important for an isolated short slug. In connection with current development of continuous jacket (cartridge) assemblies, it seems desirable to look at this question again. In this case it is possible that the effect may be of some concern.

"This bibliography is limited to book and journal references covering methods and instruments in general for measuring high temperatures. The search included only literature from 1950 to the present [1957]."

The behavior of insoluble corrosion products in the HRT is generally understood and studies of the removal of these solids by hydroclones can logically be terminated after the effect of higher processing rates by the multiple hydroclone has been determined. Chemical descaling may be required to supplement solids removal by hydroclones. Laboratory studies to find suitable reagents will be continued in conjunction with decontamination work presently in progress.

The creep problems associated with zircaloy-2 process tubes and the factors affecting the creep of these tubes were discussed in detail. Emphasis was placed on the determination of the tube wall thickness for an SPR tube, whose minimum thickness is limited by creep considerations. It was concluded that, at the present time, there is not enough information available to design zircaloy-2 process tubes on a realistic basis. Various experiments were suggested to supplement the creep rate testing program being pursued by Battelle Memorial Institute.

The following report provides data taken from investigations on radiation and the different biologic effects on it.

The following document is meant to inform the reader on the makings of a cement base for the hot filament mass spectrometer source as part of a publication in the review of scientific instruments, "Laboratory and Shop Notes".

This report follows a test made to determine the effect of temperature on the distribution of nitric acid between "carbitol" and gunk, extracting a number of samples of aqueous copper nitrate with samples of "carbitol" of various acidities. The data obtained is covered in Table 1.

Abstract. An IBM-650 computer code for the detailed unfolding of [gamma]-ray spectra obtained from NaI scintillation counters has been developed. The procedure is set up to remove analyzer scale dependence and to largely remove energy dependences. Computer time is about 1 minute per [gamma]-ray.

"Changes, corrections and additions to the original report are included in this addendum. These are brought about by further development of the design by Blaw-Knox, ANL and ORNL. The changes are listed in accordance with the main headings, pages and paragraphs to which they apply."

Abstract: "A novel procedure employing ion exchange resins was developed to separate chromate ions from hydrogen peroxide, permitting, permitting the subsequent analysis of peroxide to determine its decomposition in sodium chromate solutions. At high pH's, peroxide was absorbed anionically on the ion exchange resins along with chromate. By selecting a resin which would be effective at nearly neutral conditions, chromate was satisfactorily separated from peroxide. It was found that the rate of peroxide decomposition in slightly alkaline sodium chromate solutions was dependent on temperature, pH, aeration, and chromate concentration. No significant effect on decomposition was caused by visible light."

The following report is a study of the separating qualities of a loop-type separator that can obtain separation with a smaller pressure drop.

Abstract: "Uranium monocarbide-Zircaloy II alloy cermets were developed and tested for chemical and physical properties. It was determined that pure uranium monocarbide can be prepared by vacuum are melting techniques. Following melting, the combination, hot pressing, and corrosion behavior of dense monocarbide has been studied. The preparation of uranium monocarbide-Zircaloy II cermet bodies was investigated by means of hot pressing, cold pressing and sintering, warm pressing, extrusion, and hot rolling. The corrosion resistance of the cermets was related to such variables as composition, preparation technique, and powder size. 01 per cent uranium monocarbide, 70 per cent zircaloy II cermets withstood corrosion tests in 680 F water. Cermets having above 30 weight per cent uranium monocarbide were not corrosion resistant."

From introduction: "The purpose of the present report is to describe briefly certain improvements that have been made in the experimental facilities and to present the results of further measurements on critical masses and spatial neutron flax distributions in Be reflected reactors having square and thin slab geometries."

Abstract:"A method is described for the electroreduction of plutonium to the +3 valence state in a nitric acid-sulfamic acid solution. Exploratory experiments in the search for a coulometric titration of Pu(III) using electrolytically generated ceric ion are also described. The results strongly indicate that a convenient procedure can be devised. Suggestions for future work are presented."

Hydrogen peroxide has been used to reduce plutonium (VI) in nitric acid solution to the (IV) valence state. However, reduction of plutonium (VI) solutions containing iron has often been incomplete when hydrogen peroxide was used as the reducing agent. Since reduction of plutonium (VI) has been applied in plant solutions containing iron, a study of the plutonium (VI) reduction with hydrogen peroxide was undertaken. Variables tested included plutonium, nitric acid, and iron concentrations.