Black cardboard viewer with plastic lenses, "for printed stereo photographs." It has scored portions and instructions for folding the cardboard to create a standing viewer to look through the lenses and keep the image at a distance.

The radiolytic decomposition of tributyl phosphate has been show by burr to product gases, acids, and polymers. the acids that are formed can limit the usefulness of tributyl phosphate for the processing of radioactive materials. The study of acid formation on radiolysis therefor becomes important to us for the understanding of the mechanism of acid formation, the influence of added materials and the effect of the structure of organo- phosphorous compounds. Samples of purified esters have been irradiated in the ORNL cobalt source. Conclusions: (1) The formation of acid from tributyl phosphate during irradiation with cobalt gamma rays involves a mechanism that is not a primary step. Evidence has been obtained for a secondary reaction that is minimized by the presence of certain compounds. (2) Toluene acting as an inhibitor for radiolytic formation of acid may indicate the usefulness of an aromatic hydrocarbon diluent in processing. (3) The aromatic hydrocarbon, when phenyl, was not effective when it was part of the molecule. (4) First tests revealed that dibutyl butyl-phosphonate produced less acid the TBP and may warrant further consideration for process application.

This memorandum presents a description of several additional miscellaneous HRT core maintenance tools, not in an earlier report (1). These tools were used in the removal of the cut up diffuser plates, probing the core wall, gauging the size of the holes, and other simple tasks. Function, design, and operation are described for the following items.

After shutdown heating rates have been calculated for the target, control plates, and the beryllium reflector of the HFIR. Hilvety previously calculated the after shutdown heating rates in the element and his results are reported in ORNL CP-60-4-110. Decay times of 1.0 10, 10^2, 10^3, 10^4, and 10^5 seconds have been considered, and heat fluxes have been computed for all of the mentioned components. The greatest heat fluxes were found to be at the surfaces of the control plates and the permanent beryllium reflector.

For Co60 source at 15 meters, the air-scattered gamma dose rate predicted by theory is excerpted from ORNL-1575, pp. 167-203. This is compared with experimental measurements for the same source and comparable geometry reported by Convair in CVAC-170T. After applying an appropriate correction for ground scattering as estimated in Mart-55-16T (Convair), the two results are found to be in substantial agreement.

This quarterly progress report of the Aircraft Nuclear Propulsion Project at ORNL records the technical progress of the research on circulating-fuel reactors and other ANP research at the Laboratory under its Contract W-7405-eng-26. The report is divided into three major parts: I. Reactor Theory, Component Development, and Construction, II. Materials Research, and III. Shielding Research. The ANP Project is comprised of about 530 technical and scientific personnel engaged in many phases of research directed forward the achievement of nuclear propulsion of aircraft. A considerable portion of this research is performed in support of the work of other organizations participating in the national ANP effort. However, the bulk of the ANP research at ORNL is directed toward the development of a circulating-fuel type of reactor. The design, construction, and operation of the Aircraft Reactor Test (ART), with the cooperation of the Pratt & Whitney Aircraft Division, are the specific objectives of the project. The ART is to be a power plant system that will include a 60-Mv circulating-fuel reflector-moderated reactor and adequate means for heat disposal. Operation of the system will be for the purpose of determining the feasibility, and the problems associated with the design, construction, and operation, of a …

The development of the reactor layout is continuing. New features that have been incorporated because of stress, fluid flow, or fabricability considerations include an elliptical fuel expansion tank, a rounded dome to enclose the top of the reactor, a newly designed sodium pump impeller, and other related items. Recently completed heat exchanger tests yielded consistent data from which a series of heat exchangers is being designed. The most promising of these will be chosen for the ART.

Progress report of the Oak Ridge National Laboratory Aircraft Nuclear Propulsion Project providing updates on various projects, experiments, and other work. This report includes summaries of project activities in: aircraft reactor test design, ART physics, ART instruments and controls, component development and testing, procurement and construction, ART, ETU, and in-pile loop operations, phase equilibrium studies, chemical reactions in molten salts, physical properties of molten materials, production of fuels, compatibility of materials at high temperatures, chemistry, analytical chemistry, metallurgy, dynamic corrosion studies, general corrosion studies, fabrication research, welding and brazing investigations, mechanical properties studies, ceramic research, nondestructive testing studies, heat transfer and physical properties, radiation damage, fuel recovery and reprocessing, critical experiments.

Progress report of the Oak Ridge National Laboratory Aircraft Nuclear Propulsion Project providing updates on various projects, experiments, and other work. This report includes summaries of project activities in: aircraft reactor test design, ART physics, ART instruments and controls, component development and testing, procurement and construction, ART, ETU, and in-pile loop operations, phase equilibrium studies, chemical reactions in molten salts, physical properties of molten materials, production of fuels, compatibility of materials at high temperatures, chemistry, analytical chemistry, metallurgy, dynamic corrosion studies, general corrosion studies, fabrication research, welding and brazing investigations, mechanical properties studies, ceramic research, nondestructive testing studies, heat transfer and physical properties, radiation damage, fuel recovery and reprocessing, critical experiments.

This quarterly progress report of the Aircraft Nuclear Propulsion Project at ORNL records the technical progress of the research on circulating-fuel reactors and ether ANP research at the Laboratory under its Contract W-7405-eng-26. The report is divided into three major parts: I. Reactor Theory, Component Development, and Construction, II. Materials Research, and III. Shielding Research.

The successful completion of a program of experiments, including the Aircraft Reactor Experiment (ARE), has demonstrated the high probability of producing militarily useful aircraft nuclear power plants employing reflector-moderated circulating-fuel reactors. Consequently, and accelerated program culminating in operation of the Aircraft Reactor Test (ART) is under way. In order to adhere to the compressed schedule of the accelerated program, it is essential that the Atomic Energy Commission approve the 7500 Area in Oak Ridge as the test site by February15, 1955. This report summarizes the hazards associated with operating the contained 60-Mv reactor of the ART at the proposed Oak Ridge test site.

The method is based on caustic precipitation and centrifugation (which removes the Cs and small amounts of Sr, rare earths, Zr, Nb, and Ru). These are removed in the supernatant and run through a cation exchange column. This separates Zr-NB and Ru. The effluent is precipitated and the Zr-Nb is stored in an asphalt pit. The Ru then may be recovered from the precipitate. The precipitate from the original centrifugation is calcined, pressed and transported to a deep well.

The ORNL analog computer was used to examine one aspect of a safety system for the EGCR. The thermal behavior of the fuel as a result of increases in reactivity at various power levels and gas flows was examined. Safety actions initiated by wither a flux-minus-flow signal or a reactor outlet gas temperature signal were included in simulation.

An analog simulation is made of the HRP in-pile slurry loop in the LITR. The radiolytic gas pressure in the pressurizer is determined. This pressure is a result of the generation of radiolytic gas in the loop core. A graphical result is obtained showing the effect of catalyst activity and pressurizer flow rate on the pressure rise from radiolytic gas. The thermal behavior of the system is studied, and the response to various controller settings is predicted. Controller settings very near optimum for the actual process were recommended from the analog study,

A stimulation study of the deign as of June 1960 of the gas-cooled ORR Loop No. 1 was made using the ORNL analog computer. The proposed method of temperature control is evaluated, and the dynamic behavior of the loop for accidents and component failures is presented in graphical form.

The Thorex Pilot Plant at Oak Ridge National Laboratory was operated during 1955, processing reactor-irradiated thorium slugs to recover U233 and thorium and 12 MTR fuel elements to recover U235 and Np237. The radiation exposure received by operating personnel during this period averaged 60 mrcp/man-week. Most radiation exposure was received in areas that were intended to be only slightly or nonradioactive. However, because insufficient decontamination of process solutions was achieved and equipment surfaces became contaminated from equipment failures, these areas became primary sources of personnel exposure. The installation of additional shielding where needed and the prompt removal of surface contamination successfully reduced the radiation levels and exposures in these areas. Remote control of processing equipment and sampling of very radioactive solutions from process equipment was successfully accomplished, and assisted in the reduction of exposure to operating personnel.

Five irradiated and five unirradiated wafers were analyzed. Each wafer was analyzed for samarium by emission spectrography. The unirradiated wafers were analyzed for uranium by coulometric and potentiometric methods and for uranium isotopes by mass spectrometry. The irradiated wafers were analyzed for uranium and plutonium by coulometric methods, for plutonium isotopes by the 256-channel alpha pulse analyzer, and for the isotopes of uranium and of plutonium by mass spectrometry. The methods of preparing wafers for analysis are discussed; the data are tabulated.

Progress report of the Oak Ridge National Laboratory Analytical Chemistry Division providing updates on various projects, experiments, and other work in ionic analyses, analytical instrumentation, radiochemical analyses, activation analyses, spectrochemical analyses, inorganic preparations, optical and electron microscopy.

The development of ionic methods for the determination of corrosion products in the highly radioactive Homogeneous Reactor (HR) fuels has been of major interest in the work of the Ionic Analyses Laboratory. Methods for the spectrophotometric determination of aluminum and for the polarographic determination of iron in HR fuels have been developed. The polarographic determination of molybdenum in uranyl sulfate solutions was studied. A polarographic method for the determination of zinc was developed. A fluorometric method for the determination of microgram amounts of fluoride was studied. Three organic reagents were investigated as precipitants for microgram quantities of zirconium in HR fuel. The automatic photometric titration technique was applied to the determination of thorium and of sulfate. A method was developed for the ionexchange separation and potentiometric titration of cobalt. The ultraviolet absorption spectra of technetium and rhenium were studied.

The development of ionic methods for the determination of corrosive products in the highly radioactive Homogeneous Reactor (HR) fuels has been of major interest in the work of the Ionic Analyses Laboratory. Methods for the spectrophotometric determination of aluminum and for the polarographic determination of iron in HR fuels have been developed. The polarographic determination of molybdenum in uranyl sulfate solutions was studied. A polarographic method for the determination of zinc was developed. A fluorometric method for the determination of microgram amounts of fluoride was studied. Three organic reagents were investigated as precipitants for microgram quantities of zirconium in HR fuel. The automatic photometric titration technique was applied to the determination of thorium and of sulfate. A method was developed for the ion-exchange separation and potentiometric titration of cobalt. The ultraviolet absorption spectra of technetium and rhenium were studied.

A new gas-liquid countercurrent system (the ANCO system from Anisole-Complex) for the enrichment of boron isotopes has been developed. It is believed that use of this systems will result in a considerably lower unit cost for enriched boron-10 than was previously possible. The system utilizes the exchange reaction between BF3 (gas) and BF3·anisole (liquid) to concentrate boron-10 in the liquid phase. The single stage isotopic separation factor for this system has been found to vary from 1.039 at 0°C to 1.029 at 30°C. The isotopic exchange reaction has been shown to be rapid. Vapor pressures of the complex as a function of temperature have been measured and the heat of formation of the complex determined. Laboratory experiments show that quantitative removal of the BF3 from the complex can be accomplished by heating. A complete miniature ANCO plant was constructed and operated in the laboratory to test the feasibility of the system. The system was found to operate efficiently with a minimum of attention, and to enrich the isotopes of boron as expected. Based upon the experience obtained with the laboratory ANCO unit, a pilot plant large enough to utilize a 6-inch diameter exchange column was designed. The design calculations of …

In an elastic collision the neutron loses part of its kinetic energy to the nucleus with both the kinetic and momentum of the system being conserved. However, for many elements the scattering is not isotropic in the center-of-mass system at the higher neutron energies. Many of the present reactor multigroup codes include anisotropic scattering at the high neutron energies, while many others assume isotropic scattering at all energies. In order to consider some of the effects of including anisotropic scatting, reference is made t the multigroup equation generally assumed for the slowing-down density.

Oscillations have been observed in a magnetically supported cylindrical rod of plasma. This rod of plasma can be the discharge occurring in the defining aperture of a Mode II, pressure gradient arc. Similar oscillations can also occur in the column of a Mode I arc. These oscillations appear to be the mechanism that drives the Mode II blowup phenomena.

This semi-annual report of the Applied Health Physics Section of the Health Physics Division provides both narrative and quantitative descriptions of area air monitoring activities, fallout activity, rain water analyses, Clinch River and White Oak Creek analyses, background radiation monitoring, and monitoring of the work and protective garments laundry. Measurements for gamma and beta activity are reported in millicuries/cubic centimeter. The report does not provide information on specific radionuclides.