100% recovery of uranium from pyrolytic carbon-coated spheroids of uranium dicarbide has been accomplished by an aqueous electrolytic process at the small scale laboratory level. This result was obtained in a system which circulated 1 molar nitric acid through a thin bed of the spheres. The bed was supported between a glass frit and the anode, with which the bed was in contact. The anode was a spiral of platinum wire; the cathode was a grid of titanium wire. Current density was about 0.2 amp/cm2 based on geometric surface area calculated from the average particle size of 150 microns. Initial flow rate was about 1.3 ml/cm2/sec. Reaction temperature was 72-82°C; time was 15 hours. At 1/5 the above current density and at the same temperature recovery was smaller and was independent of concentration of nitric acid over the range 1-4 molar; also recovery in 1 molar ammonium nitrate was about the same as in 1 molar HNO3. About a 100-fold increase in recovery was obtained by going from a convection stirred cell at 90°C to the pumped type of cell at 54°C using ammonium nitrate as the electrolyte.

The absorption bands induced in α-Al2O3 by gamma and reactor irradiation have been studied. The slight coloration due to γ-rays saturates. Bands specific to reactor irradiation have been found and their growth studied.

This note describes some results of the study of single pion production in π⁻-p interactions at 4.65 Bev/c, using the BNL 20" Hydrogen Bubble Chamber. It is well known that the observability of some of the particle resonances (e.g. 33 Isobar and η) varies markedly with the energy of the incident particle. The ρ meson has been observed in π⁻-p interactions at 1.25 Bev/c and 1.9 Bev/c incident pion energies. Evidence will be shown that this resonance persists with the much higher incident pion energy used in the present experiment.

In recent months, experiments investigating the total, non-elastic, transport, etc., cross-sections of U-238 have been performed. It is the purpose of this memo to examine these data and to obtain from them information which will be of use in refinements pile calculations. In cases, e.g. transport cross-sections, where experimental data do not suffice, the theory developed pertaining to the continuum model of the nucleus has been depended upon. One of the fundamental requirements of this model is that the spacings of the energy levels in the compound nucleus are small compared to their widths and that consequently many levels are excited by the incoming particles. As a result there are many more modes of decay and the continuum model is an average over these levels.

This report describes the design procedure for a reflectometer or directional coupler to replace the probe part of the D07-1020 assembly used at the Brookhaven Alternating Gradient Synchrotron linac. Mathematical treatment and diagrams of various reflectometers are included.

Use of the Smith chart in studying stub tuners is demonstrated. Several properties of the tuners are shown, and charts for various wave length spacings, tuning trajectories, and admittances are included.