Abstract: "X-ray and microscopic examination of slags from uranium metal production bombs which gave good and bad yields in the plant at St. Louis have indicated the significance of uranium oxide formation. Apparently the oxide (UO2) results from reaction of the UF4 with linear material, particularly with moisture in the liner."

This technical report presents the process design for the thorium semi-works plant which will be located at the Feed Materials Production Center, Fernald, Ohio. It contains the process information required for the layout and detailed mechanical design of the thorium plant.

Introduction: "This letter is intended to provide a brief summary of the information presently available on the engineering properties of iron-linonite concrete with the view of adapting such concrete with the view of adapting such concrete for use as biological shielding material in a Hanford pile. By reducing materials and fabrication costs, such a adaptation might effect a savings of at least two million dollars per pile over the present iron-masonite laminated shield structure."

Objective: "Production Test 235-1 and an amendment, were written to outline the procedures for reducing the outgassing time and evaluating the effects of these reductions."

The following report provides the results of an accelerated corrosion test that was performed to compare the effect of two coagulants on the corrosion rates of aluminum slug jacket alloy and 72S. Additionally, some analytical data on the water from the two treatments were obtained and are presented in this report.

The following report provides measurements of the crystalline structure of neptunium metal.

The following document is meant to inform the reader on the makings of a cement base for the hot filament mass spectrometer source as part of a publication in the review of scientific instruments, "Laboratory and Shop Notes".

Technical report presenting the results of a study of the AEC thorium production facilities at Iowa State College, Ames, Iowa. Operating procedures, descriptions of equipment and a production cost analysis have been included in this study.

"This report covers mainly the work completed since the last interim report, HNL Log No. 0-4714. This report includes results from studies of the rare earth distribution in bismuth-uranium and fused chloride and studies of fused chloride behavior."

This report follows an investigation made on the welding of Ames thorium by the inert-gas-shielded tungsten-arc process as the first part of a program on the joining of thorium. This program is part of a broader research program to develop the technology of thorium.

The following report calculates pile reactivity changes that result from different pile loadings where it is desirable to have available values of (flux)2 d(volume) for various flat zone radii. This information was found for a cylindrical pile having circular flat zones and an effective radius of 598 cm., by integrating over a cross sectional volume of one cm. thickness.

This report follows a study that was undertaken to evaluate the practicality if removing the heat from the reactor cooling water by means of a "flash cooler" and to compare its economics with that of the conventional heat exchange system.

From introduction: "A simplified calculation has been carried out in order to gain some insight into the flux distribution, peak to average power density, efficiency of a catching blanket and the effect of a reflector in the proposed converter reactor."

The corrosion of uranium in moist air is more rapid than had been thought previously. Earlier recommendations were based on test of 300 hr duration. In tests which were conducted for over 1000 hr, moisture has less effect than in those tests made over shorter periods. The corrosion of uranium by dry and moist air has been studied at 38, 57, and 75 degrees C. Although moisture increases the rate of initial attack, after 200 to 500 hr the effect is reduced and an accelerating corrosion rate overshadows the initial effects of moisture.