Report regarding the chemical processing instrumentation designs and problems at the Idaho Chemical Processing Plant.

Tests made on the Oy-Tu reacting assembly at Pajarito indicate that the lateral displacement of two halves of the active material within the assembly can be used as a control mechanism on this type of reacting assembly. This report describes a reacting assembly using a rotary control mechanism based on this principle and indicates the sensitivity of control possible with such a device.

Extremely radioactive particles result from the abrasive wheel cutting of irradiated fuel elements in the cut-off cell located in the 327 Building. Due to the use of water during the cutting operation these particles are in suspension and must be removed before the liquid can be discharged to the liquid waste tanks in the 340 building. The filters presently employed in the cell total activity discharged to the 340 Building tanks is attributed to the particles which pass these filters. With the start-up of a new, larger cut-off cell the cutting is expected to increase considerably, thereby increasing the amount of radioactive cuttings requiring disposal. The installation of equipment which would more efficiently remove the suspended particles would (1) reduce the activity level of wastes disposed to ground, (2) reduce the radiation exposure level to drivers who truck the wastes to the 200 Area, and (3) prevent the forming of localized high radiation zones due to the deposition of particles in the waste line in the 327 Building.

From purpose and scope: Diamond drill exploration of the Lukachukai district was undertaken to find minable bodies of uranium ore and to determine whether sufficient reserves were present to warrant construction of a local mill. A minimum of 30,000 feet and a maximum of 50,000 feet of drilling were assigned to block out ore in the discovery area, Mesa I (pl. 1.). It was anticipated that some of the footage might be used to test Mesa II should the area become accessible. With access to Mesas II and IV subsequently provided by roads constructed by F. A. Sitton, Inc., and access to Mesa III furnished by a road constructed by the Atomic Energy Commission, the area available for drilling was eventually increased by some three and a half times. With no increase in allotted footage, the hole density was correspondingly decreased,

"The performance of the Model I electrostatic precipitator sampler in recent field and laboratory tests is described and discussed. Two of the four precipitator-bearing balloon flights during this interval reached the floating altitude of approximates 105,000 feet, and the precipitator operated efficiently on both. One sample was collected at the nominal design flowrate of approximates 100 cfm, and the second at approximates -200 cfm. Comparison of the deposition profiles of the stratospheric samples with those obtained under controlled conditions in the altitude chamber indicates that the field samples were collected with >90% efficiency. The laboratory tests also showed that the performance capability of the precipitator improves with increasing precipitator current, and with increasing altitude. One of the above balloon flights carried two Model A-I altimeters with recorder outputs. The two records were identical within plus or minus 250 feet. In addition, variations in altitude indications were consistent with the less sensitive aneroid barocoder measurements from the same flight. A revised Model A-I altimeter with a telemeterable output signal has been designed and constructed. The frequency of the signal is a function of the altitude. A preliminary design concept for a flowmeter with negligible flow resistance is described. It would utilize …