Report presenting an investigation at transonic speeds to determine the effects of fences, drooped nose, combination fences and drooped nose, and vortex generators on a 45 degree sweptback wing-fuselage combination. The purpose of undertaking this investigation was due to the pitch-up tendency that results from leading-edge vortex-type flow on thin sweptback wings. The data for each component and their interaction with one another is also provided.

Report presenting an investigation to determine the effect of oxygen concentration of the inlet oxygen-nitrogen mixture on the combustion efficiency of a J33 single combustor operating with gaseous propane fuel. Combustion efficiency data were obtained at a variety of combustion-inlet total pressures, fuel flow rates, and inlet oxygen concentrations. Results regarding combustor data, application of fundamental combustion properties to combustor data, application of simplified reaction kinetics equation to combustor data, comparison of liquid and gaseous fuel data, and limitations of correlation parameters.

Report presenting an investigation to determine the aerodynamic characteristics of two three-blade propellers over a range of blade angles and Mach numbers. The thick-blade propeller was more adversely affected by compressibility than the thin-blade propeller, and the maximum efficiency of the thin-blade propeller was higher than the thick-blade propeller.

Report presenting a series of fence installations tested on a swept-wing jet airplane to determine their effects on the longitudinal instability, or "pitch-up", encountered in high-maneuvering flight. Longitudinal-stability measurements were made at a variety of Mach numbers with nine fence configurations that varied in chordwise extent and spanwise position. Results regarding longitudinal stability, flow phenomena, buffeting and wing dropping, drag, and low-speed stalls are provided.

"A general vector differential equation for the vorticity component parallel to a streamline is derived for steady, nonviscous, and incompressible flow in a rotating system. This equation is then simplified by restricting it to rotating radial channels and by making further simplifying assumptions. The simplified equation is used to solve for the secondary vorticity, the vorticity component parallel to the streamline, in three special cases involving different streamtube geometries; the results are presented in a series of figures" (p. 1).

Memorandum presenting the use of the hypersonic similarity rule to correlate pressure distributions and wave drags for minimum-drag nose shapes derived by Von Karman and Newton. The computed results have been confirmed by comparison with available experimental data. Wave-drag results for both the Karman and Newtonian shapes are compared with each other and with results for ocnes and circular-arc tangent ogives.

This quarterly report discusses ongoing research and experiments at Oak Ridge National Laboratory in the Metallurgy Division. This report discusses water cooled reactors, liquid metal cooled reactors, reactor development metallurgy, basic metallurgy, applied metallurgy, and aqueous corrosion.

A number of questions have arisen in regard to the interpretation of personnel monitoring results reported to users of the Brookhaven neutron monitoring service. The original announcement was rather brief and did not contain most of the technical characteristics upon which an evaluation of results must be based. The following paragraphs have been composed with the hope that they will clarify the meaning of the exposure reports.

The purpose of this report is to describe a method of obtaining deuterons from the 184-inch cyclotron of higher energy than can be achieved from direct acceleration.

This document is a sequel to HW-30226, "Steady State Temperature Distribution in a Solid Slug." A primary feature of the present as well as the former paper is a treatment of the stand heat flow equation in a manner which accounts accurately for the dependence of the thermal conductivity, K, on temperature, v.

"An experimental investigation has been conducted in the Langley stability tunnel at low speed to deter+nine the yawing stability derivatives of a 1/9-scale powered model of the Convair XFY-1 vertically rising airplane. Effects of thrust coefficient were investigated for the complete model and for certain components of the model. Effects of control deflections and of propeller blade angle were investigated for the complete model" (p. 1).

The zero-lift damping in roll of the Bell MX-776 missile has been measured by a sting-mounted rocket-model technique at Mach numbers from 0.6 to 1.56. The damping-in-roll data, in general, show no unusual variation with Mach number. Aileron rolling-moment effectiveness derived from these data and previously obtained rolling-effectiveness data appear reasonable,.

This report describes the results of a study to determine the mechanical properties of joining stainless steel tubes to stainless steel tube sheets and evaluating the joint types made by various combinations of rolling and welding.