Abstract: "The mechanical properties of a large number of zirconium alloys have been investigated. These alloys include zirconium-tin and zirconium-tin-uranium. Tensile tests have been run on these alloys at room temperature, 500 F, and 600 F. Hot-hardness data have been obtained from room temperature to 1600 F, with particular emphasis on the hot-rolling range. Creep tests and fatigue tests have been run on a number of zirconium-tin alloys at 500 F."

Abstract: "The mechanical properties of a large number of zirconium alloys have been investigated. These alloys include zirconium-tin and zirconium-tin-uranium. Tensile tests have been run on these alloys at room temperature, 500 F, and 600 F. Hot-hardness data have been obtained from room temperature to 1600 F, with particular emphasis on the hot-rolling range. Creep tests and fatigue tests have been run on a number of zirconium-tin alloys at 500 F."

From to the files: The Shinarump-Moenkopi contact on Oljetoh Mesa in the Monument Valley district, Arizona-Utah, was examined from November 5 to 15, 1951, to determine the location of and the mineralization in Shinarump channels. Twenty-seven distinct channel outcrops were located and examined. Three of these channel outcrops are mineralized and the remaining 24 are barren. Plate I shows the distribution of the Shinarump, the Moenkopi, and the DeChelly member of the Cutler formation; the location of the Shinarmp channel outcrops; the channel trend where there is good evidence for such a trend. The Hoskinrnini tongue of the Cutler was mapped with the Moenkopi as it is not a good mappable unit in this area. The three mineralized outcrops are indicated by the letters A, G, and AA while the barren outcrops bear the letters B to F and H to Z.

From introduction: The purpose of an airborne radioactivity survey is to locate ground areas of higher than normal radioactivity which might lead to discovery of uranium mineralization. For this type of survey, gamma-ray detection equipment employing either a geiger counter or a scintillation counter can be mounted in a fixed wing aircraft or a helicopter.

"An experiment to determine the effect of reactor irradiation on the thermal conductivity of uranium-impregnated graphite at elevated temperatures as described. The results show a decrease in the thermal conductivity saturating at [approximately] 60 percent at a temperature of 700 degrees C; at [approximately] 50 percent at a temperature of 1000 degrees C; and at [approximately] 25 percent at a temperature of 1300 degrees C. It was found that after irradiation at a given temperature, exposure at a higher temperature resulted in an increase in the thermal conductivity. The converse was also observed. Within the precision of measurement there was no difference in effed between temperature changes produced by varying the fission rate in the samples and changes produced by varying the power in an external heater."

Abstract: "An absolute measurement of the 14.1-Mev (n, 2n) cross sections of Li-6 and Li-7 has been made using the large scintillator technique, resulting in cross sections in barns of 0.070 +/- 0.006 and 0.056 +/- 0.005 for Li-6 and Li-7, respectively."

Abstract: The experimentally determined exponential dependence of spontaneous fission rate on Z^2/A has been used to derive an expression for the dependence of the fission activation energy on Z^2/A. This expression has been used to calculate the activation energy for slow neutron induced fission and photofission. The correlation with the experimental data on these types of fission seems to be quite good.

The following report provides information conducted with the purpose of ascertaining the effect of oxygen on activated charcoal at approximately one atmosphere by measuring the amount of CO2 formed over a known length of time.

"These notes are intended to serve as a summary of the current knowledge of properties of materials. In the future some need may exist for related information of methods of testing, design and fabrication. This issue presents information on low tin-zirconium alloys with subdivision..."

A report regarding many uranium production plants constructed during the existing emergencies and pressures of World War II that were not intended to be permanent instillations. These plants either contractor or government owned, with buildings on the most part belonging to the contactor and a major portion of the processing equipment belonging to the government, became outmoded with the development

The present report was prepared to serve mainly as a resume of the AEC 1953 drilling project at Big Indian Wash, and a record of related activities up to early 1954.

A theoretical analysis of the thickness vibrations in long thin rods of barium titanate is presented. The theoretical results are checked experimentally and their meaning discussed.