Report presenting an investigation of the effects of sideslip on the aerodynamic loading characteristics of a 45 degree sweptback wing of aspect ratio 4 for a range of angles of attack, angles of sideslip, and Mach numbers. The load distributions, root bending-moment coefficient, and rolling moment due to sidestep were explored.

The revised report includes the chart for the analysis of aircraft accidents, combining consideration of the immediate causes, underlying causes, and results of accidents, as prepared by the special committee, with a number of the definitions clarified. A brief statement of the organization and work of the special committee and of the Committee on Aircraft Accidents; and statistical tables giving a comparison of the types of accidents and causes of accidents in the military services on the one hand and in civil aviation on the other, together with explanations of some of the important differences noted in these tables.

"An analysis of the operating characteristics of a full-floating bearing - a bearing in which a floating sleeve is located between the journal and bearing surfaces - is presented together with charts - from which the performance of such bearings may be predicted. Examples are presented to illustrate the use of these charts and a limited number of experiments conducted upon a glass full-floating bearing to verify some results of the analysis are reported. The floating sleeve can operate over a wide range of speeds for a given shaft speed, the exact value depending principally upon the ratio of clearances and upon the ratio of radii of the bearing" (p. 1).

From Summary: "An analysis is made of the influence on autogiro rotor characteristics of a periodic blade twist that varies with the azimuth position of the rotor blade and the results are compared with experimental data. The analysis expresses the influence of this type of twist upon the thrust, torque, and flapping motion of the rotor. The check against experimental data shows that the periodic twist has a pronounced influence on the flapping motion and that this influence is accurately predicted by the analysis. The influence of the twist upon the thrust and torque could be demonstrated only indirectly, but its importance is indicated."

Report presenting a method for extending to higher Mach numbers the region of low drag attainable for wing-body combinations by the use of the transonic area rule. To a good approximation, the drag depends only on the longitudinal distributions of area and moments of area about the vertical plane of symmetry parallel to the free-stream direction. The experimental results confirm the theory in that the zero-lift wave drag of a wing-body configuration over a range of low supersonic Mach numbers.

Separation processes for production of pure rare earth oxides in useful quantities are discussed. A review of applications of these oxides in the ceramic industry in production of glasses, glazes, porcelain enamels, refractories, abrasives, electronic ceramics, and nuclear ceramics is also presented. 46 references.

The discharge of cooling water from the Hanford reactors introduce radioactive contaminants to the Columbia River. These materials may subsequently bring about exposure to human populations either through the direct use of the water for sanitary purposes or transfers of the radioisotopes into the food chains. It is therefore desirable to keep to a minimum the amounts of radioisotopes released to the river.

Memorandum presenting a concept in aircraft design, which states that provision of a rolling moment in the direction of the turning rotation will be very effective, and may be necessary, for termination of any spin obtained. Current research indicates that wing sweep, use of heavy jet and rocket engines, in the fuselage, and long fuselage nose lengths are the primary causes of the changes in the nature of the spin and in the requirements for recovery.

Report presenting a wind-tunnel investigation to determine the low-speed aerodynamic characteristics of an airplane arrangement with an unswept horizontal tail and a triangular wing with an aspect ratio of 3 equipped with partial-span single-slotted flaps and plain ailerons. The effects of flap deflection on the longitudinal characteristics were investigated at several tail positions. Results indicated taht satisfactory longitudinal stability up to a lift coefficient of 1.35 was attained only when the tail was below the wing-chord plane.

Flight testing at transonic speeds occurred on two rocket-propelled models of an airplane configuration with 45 degree sweptback wings of aspect ratio 4 and with different stiffnesses. Longitudinal stability, lift, and drag characteristics were determined by analysis of the response of the models to disturbances in pitch. Results regarding lift, model vibrations, aeroelastic effects on lift, static stability, damping in pitch, and drag are provided.

Scientific paper issued by the Bureau of Standards over studies conducted on gas effusion rates. The methods used and the results of the studies are presented and discussed. This paper includes tables, and illustrations.

"Flame quenching by a variable-width rectangular-slot burner as a function of pressure for various propane-oxygen-nitrogen mixtures was investigated. It was found that for cold gas temperatures of 27 degrees C, pressures of 0.1 or 1.0 atmosphere, and volumetric oxygen reactions of the oxidant of 0.17, 0.21, 0.30, 0.50, and 0.70, the relation between pressure p and quenching distance d is approximately given by d (unity) p (superscript -r) with r = 1, for equivalence ratios approximately equal to one. The quenching equation of Simon and Belles was tested" (p. 1).

Report presenting measurements made on the Bell X-1 airplane to determine the pressures on the fuselage base and rear portion of the fuselage during level flight. Measurements were made in the power-off condition and with the engine operating. Information about the power-off pressures and jet effects is provided.

"This report presents the results of the tests of a power-plant installation to improve the circumferential pressure-recovery distribution at the face of the engine. An underslung "C" cowling was tested with two propellers with full cuffs and with a modification to one set of cuffs. Little improvement was obtained because the base sections of the cuffs were stalled. A set of guide vanes boosted the over-all pressures and helped the pressure recoveries for a few of the cylinders" (p. 1).

Report discussing some new requirements for satisfactory handling qualities due to the drastic changes in the speed range and configuration of airplanes. Longitudinal characteristics, lateral and directional stability and control characteristics, dynamic lateral and directional stability, and control effectiveness are described. Four categories of characteristics that may affect pilot control are included and ranked by level of severity.

This report discusses two methods used for experimental determination of the interfacial tension of an immisible aqueous-organic system where the density of the organic phase is less than that of the aqueous phase. The methods discussed are the falling drop method and the Donnan modification/rising drop method.

The purpose of this investigation is to make a preliminary study and evaluation of the application of ultrasonic equipment and associated handling equipment to the problem of decontaminating reactor tube dummy pieces. Reactor Section is currently planning the construction of batch process nitric acid facilities for dummy decontamination. It was felt that use of ultrasonics together with a solution less corrosive than nitric acid might provide adequate decontamination at lower project cost than the presently proposed nitric acid facilities. This report gives the progress of the investigation to date.

Report presenting testing to determine the interference effects of various sting-support configurations on the base pressure and foredrag characteristics of a wing-fuselage combination with a turbulent boundary layer. The primary variable investigated was the length of the constant-diameter portion of a sting support. Results regarding the base-pressure interference and foredrag interference are provided.

Memorandum presenting an investigation in the 4- by 4-foot supersonic pressure tunnel at Mach numbers of 1.82 and 2.01 to determine the longitudinal and lateral stability characteristics of a fighter-type airplane model with a low-aspect-ratio unswept wing and a high horizontal tail. The results indicated a region of reduced longitudinal stability at low lifts at a Mach number of 2.01 that was caused by fuselage flow fields or vertical-tail effects on the horizontal tail.

Report presenting wind-tunnel tests at a range of Mach numbers to measure the static longitudinal stability characteristics of a semispan wing-fuselage-tail model having a wing with 45 degrees of sweepback. The wing had an aspect ratio of 5.5 and had NACA 64A010 sections normal to the quarter-chord line. The center of pressure of the wing-fuselage combination moved forward as the wing began to stall, and a tail in the higher positions produced additional stalling moments due to high effective downwash.

Abstract. The preparation and properties of a new explosive, liquid over the range -65 degrees F to +165 degrees F, are presented. This explosive, called NTN, is a 5/1/1 mole ration of nitromethane, tetranitromethane, 1 -nitropropane. The sensitivity and stability of NTN meet military requirements.

Internal-conversion coefficients may be thought of as consisting of two parts: a usually dominant part which depends only on the atomic number and the nuclear transition energy, and a usually small part depending explicitly on nuclear transition matrix elements. This latter part arises from the penetration of the converting atomic electrons within the transforming nucleus.

"In an investigation of the J-33-A-21 and the J-33-A-23 compressors with and without water injection, it was discovered that the compressors reacted differently to water injection although they were physically similar. An analysis of the effect of water injection on compressor performance and the consequent effect on matching of the compressor and turbine components in the turbojet engine was made. The analysis of component matching is based on a turbine flow function defined as the product of the equivalent weight flow and the reciprocal of the compressor pressure ratio" (p. 1).

Quarterly summary report of studies conducted through the Radiation Laboratory, University of California. Some results reported in the report may be of a preliminary or incomplete nature.