Report presenting some of the hydrodynamic problems associated with launching an air missile from underwater. The results of an experiment with models are also provided, including deviation angle, effect of forward speed of the submarine, curved path of the missile, and potential environmental disruptions.

From Introduction: "These data have been collected for presentation in this report to illustrate the performance of turbojet and ram-jet cycles utilizing several of the more promising high-energy fuels. Results are presented in terms of engine over-all efficiency and thrust per pound of airflow as functions of flight Mach number."

"The flow-field characteristics around a swept-wing airplane model at low subsonic speed are described, and the loads induced on a typical missile model while operating within these flow fields are presented. In addition, theoretical flow fields are compared with experiment and are used in first-order estimations of the resulting induced missile loads" (p. 1).

"Comparisons are made of experimental and theoretical zero-lift wave drag for several nose shapes, wing-body combinations, and models of current airplanes at Mach numbers up to 1.0. The experimental data were obtained from tests in the Ames 6- by 6-foot supersonic wind tunnel and at the NACA Wallops Island facility. The theoretical drag was found by use of linear theory utilizing model area distributions" (p. 1).

Memorandum presenting a series of tests made on a full-scale Northrop XB-62 missile to determine the cause of a directional out-of-trim condition which was encountered on the initial missile flight tests. The results indicated that the directional out-of-trim condition was caused by aerodynamic loads induced by engine operation.

Report presenting a compilation of sea-level static and flight-performance data for existing and designed U.S. axial-flow turbojet and ram-jet engines. Factors considered include engine size, performance, and weight, and actual and theoretical performances are compared.

"From these preliminary wind-tunnel tests of interceptor missile configurations and the analysis of point defense against ballistic missiles, it is concluded that adequate aerodynamic lift is readily available and should be utilized when operating under high-dynamic-pressure conditions and that more work should be done on controls, either aerodynamic or reaction type, so that the configurations may be trimmed to the angles of attack required to develop the necessary turning force" (p. 5).

"An investigation of forced-convection heat transfer and associated pressure drops was conducted with air flowing through electrically heated Inconel tubes having various degrees of square-thread-type roughness, an inside diameter of 1/2 inch, and a length of 24 inches were obtained for tubes having conventional roughness ratios (height of thread/radius of tube) of 0 (smooth tube), 0.016, 0.025, and 0.037 over ranges of bulk Reynolds numbers up to 350,000, average inside-tube-wall temperatures up to 1950deg R, and heat-flux densities up to 115,000 Btu per hour per square foot" (p. 1).

Report presenting an investigation in the 20-foot free-spinning tunnel on a scale model to determine the spin and recovery characteristics of the Douglas F4D-1 airplane equipped with external fuel tanks. Results regarding erect spins, inverted spins, and parachute results are provided.

Jet engine induction systems investigations and relationship of air inlets, drag, airframe, pressure recovery, flow and interferences.

"This presentation is intended to reflect the current general approach of the NACA to the problems of high-temperature structures research facilities. The facilities and problems discussed apply to flight in the Mach number range from 2 to about 20. It is emphasized that this field is one in which the thinking is rapidly changing and the facilities investigations discussed, particularly for the higher temperature range, are in the exploratory stage" (p. 1).

Report presenting chemical and physical properties determined from a sample of boron-carbon-hydrogen fuel Z-244.

Report discussing testing of a Hughes Falcon missile, C configuration, to determine the stability and control characteristics of the missile while rolling. Information about the time histories, normal force due to angle of attack, pitching moment due to angle of attack, damping, and control effectiveness is provided.

"For the purpose of calculating bomb trajectories, forces and moments have been measured on bombs of three fineness ratios in the presence of a swept-wing fighter-bomber configuration at a Mach number of 1.61. Trajectories thus obtained have been compared with those from dynamic model tests and an analysis has been made to determine the source of errors and to suggest improvements in both techniques."

From Introduction: "The intermediate subsonic speed range is considered and the liquid-metal turbine-propeller cycle discussed in this report. In this report, compressor pressure ratio, heat-exchanger air-inlet Mach number, and turbine-inlet temperature were optimized for maximum engine net thrust per engine-plus-heat exchanger weight (minimum airplane gross weight) for a range of heat-exchanger effective wall temperature."

Memorandum presenting an investigation of flow surrounding afterbodies behind blunt nose shapes at a Mach number of 2 in the 27- by 27-inch preflight jet. Pressure measurements were made on and around the afterbodies for each configuration.

Memorandum presenting an investigation of the influence of combustion-chamber length on afterburner performance under conditions simulating altitude flight. Results regarding afterburner-inlet conditions, operational limits, and structural cooling requirements are provided.

Report presenting the flying qualities problems of current helicopters, including instability with angle of attack in forward flight, control sensitivity in hovering, and control forces following control movement in maneuvers. Some possible solutions to these issues are presented.

Note presenting an investigation of the phenomena encountered when a plane oblique shock wave is incident upon the boundary layer of a flat plate. The flow field was divided into a viscous layer near the wall and a supersonic potential outer flow. With the outer flow determined, boundary-layer growth and pressure distribution were computed and results for the laminar cases were obtained and provided.

Memorandum presenting low-speed wind-tunnel test conducted of a triangular wing of aspect ratio 2.0 with a symmetrical double-wedge section with a maximum thickness of 5 percent of the chord at 20 percent of the chord. The wing was also tested in the presence of a ground plane. Results regarding isolated wing and wing-body combinations, split-flap effectiveness, and ground effect are provided.

Report presenting high-speed wind tunnel testing of horn- and overhang-balance elevators on a full-scale, semispan, horizontal tail. The effects of unshielding the horn and unsealing the overhang were investigated. Results regarding aerodynamic characteristics, distortions of the tail, and critical Mach numbers are provided.

Report presenting calculations of the dynamic lateral stability characteristics of a mock-up configuration of the Douglas X-3. The oscillations were found to be stable for all calculations investigated but would not meet the Air Force damping requirements for the majority of the conditions. The use of an autopilot was found to greatly improve oscillation damping.

Results obtained with three different burner configurations in a connected-pipe investigation of a 16-inch ram jet are presented. The radial position of the fuel injector and the engine-outlet area both affected burner performance. For a given configuration, only slight changes in total-pressure ratio across the combustion chamber were obtained over the complete range of operation. With one burner, combustion efficiencies obtained at a combustion-chamber-inlet static pressure of 800 pounds per square foot absolute were greater than those obtained at 1920 pounds per square foot absolute.

Report presenting the results of a wind-tunnel investigation of the low-speed aerodynamic characteristics of a 45 degree sweptback horizontal-tail model of aspect ratio 2 and a comparison of these results with results for a model of the same aspect ratio with an unswept hinge line. Results regarding the lift and hinge-moment parameters, static longitudinal stability, effect of Reynolds number, effect of standard roughness, effect of removing elevator nose seal, and visualization of the air flow are provided.