Abstract. In investigating stability of a homogeneous pile it has been customary to assume that the production of bubbles follows the production of power instantaneously. Here we investigate the implications of introduction of an intermediate dissolved gas stage under two hypotheses on the formation of bubbles from this dissolved gas. It is seen that this additional stage tends to make the pile unstable.

This paper reports work carried out to determine the factors necessary to give a filterable precipitation and determine the effects of these factors on the quantitativeness of the precipitation, and how any tendency to increase the tuballoy solubility may be overcome.

Abstract: "An investigation of the mercury salvage program has resulted in the development of an improved high compacity type of distillation apparatus. The still, electrically heated and essentially automatic in its operation, will produce at a rate greater than 75 pounds per hour and develop a product 99.99% pure or better. This still will handle the lowest grade crude of amalgam that can pass through the feed lines and will continue to develop a pure prodcut for comparatively long periods of time. The clean-out operation is amazingly simple and convenient and may be done within one-half hour while the apparatus itself is still hot. Two models of this design are scheduled for installation in a mercury recovery room of the Alpha Analytical Department of Building No. 9207."

The following report studies a method of assay where an unknown sample is determined by comparison with a standard sample of known isotopic ratio. The purpose is to acquaint the technical personnel with the fundamentals of the feedback method of assaying samples of TF6.

This technical report summarizes the work done in attempting to determine the solubility of helium in tuballoy. In general, the method used has been to allow the tuballoy to stand in contact with helium at one atmosphere presume at a fixed temperature for an extended period, then to pump off the excess helium to a low pressure in as short a time as possible (10-6 mm of Hg or less). The system was then closed off and the pressure increase was measured by a suitable gauge as a function of time. The metal was employed in the form of a powder in early measurements, and later as massive metal. The experimental techniques are described in the report.