Memorandum presenting a preliminary investigation made in the two-dimensional low-turbulence tunnel on an NACA 64A010 airfoil with permeable surfaces to obtain an indication of the stabilizing effect of area suction on the laminar boundary layer. Although the airfoil surface had many waves and irregularities of contour, the data corroborated qualitatively the theoretically predicted stabilizing effect of area suction on a smooth flat plate.

From Summary: "Theoretical performance data including nozzle-exit temperature, specific impulse, volume specific impulse and composition, temperature, and mean molecular weight of reaction products based on frozen equilibrium and isentropic expansion are presented for 13 propellant combinations at reaction pressure of 300 pounds per square inch absolute and expansion ratio of 20.4. On basis of maximum specific impulse alone, five fuels had the following order for any given oxidant: liquid hydrogen, hydrazine, liquid ammonia, and either hydrazine hydrate or hydroxylamine. Three oxidants with a given fuel had the following order: liquid ozone, liquid oxygen, and 100-percent hydrogen peroxide."

Report presenting an investigation of icing and ice protection at the inlet of a turbojet engine in the altitude wind tunnel. A method of ice protection was studied that uses hot gas bled from a turbine inlet and injected into the air stream ahead of the compressor inlet. Ice was either prevented or accumulated slowly at various engine speed levels.

Report presenting an investigation in the two-dimensional low-turbulence tunnel on an NACA 64A010 airfoil with permeable surfaces to obtain an indication of the stabilizing effect of area suction on the laminar boundary layer. The surface of the airfoil that was tested had a lot of waves and irregularities, but the theoretically predicted stabilizing effect of area suction on a smooth flat plate was still observed.

From Summary: "Motion pictures at camera speeds up to 3000 frames per second were taken of the combustion of liquid oxygen and gasoline in a 100-pound-thrust rocket engine. The engine consisted of thin contour and injection plates clamped between two clear plastic sheets forming a two-dimensional engine with a view of the entire combustion chamber and nozzle. A photographic investigation was made of the effect of seven methods of propellant injection on the uniformity of combustion. From the photographs, it was found that the flame front extended almost to the faces of the injectors with most of the injection methods, all the injection systems resulted in a considerable nonuniformity of combustion, and luminosity rapidly decreased in the divergent part of the nozzle."

"A theoretical analysis is presented for obtaining by use of Theodorsen's propeller theory the load distribution along a propeller radius to give the optimum propeller efficiency for any design condition. Examples are included to illustrate the method of obtaining the optimum load distributions for both single-rotating and dual-rotating propellers" (p. 1).

From Introduction: "The single purpose of this paper is to make available the data obtained from tests of these two Clark Y section propellers as quickly as possible with no attempt being made to analyze the results or to compare them with other high-speed-propeller test results."