Report presenting tests of an NACA 4-(5)(08)-03 two-blade propeller in the 8-foot high-speed tunnel for blade angles of 45 and 60 degrees extending the Mach number range from that of previous tests of the propeller up to Mach number 0.913. When the forward speed was increased from a low value to a forward Mach number of 0.90, the loss in peak efficiency was found to be not more than 47 percent.

Report presenting flight tests of rocket-powered models at supersonic speeds to determine the effect of nose fineness ratio of winged bodies on total and component drag at high Mach numbers. Wingless models of three nose fineness ratios and winged models of two nose fineness ratios flown through a range of Mach numbers. Results regarding total drag, body drag, and wing drag are provided.

Report presenting the results from tank landing and take-off tests with a dynamic model of a hypothetical jet-propelled airplane equipped with NACA hydro-skis. Results regarding landing tests, take-off tests, and practical considerations for the creation of hydro-ski configurations are provided. The hydro-skis suitable for flush retraction into streamline fuselages do appear to offer a practical means of water take-offs and landings.

Report presenting wind-tunnel testing to determine the low-speed lift, drag, and pitching-moment characteristics of a 40 degree sweptback wing with high-lift and stall-control flaps and a fuselage with a fineness ratio of 10.2 to 1. Low, medium, and high-wing-fuselage combinations were tested at high Reynolds numbers. Results regarding the high-lift and stall-control flaps and wing-fuselage combinations are provided.

Report presenting an analysis of the spanwise loading using two different methods on the wing of an airplane for which pressure-distribution measurements were available from flight tests up to a Mach number of 0.866. A comparison between measured and calculated distributions was made on the basis of equal wing-panel normal-force coefficients.

From Summary: "A blade-element theory for axial-flow compressors has been developed and applied to the analysis of the effects of basic design variables such as Mach number, blade loading, and velocity distribution on compressor performance. The relations among several efficiencies useful in compressor design are derived and discussed. The possible gains in useful operating range obtainable by the use of adjustable stator blades are discussed and a rapid approximate method of calculating blade-angle resettings is shown by an example."

This report presents the building and design philosophy of Building 234-5 at the Hanford site.

"The spin and recovery characteristics of the Curtiss-Wright XP-87 airplane, as well as the spin-recovery parachute requirements, the control forces that would be encountered in the spin, and the best method for the crew to attempt an emergency escape, are presented in this report. The characteristics were estimated rather than determined by model tests because the XP-87 dimensional and mass characteristics were considered to be noncritical and because data were available from model tests of several similar airplanes. The study indicated that the recovery characteristics of the airplane will be satisfactory for all loadings if the controls are reversed fully and rapidly" (p. 1).

"An experimental investigation at low airspeeds was made of the filling effect observed when a screen or similar resistance is placed across a diffuser. The filling effect is found to be real in that screens can prevent separation or restore separated flow in diffusers even of extreme divergence and to depend principally on screen location and pressure-drop coefficient of the screen. Results are given for three different diffusers of circular cross section with a variety of screen arrangements. Effects of single screens and multiple screens are shown" (p. 1).

The results obtained from gust and draft velocity measurements within thunderstorms for the period July 24, 1946 to August 6, 1946 at Orlando, Florida are presented herein. These data are summarized in tables I and II and are of the type presented in reference 1 for previous flights. In two thunderstorm traverses, indications of ambient-air temperature were obtained from photo-observer records. These data are summarized in table III.

From Summary: "An investigation was conducted on a 12-cylinder V-type liquid-cooled aircraft engine of 1710-cubic-inch displacement to determine the minimum specific fuel consumption at constant cruising engine speed and compression ratios of 6.65, 7.93, and 9.68. At each compression ratio, the effect.of the following variables was investigated at manifold pressures of 28, 34, 40, and 50 inches of mercury absolute: temperature of the inlet-air to the auxiliary-stage supercharger, fuel-air ratio, and spark advance. Standard sea-level atmospheric pressure was maintained at the auxiliary-stage supercharger inlet and the exhaust pressure was atmospheric."