Report discussing an investigation into the mutual interference loads on a supersonic bomber configuration and store during separation of the store. Tests were performed at several airplane angles of attack, store angles of attack, and airplane sidestep angles. The aerodynamic characteristics of the various components and coefficients of forces are provided in tables.

"Wind-tunnel tests were conducted to determine the effects of a ventral fin on the static characteristics of a triangular-wing airplane model. Data were obtained for angles of sideslip up to 18 degrees at angles of attack of 0, 6, 12, and 18 degrees at Mach numbers from 0.25 to 0.94. The results of the tests indicated that the ventral fin did not produce as much yawing moment per unit of exposed area at any angle of sideslp as the vertical tail" (p. 1).

Report discussing zero-lift drag data for several bomb configurations at various Mach numbers. Seven configurations were tested with different combinations of interchangeable noses and tail cones with fins, some with different surface conditions. Surface conditions were not found to affect the drag, but the thickness of the tail fins and shape of the noses did change the shape of the drag curve.

Report discussing flow surveys made of several nozzles using two 2-dimensional steps at Mach number 6.98. Results regarding wall-pressure surveys, disturbance patterns in expansion, total-pressure survey, temperature recovery, and general nozzle characteristics are provided.

Report presenting an investigation of zero-lift drag of a fin-stabilized wing-body combination made at high-subsonic and supersonic speeds in a range of Reynolds numbers. The data are presented with that from a wingless body and similar winged body with a slightly different ratio of body frontal area to wing area. Results regarding total drag and wing-plus-interference drag are provided.

From Summary: "Results are presented of light tests made to determine the effect of flap deflection on the lateral control characteristics of a modified Brewster F2A-2 airplane equipped with partial-span narrow-chord ailerons on the trailing edge of a full-span NACA slotted flap. The investigation included determination of the rolling and yawing characteristics of the airplane in abrupt aileron rolls with the slotted flap at various settings ranging from 0 degree to about 40 degrees. The results showed that the effectiveness of the ailerons was greatly reduced at flap deflections greater than about 20 degrees. For flap deflections up to about 20 degrees, the aileron effectiveness was about the same as with flaps retracted, but the adverse yawing velocity developed in the abrupt aileron rolls was somewhat increased."

A vector study of the partial-differential equation of steady linearized supersonic flow is presented. General expressions which relate the velocity potential in the stream to the conditions on the disturbing surfaces, are derived. In connection with these general expressions the concept of the finite part of an integral is discussed. A discussion of problems dealing with planar bodies is given and the conditions for the solution to be unique are investigated. Problems concerning nonplanar systems are investigated, and methods are derived for the solution of some simple nonplanar bodies. The surface pressure distribution and the damping in roll are found for rolling tails consisting of four, six, and eight rectangular fins for the Mach number range where the region of interference between adjacent fins does not affect the fin tips.

Air-launched firings of eight T-40 rockets have been made. An average total impulse of 22,870 pound-seconds was observed for four of the rounds mounted in cone-cylinder vehicles. Maximum velocities of over 5000 feet per second were observed for two of the rounds with approximately 70-pound pay loads.

An investigation of the rolling effectiveness at transonic and supersonic speeds of partial-span ailerons on a 42.7 degree sweptback wing having symmetrical circular-arc airfoil sections of 10-percent thickness ratio normal to the wing quarter-chord line has been made by means of rocket-propelled test vehicles. The results are compared with results of a supersonic wind-tunnel test at Mach number 1.9.

Memorandum presenting an approximate subsonic theory developed for the solid blockage interference in circular wind tunnels with walls slotted in the direction of flow. The theory indicated the possibility of obtaining zero blockage interference. Tests in a circular slotted tunnel based on the theory confirmed the theoretical predictions.

Report presenting an evaluation of the internal performance characteristics of several plug-type nozzles over a range of pressure ratios from 1.5 to 30. Results regarding isentropic plug nozzles, conical plug nozzles, the effect of throat and throat-approach section on performance, and air-flow parameter are provided.

Report presenting an investigation of air-launched ram jets using models with double-cone inlets with a design free-stream Mach number of 2.4. Drag data are presented in the form of cowl pressure drag, additive drag, internal drag, base drag, and total drag. Mass-flow ratios and ram-jet total-temperature ratios are also provided.

Report presenting an investigation of three axial-flow-compressor inlet stages with a hub-tip diameter ratio of 0.5 to determine whether high pressure ratios can be obtained by means of high turning with highly cambered subsonic types of blading and the effectiveness of radial gradients of energy addition in reducing the deceleration across the rotor tip and thus relieving the effect of high tip loading. Results regarding the overall stage performance, diffusion factor, element performance, and stage discharge flow distribution are provided.

Report presenting an analytical and experimental investigation of the effects of cooling-air impeller performance on turbojet-engine performance at 70 and 100 percent of rated engine speed. Analysis indicated that the impeller performance has little effect on engine performance at rated engine speed for the coolant flows considered. Results regarding the impeller total-pressure ratio and cooling air available with compressor bleed are provided.

Report presenting tests to determine the flight characteristics of an F-86 airplane equipped with a blowing-type boundary-layer-control installation on the trailing-edge flaps. The effectiveness of the flap was determined in conjunction with slatted leading edges and an inflatable rubber boot on the leading edge. Measurements were made of lift, drag, flow requirements, and computations for take-off, climb, and landing.

"Wind-tunnel tests were conducted to determine the effects of a ventral fin on the static characteristics of a triangular-wing airplane model. Data were obtained for angles of sideslip up to 18 degrees at angles of attack 0, 6, 12, and 18 degrees at Mach numbers from 0.25 to 0.94. The results of the tests indicated that the ventral fin did not produce as much yawing moment per unit of exposed area at any angle of sideslip as the vertical tail" (p. 1).

Report presenting the results of an investigation of the internal dynamics of a ramjet engine and the steady-state and dynamic performance characteristics of a number of ramjet controls. Three types of engine control systems were investigated: (1) shock positioning, (2) direct control of diffuser-exit pressure, and (3) an optimalizing control designed to obtain peak pressure recovery from the diffuser. Results regarding the engine steady-state performance, engine dynamics, and controls investigations are provided.

Report presenting an investigation to determine the effects of external ribs, or load carrying fences, on the rolling effectiveness and drag on swept wings of two different stiffnesses. The primary effect of adding fences was a decrease in torsional flexibility and an increase in zero-lift rolling effectiveness. The aerodynamic effects on zero-lift rolling effectiveness due to adding fences are negligible.

Report presenting a study of the transonic drag associated with varying the vertical location of the horizontal tail of a representative tail-body combination. Factors which significantly influenced the results were flow separation in the horizontal tail-body juncture, afterbody-tail-interference pressure drag, and a downwash over the horizontal tail which resulted from the boundary conditions of the converging afterbody.

Memorandum presenting an experimental investigation of the aerodynamic loading on one blade and of a two-blade teetering rotor conducted in forward flight for a tip-speed-ratio range of 0.08 to 0.29 at a disk loading of about 2.4 pounds per square foot and a tip speed of about 480 feet per second. Chordwise loading distributions at five spanwise stations and the variation of section loading and total blade lift with azimuth position are presented. Results regarding the performance data, section aerodynamic loading, spanwise loading distribution, total blade lift, and rotor-disk load distribution are provided.

Report presents the results of wind tunnel tests of the Clark Y, the NACA 23012 and the NACA 23021 airfoils equipped with full-span ordinary flaps and with full-span simple split flaps. The principal object of the tests was to determine the characteristics of the airfoils with ordinary flaps and in addition, to determine the relative merits of the various airfoils when equipped with either ordinary flaps or with simple split flaps. The Clark Y airfoil was tested with 3 widths of ordinary flap, 10, 20, and 30 percent of the airfoil chord.

A theoretical study is made of the pressures, loadings, forces, and vortex wake associated with certain cruciform wing arrangements. For 45 degree bank, the wake of a cruciform wing is treated numerically with 40 vortices and analytically with 4 vortices. Comparisons are made with water-tank measurements, and the calculation of loads on cruciform tails by reverse flow considered.