Report presenting an investigation in the full-scale tunnel to determine the effects on the aerodynamic characteristics of a 49.1 degree sweptback wing of blowing a high-energy stream of air over a trailing-edge flap and an aileron. The results indicated that significant increases in lift coefficient and an improvement in aileron effectiveness may be obtained by the blowing method of boundary-layer control.

Memorandum presenting lift, drag, and pitching-moment coefficients of a ballistic-type missile configuration as determined from tests in the 10- by 14-inch supersonic wind tunnel at a range of Mach numbers and angles of attack. Pressure distributions and drag coefficients were also determined at 0 degrees angle of attack.

Report presenting a flight investigation to evaluate the effects of a partial-span, 15-percent-chord, leading-edge extension on the aerodynamic characteristics of the F-86A airplane. Results regarding the longitudinal stability, low-speed stalls, drag, and pilot reports are provided.

Memorandum presenting an investigation to evaluate the effects of operating propellers and of nacelles on the wing-surface pressures on a semispan model of a four-engine tractor airplane configuration with a 40 degree sweptback wing and aspect ratio of 10. Results regarding the effects of the nacelles with the propellers off, effects of flaps, and effects of operating propellers are provided.

Memorandum presenting an investigation in the supersonic pressure tunnel to determine the static longitudinal stability and control characteristics of several missiles at a Mach number of 2.01. The present paper consists largely of a data presentation of the results obtained at combined angles of pitch and sideslip. Appendices are included in which the body, wind, and stability-axes systems are described and the transfer equations necessary to convert the basic data to other forms are shown.

Report presenting an investigation of several two-dimensional supersonic inlet configurations at a Mach number of 2.01 and an angle of attack of 0 degrees. Two inlets similar in supersonic diffuser design but one with a subsonic diffusers about half the length of the other one were also investigated. Results regarding the inlet design, pressure recovery, shadowgraphs, and suggestions for inlet improvement are provided.

Report presenting an investigation to determine the normal force of two three-blade NACA propellers and the agreement of the measured normal force with a theoretical method. Propeller thrust and normal force were measured for a variety of blade angles, angles of attack, and Mach numbers. Results regarding variation with thrust, effect of inclination, and a comparison with theory are provided.

Memorandum presenting the effects of resin coating methods on some physical properties of laminates prepared with glass fabric, Fiberglas 181, and bonded with two commercial polyester resins. The resins used were Laminac 4126 and Selectron 5003. The resin coating methods used were roller coating, application of a dilute solution of resin, resin immersion, application of monomeric styrene, and vacuum impregnation.

Report presenting the zero-lift drag characteristics of seven nose shapes on a slender body of revolution in free flight between the Mach numbers of 0.7 and 1.3. Some of the nose shapes included a spherical segment, flat face with a sharp shoulder, flat face with a rounded shoulder, 30 degree and 40 degree total-angle cones, and a spherical segment with two different length spikes. Results regarding drag coefficients and performance for the various shapes are provided.

"An investigation at a free-stream Mach number of 2.02 was made to determine the effects of a propulsive jet on a wing surface located in the vicinity of a choked convergent nozzle. Static-pressure surveys were made on a flat surface that was located in the vicinity of the propulsive jet. The nozzle was operated over a range of exit pressure ratios at different fixed vertical distances from the flat surface. Within the scope of this investigation, it was found that shock waves, formed in the external flow because of the presence of the propulsive jet, impinged on the flat surface and greatly altered the pressure distribution" (p. 1).

An investigation has been made in the Langley low-turbulence pressure tunnel of the aerodynamic characteristics of the NACA 0012, 64(sub 2)-015, and 64(sub 3)-018 airfoil sections. Data were obtained at Mach numbers from 0.3 to that for tunnel choke, at angles of attack from -2deg to 30deg, and with the surface. of each airfoil smooth-and with roughness applied at the leading edge.The Reynolds numbers of the tests ranged from 0.8 x 10(exp 6) to 4.4 x 10(exp 6). The results are presented as variations of lift, drag, and quarter-chord pitching-moment coefficients with Mach number.

An investigation of the 1XP excitation of inclined single-rotation propellers has indicated a new concept for determining propeller shaft forces and moments of an inclined propeller. This report presents preliminary results, in particular to the counterrotating propeller.

"Altitude performance characteristics of the J65-B3 turbojet engine and its components were obtained at engine-inlet conditions corresponding to Reynolds number indices from 0.2 to 0.8 over a range of corrected engine speeds from 70 to 110 percent of rated speed. Engine operational limits up to an altitude of 75,000 feet together with ignition and windmilling characteristics were also obtained. The engine and component data are presented both in graphical and in tabulated form. The operational characteristics are presented in graphical form" (p. 1).

A brief summary is made of methods available to the helicopter designer for obtaining desired stability characteristics by modifications to the airframe design. The discussion is based on modifications made during the establishment of flying-qualities criteria and includes sample indications of theoretical studies of additional methods.

Report presenting a wind-tunnel investigation on two series of twisted and cambered wings, which were identical except for wing section, to compare the effects of NACA 4-digit and NACA 64A chordwise distributions of thickness on the longitudinal aerodynamic characteristics of the wings. Results regarding the low-speed results, high-speed results, and flow studies are provided.

Report presenting an investigation of the effect of wing-mounted external stores on the loading and aerodynamic characteristics in pitch of a 45 degree sweptback wing combined with a fuselage. Store arrangements investigated consisted of stores mounted at the wing tips, stores mounted inboard on the wing undersurface at 46-percent semispan, and stores in both the tip and inboard locations.

"An investigation has been conducted in the Langley 4- by 4-foot supersonic pressure tunnel at a Mach number of 1.41 to determine the static stability and control and drag characteristics of a 1/15-scale model of the Grunman F9F-9 airplane. The effects of alternate fuselage shapes, wing camber, wing fences, and fuselage dive brakes on the aerodynamic characteristics were also investigated. These tests were made at a Reynolds number of 1.96 x l0 (exp 6) based on the wing mean aerodynamic chord of 0.545 foot" (p. 1).

From Summary: "An investigation was conducted in the Langley 19-foot pressure tunnel on a 0.3-scale model of the Republic RF-84F airplane to determine modifications which would eliminate the pitch-up that occurred near maximum lift during flight tests of the airplane. The effects of high-lift and stall-control devices, horizontal tail locations, external stores, and various inlets on the longitudinal characteristics of the model were investigated. For the most part, these tests were conducted at a Reynolds number of 9.0 x 10(exp 6) and a Mach number of 0.19. The results indicated that from the standpoint of stability the inlets should possess blunted side bodies. The horizontal tail located at either the highest or lowest position investigated improved the stability of the model."