None

The purpose of this document is to present in graphical form a current picture of the quality of the Hanford plutonium product.

"Theoretically derived charts showing the profile-drag-thrust ratio are presented for helicopter rotors operating in forward flight and having hinged rectangular blades with a linear twist of 0 degree, 8 degrees, and 16 degrees. The charts, showing the profile-drag characteristics of the rotor for various combinations of pitch angle, ratio of thrust coefficient to solidity, and a parameter representing shaft power input, are presented for tip-speed ratios ranging from 0.05 to 0.50. Also presented in chart form are the ratio of thrust coefficient to solidity as a function of angles of attack, as a function of inflow ratio and collective pitch, and as a function of power and thrust coefficients" (p. 1).

None

Report of the daily cash position for Sugarland State Bank.

Memorandum presenting an airborne missile simulator used to represent visually the predicted flight behavior of the Navy XASM-N-7 Bullpup air-to-surface missile, which is guided along the line of sight to the target by bang-bang radio signals controlled by the pilot of the launch airplane. Quantitative response measurements showed that the simulator gave a good representation of the trajectory and control characteristics predicted for the Bullpup missile, and the simulation appeared plausible to the pilots.

This report lists some physical properties data of aqueous homogenous reactor materials.

Report presenting results of a flight investigation of a radar fire-control system installed in a fighter airplane. Some of the factors included in the radar evaluation are "noise" of the steering dot, lack of target-attitude information, and sensitivity and linearity of the display.

Report presenting an investigation in the stability tunnel to determine the combined effect of wing and wing-body interference on the contribution of an x-tail configuration to the low-speed rolling-stability derivatives of an airplane model with an unswept midwing and to indicate the change due to roll in the local flow angularity at a number of stations across the tail surfaces for one-half of the x-tail. Results regarding the static longitudinal characteristics, steady-roll characteristics, and angularity measurements are provided.

Report presenting an investigation in the 300 mph 7- by 10-foot tunnel to determine the chordwise and spanwise load distribution on a thin 60 degree delta-wing-fuselage model equipped with double slotted and extended double slotted flaps. The effects of a canard on the loads of the wing with the extended double slotted flaps are also determined.

Experimental investigations were undertaken at Columbia University to determine the heat transfer and fluid flow characteristics of fuel elements for the Savannah River reactors. Primarily the tests simulated quatrefoil operation, but a number of tests directly applicable to the operation of extended surface fuel elements were performed. Data books were published in which the experimental data are tabulated.

A summary is given of the background and present status of the pure-planing theory for rectangular flat plates and v-bottom surfaces. The equations reviewed are compared with experiment. In order to extend the range of available planing data, the principal planing characteristics for models having sharp bottom surfaces having constant angles of dead rise of 20 degrees and 40 degrees. Planing data were also obtained for flat-plate surfaces with very slightly rounded chines for which decreased lift and drag coefficients are obtained.

The purpose of the test was to determine if failed blanket elements exist in other regions of the core beside F-2. FEDAL sampling ports that have indicted the greatest deviation as determined in a statistical analysis performed on a number of traverses in the FEDAL system will be tested. Data obtained from the start up runs of the FEDAL sample port Nos. 11, 31, 36 and 37 of Monitor 2 and port Nos. 14, 46, 11, 49 and 7 of Monitor 1 gave no indications of a blanket element failure. At each power increase, the radiation increase was normal with no signs of bursts or peaks of radiation which would indication the failure of a blanket fuel element.

The Geneva conference of experts stated that surface waves help define the nature of a seismic perturbation. A `phase equalization` method has been proposed by several seismologists to determine the polarity of the source using crustal surface waves. In this report a horizontal source array is designed which will reduce the amplitude of the crustal surface waves by a factor of five. Experimental data from Geophysical Prospecting is cited to support the effectiveness of such arrays. It is thought that phase shifts will accompany this amplitude reduction. It is concluded that these amplitude and phase changes will make the phase equalization method unreliable. The significance of the report is that the Geneva negotiations must take into account the possibility of horizontal as well as vertical arrays.

Purpose of this study was to determine the {sup 237}Np input to the Purex process. The {sup 237}Np content of 639 g Pu/ton U irradiated fuel was found to be 1.78 {plus_minus} .09 g/ton of uranium at the 95% confidence level. Standard recovery for the chemical method was 96.7%, 98.0% for the sampling.

This review lists some of the salient features of semiconductor particle counters and cannot claim to contain an exhaustive listing of all the work in the field. Performance results on the surface-barrier counters as developed at California Institute of Technology are included as typical for this type of counter, though comparable results have been obtained elsewhere.

Five eighteen-inch enriched tube-and tube-elements will be irradiated in the KER Loops in pH 10 water to an exposure of 3500 MWD/T, (to see if a pitting corrosion problem exists under NPR conditions).

None

The PWR Plant was operated at approximately 60 MW net electrical output for a total of 1000 EFPH from February 3, 1959 to March 28, 1959. During this period, while performing DL-S-225, there were two planned shutdowns, no safety shutdowns or safety insertions and one flux title. The performance of the plant was satisfactory during the period of the test.

The utilization of gloves wherein heavy element additives have been included is a significant means of reducing exposure to hands and, consequently, increasing allowable working time in operations which require direct contact with low energy isotopes - such as plutonium. The number of such gloves available has been limited considerably by the feasibility of fabrication and the practicality of application. The following study was made on two basic gloves - the first, a heavy zinc-neoprene coated glove and the second, a lead loaded neoprene glove available in two thicknesses. Included in the study was a standard 30 gauge neoprene glove.