Memorandum presenting an airborne missile simulator used to represent visually the predicted flight behavior of the Navy XASM-N-7 Bullpup air-to-surface missile, which is guided along the line of sight to the target by bang-bang radio signals controlled by the pilot of the launch airplane. Quantitative response measurements showed that the simulator gave a good representation of the trajectory and control characteristics predicted for the Bullpup missile, and the simulation appeared plausible to the pilots.

This report lists some physical properties data of aqueous homogenous reactor materials.

Report presenting results of a flight investigation of a radar fire-control system installed in a fighter airplane. Some of the factors included in the radar evaluation are "noise" of the steering dot, lack of target-attitude information, and sensitivity and linearity of the display.

Report presenting an investigation in the stability tunnel to determine the combined effect of wing and wing-body interference on the contribution of an x-tail configuration to the low-speed rolling-stability derivatives of an airplane model with an unswept midwing and to indicate the change due to roll in the local flow angularity at a number of stations across the tail surfaces for one-half of the x-tail. Results regarding the static longitudinal characteristics, steady-roll characteristics, and angularity measurements are provided.

Report presenting an investigation in the 300 mph 7- by 10-foot tunnel to determine the chordwise and spanwise load distribution on a thin 60 degree delta-wing-fuselage model equipped with double slotted and extended double slotted flaps. The effects of a canard on the loads of the wing with the extended double slotted flaps are also determined.

Experimental investigations were undertaken at Columbia University to determine the heat transfer and fluid flow characteristics of fuel elements for the Savannah River reactors. Primarily the tests simulated quatrefoil operation, but a number of tests directly applicable to the operation of extended surface fuel elements were performed. Data books were published in which the experimental data are tabulated.

A summary is given of the background and present status of the pure-planing theory for rectangular flat plates and v-bottom surfaces. The equations reviewed are compared with experiment. In order to extend the range of available planing data, the principal planing characteristics for models having sharp bottom surfaces having constant angles of dead rise of 20 degrees and 40 degrees. Planing data were also obtained for flat-plate surfaces with very slightly rounded chines for which decreased lift and drag coefficients are obtained.