Abstract: The Trans-Pecos region of southwest Texas is noted for the production of quicksilver, lead, silver, and copper from its several mining districts. Reconnaissance, which was concentrated in and around these districts, revealed many areas of slightly abnormal radioactivity. Only a few areas, however, showed uranium mineralization.

This procedure is intended to be used as: 1. An instruction and guide for operation of the KER loops. 2. To aid in familiarization and understanding of the general operation of the loops. 3. To prevent lost time due to errors in loop operation. The procedure is not meant to be completely comprehensive in all details of loop operation.

Discussing an examination made of Green Vein Mesa in the southwestern part o he San Rafael Swell in Utah to determine the extent of uranium mineralization.

An inventory of the contaminated materials accumulated since the initiation of this project in June 1958, revealed a larger variety and quantity of materials that could be burned, than was specified for the initial scope. Therefore, it is desirable to revise the scope to permit handling the majority of these materials with the initially installed equipment.

By radiation dosimetry, we will mean the determination of the energy deposited per unit mass of irradiated material by ionizing radiation. Usually the material of interest in tissue and the results are to be applied to a radiobiological experiment, a radiotherapy treatment, or the protection of personnel from radiation hazards. The same methods, however, are applied to such engineering problems as the production of heat by reactor radiations, the use of radiation in chemical reactions or food processing, etc.

Experiments are described which show that the velocity of compressional waves along a thin plate varies as a function of the frequency of the waves. In terms of transit times in aluminum the value is between 4.02 and 4.94 microseconds per inch.

At the request of the Alloy Preparation Group, the Nondestructive Test Development Group investigated the feasibility of determining the clad thickness on Mark X MTR Fuel Plates. As the use of induced eddy-currents was considered to be the most promising approach, a prototype instrument and probe coil utilizing this principle was developed to measure clad thickness. The results of the investigation conducted with this instrument indicate that the clad thickness of this type of fuel plats can be measured to withing +- 0.001 in.